非稳腔主动式直接获取纳秒近似无衍射贝塞尔绿光

通过对基于轴棱锥的贝塞尔谐振腔和贝塞尔-高斯谐振腔的研究,设计了一台腔内倍频Nd:YAG纳秒近似无衍射贝塞尔绿光激光器. 非稳激光器谐振腔由轴棱锥和凸面镜组成. 实验采用单灯脉冲抽运激光增益介质Nd:YAG晶体,倍频晶体选用KTP. 当抽运电压为350 V时,由主动式直接产生纳秒近似零阶贝塞尔绿光,其脉冲宽度为55.1 ns,波长为532 nm,线宽为0.8 nm,近似无衍射零阶贝塞尔绿光的中心光斑直径为192 μm. 利用Fresnel-Kirchhoff 衍射积分和Fox-Li迭代法,通过数值计算得出     

阶变折射率轴棱锥产生局域空心光束

提出利用折射率成阶跃性变化的轴棱锥产生局域空心光束(bottle beam).讨论了折射率沿径向成阶跃式减小或增加两种模型,从几何光学角度分析了它们产生bottle beam的原理,利用衍射积分理论数值模拟两种轴棱锥光传输的光场分布和不同距离处的二维光斑图,研究结果表明折射率沿径向阶跃减小的轴棱锥产生单个bottle beam,而折射率沿径向阶跃增加的轴棱锥产生具有周期再现的bottle beams.bottle beam在原子引导和囚禁、光学俘获及光镊等方面有广泛的应用, 因此本文的研究对bottle     

Improvement of the axial trapping effect using azimuthally polarised trapping beam

A dual optical tweezers system, which consists of a doughnut mode optical tweezer (DMOT) with the azimuthally polarised trapping beam and a solid mode optical tweezer (SMOT) with the Gauss trapping beam was constructed to compare the axial trapping effect of DMOT and SMOT. The long-distance axial trapping of ST68 microbubbles (MBs) achieved by DMOT was more stable than that of SMOT. Moreover the axial trapping force measured using the viscous drag method, was depended on the diameter of the particle, the laser power, and the numerical aperture (NA) of the objective lens. The measurement of the axial trapping force and the acquisition of CCD images of trapping effect confirmed that the DMOT showed excellent axial trapping ability than SMOT. A simple and effective method is developed to improve axial trapping effect using the azimuthally polarized beam as trapping beam. This is helpful for the long-distance manipulating of particles especially polarised biological objects in axial direction.     

摄动理论在腐蚀管线随机地震反应分析中的应用

埋地管线的腐蚀情况十分复杂,具有随机性的特点,从而导致其在地震激励下的反应必然具有随机性。本文在管线腐蚀离散状态模型和弹性地基梁原理的基础上,利用随机摄动理论推导给出了腐蚀管线在地震激励下位移和应力的解析表达式,并进行了均值和标准差的计算。实例分析中将该方法计算结果与Monte Carlo模拟方法计算结果进行了对比。结果表明,利用随机摄动方法可以快速、精确地求得腐蚀管线的随机地震反应。     

Analytical solutions for Euler–Bernoulli beam on visco‐elastic foundation subjected to moving load

Analytical solutions for the steady‐state response of an infinite beam resting on a visco‐elastic foundation and subjected to a concentrated load moving with a constant velocity are developed in this paper. The beam responses investigated are deflection, bending moment, shear force and contact pressure. The mechanical resistance of the foundation is modeled using two parameters k_s and t_s — k_s accounts for soil resistance due to compressive strains in the soil and t_s accounts for the resistance due to shear strains. Since this model represents the ground behavior more accurately than the Winkler spring model, the developed solutions produce beam responses that are closer to reality than those obtained using the existing solutions for Winkler model. The dynamic beam responses depend on the damping present in the system and on the velocity of the moving load. Based on the study, dynamic amplification curves are developed for beam deflection. Such amplification curves for deflection, bending moment, shear force and contact pressure can be developed for any beam‐foundation system and can be used in design. Copyright © 2012 John Wiley & Sons, Ltd.     

地球弓激波前的低频磁流体波

一、引言 在地球弓激波前存在着低频磁流体波。这种低频磁流体波是太阳风在地球弓激波上的反射粒子和太阳风粒子之间相互作用产生的。根据人造卫星的观测资料可以得到,在地球弓激波前,Pc3-4脉动频率范围内的低频磁流体波的主频率和行星际磁场强度     

钢梁阻尼器的最佳延性率及其控制

基于双线性和三线性的力－位移滞回线假设，导出了钢梁阻尼器隔震系统等效阻尼比与阻尼器延性率的关系；为了获得大阻尼比隔震系统，以尽量减小隔震系统的地震反应，求得了使系统阻尼比为最大的阻尼器相应延性率（即最佳延性率）所需满足的条件；给出了在给定地震地面运动输入条件下，使系统阻尼器变形位移达到最佳延性率的阻尼器初始刚度和屈服位移的确定方法。     

滑坡钢筋砼格构防治"倒梁法"内力计算研究

格构锚固技术能有效地控制滑坡深部和浅表破坏,提高锚固体系的整体刚度。目前在格构 锚杆体系的设计中,大多采用经验设计钢筋砼格构,常导致配筋不合理,不仅造成浪费,而且可能埋下工程隐患。本文采用“倒梁法”对格构梁的内力计算方法进行研究,对滑坡防护钢筋格构进行如下简化:(1)锚杆对格构梁的作用以垂向力为主,轴向力可以忽略不计。(2)纵向格构梁的刚度大于横向格构梁的刚度,因而横向格构梁的内力计算可以简化,钢筋砼格构可以作为在锚杆施力下的超静定连续梁。结合三峡工程库区巫山新城秀峰寺滑坡格构防护工程设计,通过“三弯矩方程”进行了格构梁内力实例计算,为格构梁的合理设计提供了依据。