“标贯”确定粘性土承载力标准值简易计算法

标准贯人（“标贯”）试验锤击数,要确定粘性土地基承载力标准值简易计算公式。将经杆长修正的标准贯人击数N进行统计分析,再把修正击数平均值带人相关方程,计算粘性土的承载力标准值fk,从而简化了计算过程。     

黔北后槽下石炭统含铝岩系的粘土矿物

为揭示黔北下石炭统含铝岩系的沉积环境,本文利用贵州遵义县后槽TC718剖面系统试样的粘土矿物进行x一射线衍射测试及特征分析。含铝岩系粘土岩与下伏桐梓组粘土页岩在矿物组合和成分上均有明显的差异,水云母的结晶度指数、开形指数在剖面纵向上有三个变化拐点：一是含铝岩系与下伏桐梓组粘土页岩分界处;二是含铝岩系上、下段的接触带;三是含铝岩系顶部含炭质粘土岩出现的临界面。其变化特征表明,本区下石炭统含铝岩系粘土岩段为海相或海陆过渡相,铝质岩段为残积一坡积相,顶部为大陆湖沼相;下奥陶统桐梓组页岩段为海相。     

Mechanism for the rapid motion of the Qianjiangping landslide during reactivation by the first impoundment of the Three Gorges Dam reservoir, China

The first impoundment of the Three Gorges Dam reservoir in China started from a water surface elevation of 95 m on June 1, 2003 and reached 135 m on June 15, 2003. Shortly after the water level reached 135 m, many slopes began to deform and some landslides occurred. The Qianjiangping landslide is the largest one; it occurred on the early morning of July 14, 2003 and caused great loss of lives and property. Field investigation revealed that, although failure occurred after the reservoir reached 135 m, the stability of the slope was already reduced by preexisting sheared bedding planes. To study the mechanism of the rapid motion of this reactivated landslide, two soil samples were taken from a yellow clay layer and a black silt layer in the sliding zone, respectively, and a series of ring shear tests were conducted on the samples. One series of ring shear tests simulates the creep deformation behavior, while the other series simulates different shear rates. Conclusions drawn from analysis of the ring shear tests indicate that the mechanism of the rapid motion of the reactivated landslide was caused by the rate effect of the black silt layer during the motion phase after the creep failure. The yellow clay layer did not play any important role in the rapid motion in the 2003 event.     

华南二叠－三叠系的事件地层与生物地层界线

华南二叠－三叠系界线研究应严格区分事件地层界线与生物地层界线。“界线粘土”层的底界即为事件地层界线。生物地层界线定义不能与“混生层”或“过渡层”的概念连在一起。长兴煤山忠心大队剖面是最好的二叠－三叠系全球界线层型剖面点（ＧＳＳＰ）。二叠－三叠系生物地层界线定义为ＨｉｎｄｅｏｄｕｓｐａｒｖｕｓＭｏｒｐｈｏｔｙｐｅ１的首次出现,其位置就在长兴剖面界线层（混生层）２的内部,比事件地层界线高１５ｃｍ。ＨｉｎｄｅｏｄｕｓｐａｒｖｕｓＭｏｒｐｈｏｔｙｐｅ１的首次出现,即为长兴阶的顶界。     

Weathering characteristics of arctic islands in northern Norway

The arctic islands of the Lofoten-Vesterålen archipelago in northern Norway have a wide distribution of weathered land surfaces commonly located above 250 m with several apparent similarities. In order to investigate the characteristics of (deep) weathering in this region, northern Langøya and Hadseløya were chosen for in-depth analyses. Eight weathering profiles were excavated from various surfaces, and the stratigraphies were logged in detail. Material was collected throughout the weathering horizons, and all samples were subsequently analysed for clay mineralogy (< 63 μm fraction) and grain size distribution. The sampling strategy was complemented by samples from additional saprolites and other landforms such as moraines and rock glaciers. The XRD results indicate that the presence of secondary minerals, such as gibbsite (Al(OH)₃) and kaolinite (Al₂Si₂O₅(OH)₄), are very common throughout the profiles. Gibbsite is an extreme end product of silicate weathering and usually associated with a warmer and more humid climate, as found in Scandinavia during the Tertiary. The grain size analyses (< 63 μm) show that the finer silt fractions (< 8 μm) tend to be high in the profiles (20–40%), with significant amounts of clay (5–15%) demonstrating that the regolith itself is susceptible to frost sorting mechanisms.¹⁰Be exposure dates from in situ quartz knobs on tors and boulders of local origin suggest > 40,000 years of subaerial conditions. Considering the steady surface erosion, this figure should be viewed as an absolute minimum age estimate. Mapping of the superficial sediments and geomorphological features of the study areas has revealed several common morphological features, which indicate dominance of glacial and periglacial processes in the areas lying below the lower boundary of blockfields (c. 250 m). The weathering mantles are not a periglacial end product, but rather a relict tertiary landform that were modulated by permafrost processes as well as biological processes at later stages. The regolith cover constrain the vertical extension of warm-based Quaternary ice sheets challenging the notion of a parabolic ice mass consuming every mountain top of Lofoten and Vesterålen.     

Initiation and development of pull-apart basins with Riedel shear mechanism: insights from scaled clay experiments

Typical pull-apart structures were created in scaled clay experiments with a pure strike-slip geometry (Riedel type experiments). A clay slab represents the sedimentary cover above a strike-slip fault in the rigid basement. At an early stage of the development of the deformation zone, synthetic shear fractures (Riedel shears) within the clay slab display dilatational behaviour. With increasing basal displacement the Riedel shears rotate and open further, developing into long, narrow and deep troughs. The shear displacement and the low angle with the prescribed principal basal fault set them apart from tension gashes. At a more evolved stage, synthetic segments (Y-shears) parallel to the basal principal fault develop and accommodate progressive strike-slip deformation. The Y-shears connect the tips of adjacent troughs developed from the earlier Riedel shears, resulting in the typical rhomb-shaped structures characteristic for pull-apart basins. The Strait of Sicily rift zone, with major strike-slip systems being active from the Miocene to the Present, comprises pull-apart basins at different length scales, for which the structural record suggests development by a mechanism similar to that observed in our experiments.     

A highlight of environmental and engineering geology in Fargo, North Dakota, USA

Several unfavorable environmental and engineering geologic conditions exist in Fargo, North Dakota. Dominantly, the behavior of smectitic clays within the proglacial Lake Agassiz sediments of the Sherack and Brenna Formations creates subsoil instability beneath engineered structures in the Fargo area and slope instability within cutbank meanders of the Red River of the North. Unfavorable engineering geologic conditions encountered include: the elastic deformation of clayey glaciolacustrine soils, shrink-swell properties, inadequate bearing capacities, and mass movements. These conditions are responsible for structural failures including the Fargo Grain Elevator in 1955 and the Northern Pacific railroad grade. Bank failures along the Red River are common due to the inherent instability of Brenna Formation smectitic clays which are subject to plastic deformation in the subsurface, with resultant block failure of overlying Sherack Formation. Recent alluvial sediments due to typical fluvial action and the continued seasonal saturation of cutbank meanders within the floodplain also add to soil instability.     

甘肃西峰6.2～2.4MaB.P.红粘土中孢粉记录及古植被演化

通过对甘肃西峰赵家川6.2～2.4MaB.P.红粘土地层的孢粉学研究,建立了3个孢粉组合带。孢粉组合特征显示该区在此阶段总体为干旱的草原环境,6.2～5.8MaB.P.为灌丛草原;5.8～4.2MaB.P.是稀疏森林草原,植被由大量中生性草本植物和少量喜湿性的乔木植物组成,反映当时气候相对湿润;4.2～2.4MaB.P.植被中旱生植物藜科和麻黄明显增多,反映典型草原-荒漠草原。分析认为研究区自6.2MaB.P.干旱草原环境的格局就已经形成。红粘土中孢粉记录的植被演化信息与青藏高原隆升有时代上的耦合性,也与北极冰盖的起源和演化历史有着密切的联系。     

沿海表层沉积物中重金属的有效结合态

以浙江沿海表层沉积物为研究对象,系统地研究了重金属有效结合态与沉积环境、矿物组成和人为排放等环境因素之间的相互关系.结果表明:沿海表层沉积物中重金属的积累数量,呈现出潮汐河口沉积物>沿海沉积物>强潮汐河口沉积物的趋势,这反映了不同沉积类型对重金属富集作用的差异;重金属的有效结合态,总体上以铁锰氧化物结合态>碳酸盐结合态>硫化物及有机结合态>可交换态的顺序存在,但是不同的重金属或同种重金属在不同的采点,主要有效结合态的比例存在明显的差异,这不仅与重金属的地球化学性质、沉积环境和沉积物中的粘土矿物组成有关,更受到重金属污染物的人为排放量的影响.     

Stabilization of swelling clays by Mg(OH)2. Changes in clay properties after addition of Mg-hydroxide

Stabilization of the swelling clay structure is attempted by intercalation of Mg(OH)₂ and the development of a brucite interlayer between the clay layers. The properties of the product obtained by applying the technique, formulated as described in a previous work, are considered here. The materials used were Wyoming bentonite (USA), Fuller's Earth (UK), kaolinite, illite, lignite, and silica gels. The Mg(OH)₂-clay products were examined by the methylene blue dye test, X-ray diffraction analysis (XRD), differential thermal analysis (DTA), and derivative thermogravimetry analysis (DTGA). From the results obtained it is concluded that: the Mg-hydroxide is adsorbed by swelling clays both on their external and internal surface, whereas it is adsorbed on the external surface by non-swelling clays. The internally adsorbed phase of Mg-hydroxide forms an ill-defined interlayer of brucite, retarding swelling, whereas the external phase covers the particles modifying drastically their surface properties, like the adsorption of the MB dye. The material produced after precipitation of Mg-hydroxide on swelling clays (smectites) did not re-expand on wetting or after glycolation. The adsorption of MB dye was also reduced by some 80–90%, due to coating effect, preventing the measurements of the external surface area of the clay by polar molecules. The principal forces involved in the process are believed to be physical adsorption on the external surface, along with chemisorption and some chemical bonding, mostly in the internal surface. Cementation due to crystallization and, in the long term, some pozzolanic reactions take also place. Internal adsorption of the Mg-hydroxide is postulated to be in the form of positively charged mono- and/or small polymers and it is, chiefly, diffusion controlled. Since Mg-hydroxide is internally adsorbed by swelling clays, whereas Ca-hydroxide(lime) is not, and the (Mg, Ca)-clay aggregates are more stable than the Ca-clay or the Mg-one, the combination of the two hydroxides could give better results in soil stabilization than each hydroxide alone.