Correlation of T-log with E-log in coal-bearing formations

The profile of temperature gradient versus depth (T-log) has been found to be very useful for correlation with electrical resistivity log (E-log) in coal-bearing formations. A positive correlation between electrical resistivity and thermal resistivity is observed in coal sections whereas a negative correlation is found in sandstone/shale beds, thus helping in coal prospect evaluation. T logs have been used to correct the location of coal bed which had apparently been misinterpreted by the E-log. Hole to hole correlation of T-log and E-log is found to be excellent and it is observed that thermal resistivity characteristics of given formations remain fairly uniform. A rough estimation of coal grade is possible from the detailed study of the T-logs. Abrupt changes of temperature gradient as also its reversals have been observed in burnt coal sections.     

Thymol as a Biocide in Japanese Rainwater

Rainwater samples (wet-only; event samples) collected in Niigata in late autumn 1996 and springtime 1997 were used to assess the effectiveness of thymol as a biocide in Japanese rainwater. Upon collection each rainwater sample was divided into sub-samples, with thymol added to one sub-sample. Sub-samples with and without thymol were shipped to CSIRO, Australia, for chemical analysis. Comparison of analytical results for each pair of sub-samples proved the effectiveness of thymol in preventing biological action in this region where effects of rainwater microflaura and fauna on rainwater composition have not before been studied. Sub-samples without thymol exhibited lowered electrical conductivity, loss of the cations H⁺ and NH ₄ ^- , and loss of the anions HCOO^-, CH₃COO^-, C₂O ₄ ^2- , CH₃SO ₃ ^- and PO ₄ ^3- . Nitrate showed no change in all but one of the samples, indicating that ammonia was the preferred source of nitrogen for the biological processes that consumed the rainwater organic acids and phosphate. These results suggest that thymol is a suitable rainwater biocide for use under Japanese conditions.     

Model Simulations on the Variability of Particulate MSA to Non-Sea-Salt Sulfate Ratio in the Marine Environment

A box model was constructed to investigate connections between the particulate MSA to non-sea-salt sulfate ratio, R, and DMS chemistry in a clean marine boundary layer. The simulations demonstrated that R varies widely with particle size, which must be taken into account when interpreting field measurements or comparing them with each other. In addition to DMS gas-phase chemistry, R in the submicron size range was shown to be sensitive to the factors dictating sulfate production via cloud processing, to the removal of SO₂ from the boundary layer by dry deposition and sea-salt oxidation, to the entrainment of SO₂ from the free troposphere, to the relative concentration of sub- and supermicron particles, and to meteorology. Three potential explanations for the increase of R toward high-latitudes during the summer were found: larger MSA yields from DMS oxidation at high latitudes, larger DMSO yields from DMS oxidation followed by the conversion of DMSO to MSA at high latitudes, or lower ambient H₂O₂ concentrations at high latitudes leading to less efficient sulfate production in clouds. Possible reasons for the large seasonal amplitude of R at mid and high latitudes include seasonal changes in the partitioning of DMS oxidation to the OH and NO₃ initiated pathways, seasonal changes in the concentration of species participating the DMS-OH reaction pathway, or the existence of a SO₂ source other than DMS oxidation in the marine boundary layer. Even small anthropogenic perturbations were shown to have a potential to alter the MSA to non-sea-salt sulfate ratio.     

Changes in stream water quality due to logging of the boreal forest in the Montmorency Forest,Québec

Summer stream water quality was monitored before and following the logging of 50% of the boreal forest within three small watersheds (<50 ha) nested in the ‘Ruisseau des Eaux‐Volées’ Experimental Watershed, Montmorency Forest (Québec, Canada). Logging was conducted in winter, on snow cover according to recommended best management practices (BMPs) to minimize soil disturbance and protect advance growth. A 20‐m forest buffer was maintained along perennial streams. In watershed 7·2, cut‐blocks were located near the stream network and logging was partially allowed within the riparian buffer zone. In watersheds 7·5 and 7·7, logging occurred farther away from the stream network. Observations were also made for watershed 7·3 that collected the runoff from watersheds 7·2 and 7·5, and watershed 7·6, the uproad portion of watershed 7·7. The control watershed 0·2 was contiguous to the impacted watersheds and remained undisturbed. Following clearcutting, changes in summer daily maximum and minimum stream temperatures remained within ± 1 °C while changes in diurnal variation did not decrease by more than 0·5 °C. Concentrations of NO₃^? greatly increased by up to 6000% and concentrations of K⁺ increased by up to 300% during the second summer after logging. Smaller increases were observed for Fe_total (up to 71%), specific conductance (up to 26%), and Mg²⁺ (up to 19%). Post‐logging pH decreased slightly by no more than 7% while PO₄^3? concentration remained relatively constant. Suspended sediment concentrations appeared to increase during post‐logging, but there was not enough pre‐logging data to statistically confirm this result. Logging of moderate intensity and respecting established BMPs may account for the limited changes of water quality parameters and the low exceedances of the criteria for the protection of aquatic life. The proximity of the cutover to the stream network and logging within the riparian zone did not appear to affect water quality. Copyright © 2008 John Wiley & Sons, Ltd.     

Water source characterization through spatiotemporal patterns of major,minor and trace element stream concentrations in a complex,mesoscale German catchment

The link between spatiotemporal patterns of stream water chemistry and catchment characteristics for the mesoscale Dill catchment (692 km²) in Germany is explored to assess the catchment scale controls on water quality and to characterize water sources. In order to record the spatiotemporal pattern, ‘snapshot sampling’ was applied during low, mean and high flow, including 73 nested sites throughout the catchment. Water samples were analysed for the elements Li, B, Na, Mg, Al, K, Ca, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, Rb, Sr, Mo, Ba, Pb and U using inductively‐coupled‐plasma mass spectrometry, and for electric conductivity and pH. Principle component analysis and hierarchical cluster analysis were used to find typical element associations and to group water samples according to their hydrochemical fingerprints. This revealed regional hydrochemical patterns of water quality which were subsequently related to catchment attributes to draw conclusions about the controls on stream chemistry. It was found that various lithologic signals and anthropogenic point source inputs controlled the base flow hydrochemistry. During increased flows, stream waters were diluted causing additional hydrochemical variability in response to heterogeneous precipitation inputs and differences in aquifer storage capacities. The hydrochemical patterns further displayed in‐stream mixing of waters. This implied, that stream waters could be apportioned to the identified water sources throughout the catchment. The basin‐wide hydrochemical variability has the potential to outrange the tracer signatures typically inferred in studies at the hillslope scale and is able to strongly influence the complexity of the catchment output. Both have to be considered for further catchment scale tracer and modelling work. Despite the likelihood of non‐conservative behaviour, the minor and trace elements enhanced the rather qualitative discrimination of the various groundwater types, as the major cations were strongly masked by point source inputs. Copyright © 2007 John Wiley & Sons, Ltd.     

贵州瓮安玉山煤矿煤质特征及其影响因素

玉山煤矿含煤地层为吴家坪组,可采煤层2层,具有中灰、中等挥发分、高硫分、低磷分、特低—低氯,低砷、高氟,中高发热量的煤质特征,煤类丰富,呈条带状分布。通过对区内沉积环境和煤的变质作用2个方面的分析,阐述了形成煤层高硫、中灰特征的影响因素,解释了煤类分带现象,并指出了主要煤质指标的变化规律。     

威海市环翠区地下水环境质量评价

在威海市环翠区地下水调查研究的基础上,选取10项因子,采用单项组分评价和综合评价相结合的方法对区内浅层地下水进行分析评价。结果显示,区内大部分地区水质较好,部分地区由于受人类活动等的影响,导致水质变差,其主要超标因子有硫酸盐、硝酸盐、氯化物、总硬度等。     

SD-WACCM模式对平流层化学组分的模拟研究

利用美国大气研究中心开发的全球气候模式,对2008年平流层的化学组分(HNO₃、HCl和O₃)进行了模拟研究,并结合了MLS卫星资料进行了对比分析。结果表明,模式可以较好地再现平流层的各化学组分的时空分布状况。并选取了8个区域,将模拟的2008—2009年O₃柱浓度与臭氧监测仪资料对比,结果表明,模式可以较好地再现全球O₃总量的季节变化情况。     

南京市降水化学特征及其来源研究

为了解南京江北地区降水化学特征,分析了2011年3—6月共25个降水日的109个降水样品中的主要水溶性离子,并利用后向轨迹模式探讨了降水气团来源.结果表明:1)南京地区3—6月降水主要受南、北2种气团影响,北方气团降水的主要离子浓度高于南方气团降水.2)海盐示踪法和相关性分析显示,降水中NO₃^-和SO₄^2-主要来自燃煤、工业排放和汽车尾气;Ca²⁺主要来自地壳源;Cl^-主要来自海洋;海洋源和陆源对Mg²⁺和K⁺都有贡献,Mg²⁺的陆源贡献大于海洋源贡献,K⁺受海洋源的影响程度要低于Mg²⁺.3)南、北气团初期降水的各离子浓度高于总降水的各离子浓度,且初期降水的主要离子的富集系数高于总降水.这说明在降水初始阶段,雨水对南京大气中污染物(气态污染物和颗粒物)的云下冲刷去除作用较强,降水的离子浓度最高,局地源对降水离子的贡献较明显.