修正的莫尔-库仑理论的解析和验证

根据主应力可分解为静水应力和偏应力,以及它们在应力莫尔圆和变形方面的相关性,推导出修正的莫尔-库仑理论的数学表达式。从理论上解决了库仑理论和莫尔理论存在的许多缺陷,特别是中间主应力对材料抗剪强度的影响。它的四参数准则的计算结果与一些混凝土的试验数据相当吻合。     

三峡引水工程秦巴段输水隧洞稳定性分析

三峡引水工程秦巴段隧洞总长占线路总长的80%。为了分析隧洞施工及运营中可能发生的工程地质问题,在地质调查、地应力测量和岩石力学参数测试的基础上,利用Ansys有限元软件对引水工程北部不同深度、不同截面形态的隧洞围岩的应力重分布情况进行了模拟计算,得到了圆形隧洞、城门形隧洞和马蹄形隧洞围岩的应力分布结果。利用Hoek-Brown强度准则,得到了隧洞围岩的强度/应力比值,进而对不同深度、不同截面形态的隧洞围岩的稳定性进行了分析。初步认为:隧洞埋深小于1000m时,应优先考虑圆形隧洞和马蹄形隧洞;埋深大于1000m时,应优先考虑城门形隧洞。这项研究成果为引水工程深埋隧洞的设计提供了参考依据。     

A simplified approach for studying the influence of vertical accelerations on seismic response of slopes

ABSTRACT

A simplified approach is presented for estimating permanent displacements in slopes as a result of both vertical and horizontal seismic accelerations. A study of 52 earthquake records showed that the time difference between maximum horizontal and vertical accelerations varied between 0 and 10.3 s. The approach is illustrated for an earth dam embankment by analysing the effects of five of the above earthquake records. The approach combines a pseudo-static slope stability analysis for estimation of the critical (or yield) horizontal-vertical acceleration combinations, and a Newmark type displacement analysis. Guidelines are presented for conservative choice of soil strength parameters of saturated clays for use in the stability analysis. While permanent displacements of up to 40 cm were predicted without considering the vertical acceleration component, no additional displacement above 3.5 cm resulted when this component was included. The predicted additional displacement was consistently less than 10%, and in 50% of the analyses, vertical acceleration led to smaller predicted displacements. The simple approach may be applied in analysis for any slope using real earthquake records. Using existing, empirical expressions for permanent displacement, based only on horizontal accelerations, the effect of the vertical accelerations may be conservatively estimated by increasing the displacement by 10%.     

Silica fume stabilization of an expansive clay subgrade and the effect of silica fume-stabilised soil cushion on its CBR

ABSTRACT

Expansive soil subgrades, which are subjected to dual swell-shrink problem consequent upon absorption and evaporation of water, need to be improved by chemical stabilization or compacted cushion or geosynthetic reinforcement in order that pavements constructed over them are even, stable and safe. This paper presents extensive experimental data on plasticity, free swell index (FSI) and compaction characteristics of a highly swelling expansive clay stabilized with varying silica fume contents. In another series of tests on a laterite soil to be used as a cushion over the expansive clay subgrade, plasticity properties, compaction characteristics and strength characteristics were determined at varied silica fume contents. Further, CBR of the expansive clay subgrade was determined in the laboratory stabilizing it with varied silica fume contents and providing a cushion of 50 mm thickness of silica fume-stabilized lateritic soil. Liquid limit (LL), plasticity index (PI) and free swell index (FSI) of the expansive clay decreased with increasing silica fume contents. The compaction and strength characteristics of both the soils improved with silica fume stabilization. The CBR of the expansive clay provided with silica fume-stabilized cushion improved significantly.     

Investigations of the effects of manganese addition to Dry Creek Saltfield brines

Trials conducted at Dry Creek, a solar saltfield north of Adelaide, Australia, indicate that manganese, as manganous sulphate, can increase both the purity and strength of salt crystals grown at an ambient or neutral-slightly acid pH range resulting in a salt suitable for high purity uses. The improved load bearing strength of the crystals indicates that manganous sulphate could also be useful in salt floor maintenance. However, the impact of an apparently slight rise in pH to 8.5 was significant. Crystals produced at the higher pH from the manganese enriched brine were opaque with many tiny, almost colloidal crystals. The salt did not drain well, had low load bearing strength and was notably impure.     

冻结粉土动强度的荷载效应及长期极限动强度

荷载效应包括速率效应和疲劳效应两部分．速率效应使冻土的动强度和退荷回弹动弹模随应变速率加快而提高;疲劳效应使冻土的动强度随振频增加而下降,但在低应变速率下却使动强度略有提高．在高应变速率下动强度大于静强度,在低应变速度下动强度小于静强度,其间存在一个临界应变速率．通过动强度－破坏振次关系,可确定长期极限动强度．     

华北克拉通基性火山岩高场强元素对Ar-Pt界限及新生代地幔源区特征的示踪

华北克拉通不同时代基性火山岩存在向富集方向演化的趋势,并出现明显的Ａｒ－Ｐｔ界限和新生代异常．元古宙基性火山岩比太古宙富集大部分高场强元素（ＨＦＳＥ）和轻稀土元素（ＬＲＥＥ）,ＲＥＥ分异程度显著增加,而且相容性接近的不相容元素（如Ｎｂ,Ｔａ）的相对不相容性发生了改变．新生代玄武岩ＨＦＳＥ及Ｎｉ高度富集,ＲＥＥ强烈分异,δ（Ｅｕ）值最高．Ａｒ－Ｐｔ界限可能与地幔熔融时物理条件（如氧逸度）的改变和地幔富集作用有关．新生代玄武岩独特的地球化学特征可能主要反映了地幔源区的特殊性———“似ＯＩＢ型”富集地幔,其形成既可能有携带远洋沉积物的俯冲古老玄武岩洋壳部分熔融残余的贡献,也可能有直接循环（如通过拆沉作用）的陆壳物质的贡献,同时还可能涉及了地幔柱活动的影响．     

Laboratory modelling of shear behaviour of soft joints under constant normal stiffness conditions

Shear behaviour of regular sawtooth rock joints produced from casting plaster are investigated under constant normal stiffness (CNS) conditions. Test results obtained in this investigation are also compared with the constant normal load (CNL) tests. It is observed that the peak shear stress obtained under CNL conditions always underestimates the peak shear stress corresponding to the CNS condition. Plots of shear stress against normal stress show that a nonlinear (curved) strength envelope is acceptable for soft rock joints subjected to a CNS condition, in comparison with the linear or bilinear envelopes often proposed for a CNL condition. Models proposed by Patton (1966) and Barton (1973) have also been considered for the predictions of peak shear stress of soft joints under CNS conditions. Although Patton's model is appropriate for low asperity angles, it overestimates the shear strength in the low to medium normal stress range at higher asperity angles. In contrast, while Barton's model is realistic for the CNL condition, it seems to be inappropriate for modelling the shear behaviour of soft joints under CNS conditions. The effect of infill material on the shear behaviour of the model joints is also investigated, and it is found that a small thickness of bentonite infill reduces the peak stress significantly. The peak shear stress almost approached that of the shear strength of infill when the infill thickness to asperity height ratio (t/a) reached 1.40. This paper also introduces an original, empirical shear strength envelope to account for the change in normal stress and surface degradation during CNS shearing. © Rapid Science Ltd. 1998     

软岩的强度—变形—时间之间关系的试验分析

对软岩和有不连续面的软岩试样进行一系列固结不排水三轴压缩和蠕变试验,测定并分析了它们在正常固结和超固结状态下的应变软化性状、蠕变特性和残余强度的变化规律。探讨了软岩中存在的不连续面对应力－应变关系、残余强度特性和蠕变应变速率的影响。