考虑3种非线性关系的径向排水固结解析解

大部分砂井及排水板固结解析解理论结合了太沙基一维固结理论, 把土体考虑成线弹性问题, 而研究发现, 软土在等向固结条件下平均有效应力和水平渗透系数与孔隙比成半对数线性关系。同时, 实验表明, 在塑料排水板周围的涂抹区中水平渗透系数成抛物线状分布。因此, 为了充分考虑这些非线性的影响, 推导出了该问题的解析解, 并通过退化验证了该解析解的正确性。同时, 还对参数Cc/Ck和对固结速率的影响进行了分析, 结果表明:当Cc/Ck1时, 固结速率较快; 当Cc/Ck1时, 固结速率较慢; 参数增加, 固结速率逐渐变小。     

The Bear Brook Watershed in Maine: Multi-decadal whole-watershed experimental acidification

The Bear Brook Watershed in Maine (BBWM) is a long-term research site established to study the response of forest ecosystem function to environmental disturbances of chronic acidic deposition and ecosystem nitrogen enrichment. Starting in 1989, the West Bear (treated) watershed received bimonthly applications of ammonium sulfate [(NH₄)₂SO₄] fertilizer from above the canopy, whereas East Bear (reference) received ambient deposition. The treatments were stopped in 2016, marking the beginning of the recovery phase. Research at the site has focused on soils, streams, and vegetation. Here, we describe data collected over three decades at the BBWM—input and stream output nutrient fluxes, quantitative soil pits and soil chemistry, and soil temperature and moisture.     

非饱和土的应力状态变量研究

以热力学和连续介质力学的应力理论为基础,从非饱和土的土骨架平衡方程出发,导出了一系列应力状态变量,目前文献中所使用的应力状态变量都在其中。研究发现：非饱和土的应力状态变量有多种组合形式（5组以上）,不是惟一的;大多数应力状态变量与土的孔隙率、饱和度等物性指标孪生相伴;所有应力状态变量都具有应力的量纲,单纯孔隙率或饱和度及其组合都不构成应力状态变量;简化的Bishop有效应力公式和Fredlund倡导的两个应力状态变量都是简化了的应力状态变量,前者忽略了孔隙率的影响,而后者忽略了与孔隙率及饱和度的关联性。在选择应力状态变量时应考虑理论合理、应用方便、逻辑关系正确的原则,还应做一定的验证工作。     

微量元素在湖积物、土壤的垂向分布与稻谷中的分配

报道了“江苏省国土生态地球化学调查”项目有关湖积物、土壤柱微量元素垂向分布及稻谷样元素分配研究的初步成果。通过对有关样品元素含量的分析对比,指出洪泽湖沉积柱元素垂向分布与其动荡的沉积环境关系密切、太湖局部沉积物在其目前20cm以上深度存在人为重金属污染,这二湖沉积物中其氮与总有机碳含量呈显著正相关;认为城市化可使当地土壤环境受重金属等污染的深度显著加大、城市土壤环境受人为活动的影响要显著高于农村;发现Mo易富集于稻米、重金属与营养元素易富集于稻皮、各元素在米-谷间的分配关系不确定。     

Limitations of suction‐controlled triaxial tests in the characterization of unsaturated soils

Behavior of unsaturated soils is influenced by many factors, and the influences of these factors are usually coupled together. Suction‐controlled triaxial (SCTX) tests are considered to allow researchers to investigate influences of individual variables on unsaturated soils under specified stress path with controls of stresses, pore water, and air pressures. In the past 50 years, SCTX testing method has been established as a standard approach to characterize constitutive behavior of unsaturated soils. Most important concepts for modern unsaturated soil mechanics were developed upon results from the SCTX tests. Among these, one of the most important contributions in the constitutive modeling of elasto‐plastic behavior for unsaturated soils is the Barcelona basic model (BBM) proposed by Alonso et al. in 1990. The BBM successfully explained many features of unsaturated soils and received extensive acceptance. However, the SCTX tests are designed based upon the divide‐and‐conquer approach in which an implicit assumption is used: soil behavior is stress‐path independent. However, it is well‐established that unsaturated soil behavior is elasto‐plastic and stress‐path dependent. It is found that the SCTX tests in fact cannot control the stress path of an unsaturated soil during loading. This incapability, in combination with complicated loading/collapse behavior of unsaturated soils, makes the SCTX tests for characterizing unsaturated soil questionable. This paper discusses the limitations of the SCTX tests in the characterization of unsaturated soils. A possible solution to the problem was proposed based on a newly developed modified state surface approach. The discussions are limited for isotropic conditions. Copyright © 2015 John Wiley & Sons, Ltd.     

滑带土强度特性的试验研究

滑带土的强度特性对于边坡稳定具有重要的控制作用,揭示滑带土强度指标的变化规律是进行边坡安全性评估的基本前提。针对一库岸古滑坡滑动带中的含粗粒细粒土,进行了滑带土强度特性的试验研究：通过现场大剪试验和室内固结快剪试验分析了滑带土的剪切性状,确定了再生强度、现场折减强度和固结快剪强度;根据现行反复剪切试验在确定含粗粒细粒土残余强度时的不足,对试验方法和试验仪器进行了改进,提出了滑带土的残余强度指标,并与其他剪切条件下的强度指标进行了比较;基于试验结果的统计分析,探讨了土体含水率、塑性指数及粗粒含量对剪切强度指标的影响,并总结了含粗粒细粒土与一般黏性土或砂土在剪切性状方面的诸多不同     

路基粒状填土的旋转压实试验

尽管击实试验是目前最流行的室内土体压实试验方法,但实际上与现场任何一种压实方法都无相似之处,且不适用于无粘性土（粒状土）的压实试验。无粘性土的振动击实试验方法也存在很多问题。现代重型压实设备的使用,路基粒状填土的压实密度达到了目前室内规范试验方法不可能达到的水平。介绍了美国采用供高性能沥青路面混合料设计与质量控制之用的旋转压实机对粒状土进行的压实试验。其结果表明,旋转压实试验能有效模拟路基粒状填土的现场压实特征;可采用压实压力200 kPa、旋转角为1.25°、旋转次数为90、旋转速度为20 rpm的试验结果来控制粒状填土路基的现场压实质量。     

基于数据挖掘的土−水特征曲线演化规律研究

土−水特征曲线是非饱和土持水性能和水气运移规律的重要表征,由于其测试过程繁杂、影响因素众多,很难通过系列试验和数学模型全面表达。为探索土的类型和物理状态对土−水特征曲线的影响,以国内外大量试验数据为基础,以反映其形态的3个特征值（进气值、减湿率、残余含水率）为对象,采用数据分析统计方法揭示不同赋存条件对特征值的作用规律,采用机器学习方法探究影响因素的敏感性。研究结果表明：土体的物质组成（颗粒级配、粒径尺度、塑性指数）及赋存状态（密实程度、饱和含水率、干湿循环作用、环境温度）是影响其持水性能的常见分析指标,各影响因素对3个特征值的影响特征既有巨大差异也有相互联系,敏感性成果表明代表黏粒含量的塑性指数和反映密实程度的干密度是影响土体持水性能的最主导因素,给出的特征值分布范围考虑了两个主导因素的影响,具有较强的代表性和借鉴意义。     

Mechanical Characteristics of Light-Weighted Soils Using Dredged Materials

This study investigates the mechanical characteristics of light-weighted soils (LWS) consisting of expanded polystyrene (EPS), dredged clays, and cement through both unconfined and triaxial compression tests. The mechanical characteristics of the compressive strength of LWS are analyzed with varying initial water contents of dredged clays, EPS ratio, cement ratio, and curing pressure. In the triaxial compression test, it is found that the compressive strength of LWS associated with EPS is independent on the effective confining pressure. When both EPS ratio is less than 2% and cement ratio is more than 2%, the compressive strength rapidly decreases after the ultimate value. This signifies that the compressive strength-strain behavior is quite similar to that of the cemented soil. The ground improved by LWS has the compressive strength of 200 kPa associated with the optimized EPS ratio of 3-4% and initial water content of 165-175%. The ultimate compressive strength under both triaxial and unconfined compression tests is almost constant for a cement ratio of up to 2%.     

Erosion modelling for land management in the Tahoe basin,USA: scaling from plots to forest catchments

Abstract

Recent developments in hydrological modelling of river basins are focused on prediction in ungauged basins, which implies the need to improve relationships between model parameters and easily-obtainable information, such as satellite images, and to test the transferability of model parameters. A large-scale distributed hydrological model is described, which has been used in several large river basins in Brazil. The model parameters are related to classes of physical characteristics, such as soil type, land use, geology and vegetation. The model uses two basin space units: square grids for flow direction along the basin and GRU—group response units—which are hydrological classes of the basin physical characteristics for water balance. Expected ranges of parameter values are associated with each of these classes during the model calibration. Results are presented of the model fitting in the Taquari-Antas River basin in Brazil (26 000 km² and 11 flow gauges). Based on this fitting, the model was then applied to the Upper Uruguay River basin (52 000 km²), having similar physical conditions, without any further calibration, in order to test the transferability of the model. The results in the Uruguay basin were compared with recorded flow data and showed relatively small errors, although a tendency to underestimate mean flows was found.