采矿引起的边坡倾倒滑移变形机理与变形安全性分析研究—以抚顺西露天矿边坡为例

在矿山开发、水电建设过程中倾倒变形问题日渐突出。倾倒变形边坡一般具有反倾边坡结构,变形的过程和机理比较复杂、涉及的变形岩体范围较大、危害严重。论文以抚顺西露天矿边坡为例,通过岩体位移监测资料的跟踪分析、底面摩擦模拟试验,以岩体力学、松散介质力学原理为理论基础,探讨了采矿影响下边坡倾倒滑移体的变形机理,分析认为采矿引起的倾倒滑移变形问题是在特定的地质构造和采矿工程条件下产生的,并提出了岩体变形安全性分析方法。通过工程实例,验证了方法的实用性,并针对实际问题提出了变形整治对策。     

大型钢结构变形测试方法的研究与实践

介绍了精密全站仪进行结构测试的原理和方法,通过对某大型游泳跳水馆钢结构网架在张拉和加载试验中的变形测量实践,证明其具有作业简便、能够全面反映结构变形情况之优点,且精度较高,成果可靠。     

吉林台爆破料应力应变关系的三轴试验研究

通过室内大型三轴实验，研究了吉林台水库爆破料在不同级配下的应力应变关系，得到了在一定击实功下爆破料的最大干密度随细料含量变化的规律，分析了爆破料在不同级配和不同围压下应力与应变的变化规律、轴向应变与体积应变的关系及抗剪强度变化特性．从微观的角度说明了变化规律产生的原因，得出爆破料的抗剪强度随级配的变化而变化的规律．     

单一滑面边坡的非稳定蠕变模型分析

对单一滑面边坡的非稳定蠕变分析是边坡稳定性研究的基础。文中对岩质边坡单一滑面的流变变形机制进行了分析，提出了一种能较好反映这一变形机制的非稳定蠕变模型。特别是描述单一滑面边坡的非稳定蠕变破坏阶段，并对其稳定性进行了讨论。结合一些工程实例进行了对比验证，为滑坡灾害的预测和防治提供依据。     

构造煤与原生结构煤的显微傅立叶红外光谱特征对比研究

通过对平顶山、郑州和南票三大矿区石炭二叠纪含煤岩系中高煤级烟煤和无烟煤的显微傅立叶红外光谱分析，探讨了原生结构煤与构造煤的有机大分子结构演化特征及其影响因素。结果表明，构造应力有利于煤中氢发生化学环境转移，使脂肪烃含量相对减少、稳定的芳香烃含量相对增加，促进煤大分子结构缩合度和有序度增加。     

韧性剪切变形对岩石地球化学行为的制约——以北阿尔金巴什考供韧性剪切带为例

韧性剪切变形对岩石地球化学行为的制约一直是地质学家们探讨的课题。本文以构成北阿尔金红柳沟——拉配泉俯冲碰撞杂岩带与北阿尔金地块边界的巴什考供斜向逆冲型韧性剪切带为例，通过对韧性剪切带内花岗岩变形前后不同变形强度构造岩的地球化学组成进行对比，确定等比线斜率，探讨韧性变形对岩石体积和成分变异的影响。计算结果表明，在糜棱岩化过程中，糜棱岩化花岗岩体积亏损21％，花岗质糜棱岩体积亏损31％。质量平衡计算结果和等比线图表明，韧；陛剪切作用导致SiO2，流失量最大，A12O3、K2O及Ba、Rb、Sr等都有不同程度的丢失，显示出较强的活动性，MnO、P2O5、Sc位于等比线上或附近，表现出相对的稳定性。岩石中活动组分的变异是流体渗滤作用引起的，不活动组分的变异是体．积亏损造成的。     

青藏公路路基变形分析

为研究青藏公路多年冻土人为上限在退化过程中对路基变形产生的影响过程和程度, 在唐古拉山以南选择了3处具有代表性的路面进行了为期2 a的路面变形观测. 资料表明, 在多年冻土人为上限退化过程中随着公路路基结构、冻土类型的不同, 路基变形从冻胀和融沉过程、冻胀量和融沉量、发生的时间都有很大的不同. 在高含冰量多年冻土区采用半挖半填结构产生的路基变形最为剧烈, 在含冰量相对少且采用较高路堤结构的地段路基变形过程相对平缓. 同时结合探地雷达的勘察结果对路基下的融化区、多年冻土区的内部结构进行了分析. 结果显示,多年冻土人为上限的下移、地下冰的融化会在多年冻土人为上限以上的地质体中导致较强烈的层间错动和扰动.     

An experimental study of grain scale melt segregation mechanisms in two common crustal rock types

Creation of pathways for melt to migrate from its source is the necessary first step for transport of magma to the upper crust. To test the role of different dehydration‐melting reactions in the development of permeability during partial melting and deformation in the crust, we experimentally deformed two common crustal rock types. A muscovite‐biotite metapelite and a biotite gneiss were deformed at conditions below, at and above their fluid‐absent solidus. For the metapelite, temperatures ranged between 650 and 800 °C at P_c=700 MPa to investigate the muscovite‐dehydration melting reaction. For the biotite gneiss, temperatures ranged between 850 and 950 °C at P_c=1000 MPa to explore biotite dehydration‐melting under lower crustal conditions. Deformation for both sets of experiments was performed at the same strain rate (ε.) 1.37×10^?5 s^?1. In the presence of deformation, the positive ΔV and associated high dilational strain of the muscovite dehydration‐melting reaction produces an increase in melt pore pressure with partial melting of the metapelite. In contrast, the biotite dehydration‐melting reaction is not associated with a large dilational strain and during deformation and partial melting of the biotite gneiss melt pore pressure builds more gradually. Due to the different rates in pore pressure increase, melt‐enhanced deformation microstructures reflect the different dehydration melting reactions themselves. Permeability development in the two rocks differs because grain boundaries control melt distribution to a greater extent in the gneiss. Muscovite‐dehydration melting may develop melt pathways at low melt fractions due to a larger volume of melt, in comparison with biotite‐dehydration melting, generated at the solidus. This may be a viable physical mechanism in which rapid melt segregation from a metapelitic source rock can occur. Alternatively, the results from the gneiss experiments suggest continual draining of biotite‐derived magma from the lower crust with melt migration paths controlled by structural anisotropies in the protolith.     

Ground deformation of the southern sector of the Aeolian islands volcanic arc from geodetic data

The deformation pattern and the dynamics of the southern sector of the Aeolian archipelago are investigated. A study on the ground deformation, measured over the last 20 years in the trilateration geodetic network between the islands of Vulcano and Lipari, has been conducted. Analysis of the relative displacements and the uniform strain tensor parameters, as well as the comparison between areal dilatation and the vertical variations deduced by precise levelling, allow distinguishing different phases associated both with the regional dynamics and the local volcanic context of the area. These phases, however, appear to be closely interrelated. The analysis of the deformation pattern allows to constrain the predominance of a roughly E–W trending extension and a N–S contraction at a regional scale. This regime is consistent with right-lateral movements along a NW–SE striking fault system.     

Paleoliquefaction study of the Clarendon–Linden fault system, western New York State

The lack of earthquake-induced liquefaction features in Late Wisconsin and Holocene sediments in Genesee, Wyoming, and Allegany Counties suggests that the Clarendon–Linden fault system (CLF) did not generate large, moment magnitude, M≥6 earthquakes during the past 12,000 years. Given that it was the likely source of the 1929 M 4.9 Attica earthquake, however, the Clarenden–Linden fault system probably is capable of producing future M5 events. During this study, we reviewed newspaper accounts of the 1929 Attica earthquake, searched for earthquake-induced liquefaction features in sand and gravel pits and along tens of kilometers of river cutbanks, evaluated numerous soft-sediment deformation structures, compiled geotechnical data and performed liquefaction potential analysis of saturated sandy sediments. We found that the 1929 M 4.9 Attica earthquake probably did not induce liquefaction in its epicentral area and may have been generated by the western branch of the Clarendon–Linden fault system. Most soft-sediment deformation structures found during reconnaissance did not resemble earthquake-induced liquefaction features, and even the few that did could be attributed to non-seismic processes. Our analysis suggests that the magnitude threshold for liquefaction is between M 5.2 and 6, that a large (M≥6) earthquake would liquefy sediments at many sites in the area, and that a moderate earthquake (M 5–5.9) would liquefy sediments at some sites but perhaps not at enough sites to have been found during reconnaissance. We conclude that the Clarendon–Linden fault system could have produced small and moderate earthquakes, but probably not large events, during the Late Wisconsin and Holocene.