辽东半岛盖州市梁屯地区古元古代大理岩的碎屑锆石U--Pb定年及地质意义

通过地层对比、锆石LA--ICP--MS U--Pb定年及岩石地球化学研究限定胶—辽—吉活动带北东段辽东半岛盖州市梁屯地区一套碳酸盐岩建造的原岩形成时代、物质来源和地层归属等。其炭质方解大理岩锆石阴极发光(CL)图像显示碎屑锆石核部大都具有振荡环带,且其Th/U比值较高(Th/U=0. 15～2. 04),表明其为岩浆来源成因。锆石U--Pb年代学定年结果显示存在两个主要的年龄峰值,主要年龄峰值为新太古代晚期(2 560～2 500 Ma),次要峰值为古元古代中晚期(2 040～2 000 Ma),其沉积时限应晚于2. 0 Ga,与古元古代辽河岩群沉积时代一致。此外,该年龄与区域上的太古代基底和大量出露的辽吉花岗岩的年龄相一致,表明炭质方解大理岩物质来源于太古代基底和辽吉花岗岩。并通过岩相学、岩石地球化学、年代学和区域对比等研究,确认梁屯地区分布的这套富含炭质的大理岩建造(原岩为沉积石灰岩)可与辽河群高家峪岩组对比,而非前人认为的大石桥岩组。     

An Atomic Force Microscopy study of the growth of calcite in the presence of sodium sulfate

In situ atomic force microscopy (AFM) has been used to compare the growth of pure calcite and the growth of calcite in the presence of sulfate ions from aqueous solutions at a constant value of supersaturation (S.I. = 0.89) with respect to calcite. The effect of sulfate ions on calcite growth rates is determined and a potential incorporation of sulfate ions is identified in the calcite during growth. Solutions supersaturated with respect to calcite with solution concentration ratio of one and a constant pH of 10.2, were prepared and sulfate was added as Na₂SO₄ aqueous solution. The solution composition was readjusted in order to keep the supersaturation and pH constant. PHREEQC was used to determine relevant solution concentrations. In situ AFM experiments of calcite growth were performed using a fluid cell and flowing solutions passed over a freshly cleaved calcite surface. Growth rates were determined from the closure of the rhombohedral etch pits induced by initial dissolution with pure water. The spreading rate of 2-dimensional nuclei was also measured. At low concentrations of sulfate (≤ 0.5 mM), no effect on the growth rate of the calcite was observed. At higher concentrations (2 to 3 mM) of sulfate, the growth rate increased, possibly because a higher concentration of calcium and carbonate was necessary to maintain the supersaturation constant. At much higher concentrations of additional sulfate (up to 60 mM) the growth rate of the calcite was substantially decreased, despite the fact that a further increase of calcium and carbonate was required. The morphology of 2-dimensional growth nuclei became increasingly elongated with increasing sulfate content. Measurements of step height showed that newly grown steps were approximately 1 Å higher when grown in high sulfate concentrations, compared to steps grown in sulfate-free solutions. At sulfate concentrations above 5 mM the growth mechanism changes from layer growth to surface roughening. These observations suggest that the new growth has incorporated sulfate into the calcite surface.     

山西新发现大理岩玉的宝石矿物学特征

山西北部六棱山地区新发现了一种玉石品种——大理岩玉,其主要有黄色和黄褐色两种颜色,结构较致密,透明度较好,是一种优质的饰面石材和玉雕原料。采用薄片观察、环境扫描电子显微镜、X射线粉末衍射、LA-ICP-MS和常规宝石学仪器等测试手段对该大理岩玉样品的宝石矿物学特征进行了测试与研究。结果显示,该大理岩玉为经变质作用形成的方解石大理岩,所含CaCO3的质量分数为96%～97%,推测Fe元素是该玉石的致色元素;微量的碳质和铁质粉末阻碍了柱状方解石的重结晶,形成条纹结构;方解石为不规则的多边形柱体,呈镶嵌的不规则他形变晶结构。通过分析大理岩玉的结构特征,认为平行于其层纹方向切磨,可使得其成品表面光洁度好,光泽强,不易破损。     

Fe and Mn in calcites cementing red beds: A record of oxidation–reduction conditions: Examples from the Catalan Coastal Ranges (NE Spain)

Fe and Mn occur in calcite cements depending on the oxidizing–reducing conditions of cementing waters, which may change according to depositional and diagenetic environments. In red beds, Mn and Fe are available from the ferruginous matrix. Thus, it is possible to know the oxidizing–reducing conditions of fluids that precipitated calcite as a function of Mn and Fe content in calcite cement. A detailed petrological (with special attention to cathodoluminescence) and geochemical analysis of these cements is a useful tool to constrain the diagenetic evolution of red beds and the history of the basin where they deposited.     

白云鄂博矿区周围火成碳酸岩岩墙地质特征

首次填出白云鄂博矿区周围火成碳酸岩岩墙的分布图,深入系统地研究了岩墙的地质产状、主矿物类型、岩石结构、人工重砂矿物组成、稀土元素含量等特征。反映了白云鄂博矿区周围火成碳酸岩岩墙的岩浆演化分异过程存在差异。对于研究白云鄂博矿区铁与稀土的矿化提供了物质来源的证据。     

A study on mechanical properties and fracturing behavior of Carrara marble with the flat-jointed model

Overcoming two inherent limitations presented by the standard bonded-particle model (BPM), the flat-jointed model still lacks extensive application. This study hereby conducts a comprehensive investigation on the application of the flat-jointed model in rock mechanics study. First, after a careful examination on the mechanical behavior of the flat-joint contact, a systematic calibration has been conducted to build numerical models matching the mechanical properties of Carrara marble. Second, the validated model is used to simulate the fracturing behavior of marble specimens containing a single or en-echelon flaws. Finally, the appearance of particle flow code (PFC) models has been compared with the results obtained from optical observation in order to establish a possible correlation between PFC models and real marble regarding microcracking behavior. Discussions suggest that to remove the particle size effect, the model resolution (ratio of sample dimension to the average particle diameter) should be larger than 30 in the flat-jointed model and 150 in the BPM, respectively. Results from the above investigations suggest that the flat-jointed model is capable of matching both the mechanical properties and fracturing behavior of Carrara marble. The numerical model is more reliable to predict the fracturing path at the instant of initiation than at failure. Development of initial fractures is not only controlled by the magnitude of tension force but also influenced by the extent of distribution of tension force. The appearance and components of a fracture in flat-jointed models probably reveal not only its property (tensile or shear) but also the corresponding microcracking behavior of real rocks.     

Heterogeneously nucleated calcite precipitation in Lake Constance. A short time resolution study

Calcite precipitation in spring 1988 in Lake Constance was studied by measuring physical, chemical and biological parameters in daily intervals. Algae triggering calcite precipitation in spring after an induction period of 1 day wereStephanodiscus hantzschii andChlorella spp. whereas no time lag concerning maximum saturation index was observed. Number and size distribution of crystals were determined by microscopical methods. Simple equations were given for estimation of the precipitated mass of calcite by approximating the volume of calcite crystals by simple geometric bodies and multiplying by crystal numbers. Particulate calcium was analysed after dissolving suspended matter and amounted to 90% of inorganic dry weight. Crystals were observed for the first time after dissolved phosphorus was no more detectable.     

Exploring the influence of loading geometry on the plastic flow properties of geological materials: Results from combined torsion + axial compression tests on calcite rocks

For technical reasons, virtually all plastic deformation experiments on geological materials have been performed in either pure shear or simple shear. These special case loading geometries are rather restrictive for those seeking insight into how microstructure evolves under the more general loading geometries that occur during natural deformation. Moreover, they are insufficient to establish how plastic flow properties might vary with the 3rd invariant of the deviatoric stress tensor (J₃) which describes the stress configuration, and so applications that use those flow properties (e.g. glaciological and geodynamical modelling) may be correspondingly compromised. We describe an inexpensive and relatively straightforward modification to the widely used Paterson rock deformation apparatus that allows torsion experiments to be performed under simultaneously applied axial loads. We illustrate the performance of this modification with the results of combined stress experiments performed on Carrara marble and Solnhofen limestone at 500°–600 °C and confining pressures of 300 MPa. The flow stresses are best described by the Drucker yield function which includes J₃-dependence. However, that J₃-dependence is small. Hence for these initially approximately isotropic calcite rocks, flow stresses are adequately described by the J₃-independent von Mises yield criterion that is widely used in deformation modelling. Loading geometry does, however, have a profound influence on the type and rate of development of crystallographic preferred orientation, and hence of mechanical anisotropy. The apparatus modification extends the range of loading geometries that can be used to investigate microstructural evolution, as well as providing greater scope for determining the shape of the yield surface in plastically anisotropic materials.     

Fracturing and calcite cementation controlling fluid flow in the shallow-water carbonates of the Jandaíra Formation,Brazil

The shallow-marine carbonate rocks of the Jandaíra Formation have been subject to significant permeability variations through time due to various events of fracturing and calcite cementation. As a consequence, the Jandaíra Formation accommodated fluid flow only during specific moments in time. We reconstructed these episodes of fluid flow based on isotope characterizations and microscope characteristics of calcite veins and host rock cements. The Jandaíra Formation, which belongs to the post-rift sequence of the Potiguar Basin in northeast Brazil, was deposited from the Turonian onward until a marine regression exposed it in the Campanian. Due to the subaerial exposure, meteoric waters flushed out marine connate waters, leading to an event of early diagenesis and full cementation of the Jandaíra Formation. Fluid flow through the resulting impermeable carbonate formation appears to be closely related to fracturing. Fracturing in the Late Cretaceous induced a drastic increase in permeability, giving rise to extensive fluid circulation. Host rock dissolution associated to the circulating fluids led to calcite vein cementation within the fracture network, causing it to regain an impermeable and sealing character. In the research area, fluid flow occurred during early burial of the Jandaíra Formation at estimated depths of 400–900 m. This study documents the first application of fluid inclusion isotope analysis on vein precipitates, which allowed full isotopic characterization of the paleo-fluids responsible for calcite vein cementation. The fluid inclusion isotope data indicate that upwelling of groundwater from the underlying Açu sandstones provided the fluids to the fracture network. In Miocene times, renewed tectonic compression of a lower intensity created a secondary fracture network in the Jandaíra Formation. The density of this fracture network, however, was too low to induce a new episode of fluid circulation. As a result, this tectonic event is associated with the development of barren extensional fractures.     

Fluid behaviors from the seismogenic region of Longmenshan fault zone,eastern Tibetan PlateauSCIEI北大核心CSCD

震间期、同震期和震后期流体对断裂带物质的强度和运动性质起到重要作用。前人已识别出断裂带浅部区域流体对断层的弱化以及矿物沉淀导致的断层愈合,然而对于断裂带深部流体的研究鲜有报道。为深入了解孕震区流体行为以及地震成核过程中流体对断层的影响,本文以龙门山断裂带的映秀-北川断裂南段虹口乡八角庙村附近碎裂岩滑动带中石英和方解石脉为研究对象,通过对断裂带脉体的显微构造、碳氧同位素和主量元素含量等分析,开展地震相关脉体的特征结构、流体来源和矿物沉淀环境的研究。结果表明,碎裂岩主滑移带由颜色结构不同的三层断层泥和细小的方解石条带组成,在主滑动带边部和上盘碎裂岩中则分别发育了指示震间期、同震期和震后期三个阶段断层活动的脉体:(1)沿阶步生长的纤维状方解石脉和拉伸型柱状颗粒方解石脉;(2)断层泥楔入脉;(3)近等粒状方解石脉以及具有横向竞争生长结构的非等粒状方解石脉和石英脉。它们分别代表了震间期封闭的还原环境下的微滑动、同震外源高压流体注入以及震后开放的氧化环境至还原环境下的矿物沉淀。碳氧同位素结果表明主滑动带和碎裂岩方解石脉δ^(18)O V-PDB值为-20.5‰~-20.3‰,低于围岩碳酸钙胶结物,表明方解石脉具有大气水来源特征。方解石沉淀温度结合地温梯度表明方解石脉的形成深度大于4km,与碎裂岩形成深度及龙门山断裂带震源深度一致。该地区方解石脉和石英脉的研究深化了关于龙门山断裂带孕震区流体行为的理解,并且对进一步认识震间期、同震期和震后期断层的强度变化机制具有重要意义。