Environmental pollution impact on water and sediments of Kumaun lakes, Lesser Himalaya, India: a comparative study

A study of the water and sediment chemistry of the Nainital, Bhimtal, Naukuchiyatal and Sattal Lakes of Kumaun, has shown that the water of these lakes are alkaline and that electrical conductivity, total dissolved solid and bicarbonate HCO ₃ ⁻ are much higher in Nainital than in the other three lakes. The weathering of limestone lithology and anthropogenic pollution, the latter due to the very high density of population in the Nainital valley, are the primary sources of enhanced parameters. The low pH of Nainital Lake water is due to low photosynthesis and enhanced respiration, increasing CO₂ in the water and the consequent enhancement of Ca²⁺ and HCO ₃ ⁻ . The dissolved oxygen in Nainital Lake is less compared to other lakes, indicating anoxic conditions developing at the mud–water interface at depth. The PO ₄ ³⁻ content in Nainital is higher (124 μg/l), showing an increasing trend over time leading to eutrophic conditions. The trace metals (Cu, Co, Zn, Ni, Mn, and Sr) are present in greater amounts in the water of Nainital Lake than in the other three lakes, though Fe and Cr are high in Bhimtal and Fe in Naukuchiyatal. The higher abundance is derived from the leaching of Fe–Mg from metavolcanic and metabasic rocks. Most of the heavy metals (Cr, Ni, Cu, Mn, Fe, Sr, and Zn) significantly enrich the suspended sediments of the lakes compared to the bed sediments which due to their adsorption on finer particles and owing to multiple hydroxide coating and organic content, except for Fe, which is enriched in the bed sediments. The high rate of sedimentation, 11.5 mm/year in Nainital, compared to Bhimtal with 4.70 mm/year, Naukuchiyatal with 3.72 mm/year, and Sattal with 2.99 mm/year, has resulted in shorter residence time, poor sorting of grains, and lesser adsorption of heavy metals, leading consequently, their depletion in the bed sediments of Nainital Lake.     

Pixel‐oriented land use classification in energy balance modelling

Mass and energy transfer between soil, vegetation and atmosphere is the process that allows to maintain an adequate energy and water balance in the earth–atmosphere system. However, the evaluation of the energy balance components, such as the net radiation and the sensible and latent heat fluxes, is characterized by significant uncertainties related to both the dynamic nature of heat transfer processes and surfaces heterogeneity. Therefore, a detailed land use classification and an accurate evaluation of vegetation spatial distribution are required for an accurate estimation of these variables. For this purpose, in the present article, a pixel‐oriented supervised classification was applied to obtain land use maps of the Basilicata region in Southern Italy by processing three Landsat TM and ETM+ satellite images. An accuracy analysis based on the overall accuracy index and the agreement Khat of Cohen coefficient showed a good performance of the applied classification methodology and a good quality of the obtained maps. Subsequently, these maps were used in the application of a simplified two‐source energy balance model for estimating the actual evapotranspiration at a regional scale. The comparison between the simulations made by applying the simplified two‐source energy balance model and the measurements of evapotranspiration at a lysimetric station located in the study area showed the applicability and the validity of the proposed methodology. Copyright © 2012 John Wiley & Sons, Ltd.     

Prediction of river water temperature: a comparison between a new family of hybrid models and statistical approaches

River water temperature is a key physical variable controlling several chemical, biological and ecological processes. Its reliable prediction is a main issue in many environmental applications, which however is hampered by data scarcity, when using data‐demanding deterministic models, and modelling limitations, when using simpler statistical models. In this work we test a suite of models belonging to air2stream family, which are characterized by a hybrid formulation that combines a physical derivation of the key equation with a stochastic calibration of parameters. The air2stream models rely solely on air temperature and streamflow, and are of similar complexity as standard statistical models. The performances of the different versions of air2stream in predicting river water temperature are compared with those of the most common statistical models typically used in the literature. To this aim, a dataset of 38 Swiss rivers is used, which includes rivers classified into four different categories according to their hydrological characteristics: low‐land natural rivers, lake outlets, snow‐fed rivers and regulated rivers. The results of the analysis provide practical indications regarding the type of model that is most suitable to simulate river water temperature across different time scales (from daily to seasonal) and for different hydrological regimes. A model intercomparison exercise suggests that the family of air2stream hybrid models generally outperforms statistical models, while cross‐validation conducted over a 30‐year period indicates that they can be suitably adopted for long‐term analyses. Copyright © 2016 John Wiley & Sons, Ltd.     

Modeling deepwater seabed steady-state thermal fields around buried pipeline including trenching and backfill effects

Deepwater pipelines are designed to transport mixtures of oil and gas, and their associated impurities at wellhead temperatures that can be in excess of 149 °C (∼300 °F or 422 K) while the external temperature maybe in the range of 5 °C (∼41 °F or 278 K). Depending on the circumstances these pipelines may be buried for physical protection or for additional thermal insulation using robotic trenching equipment. This results in a complex cut and backfill geometry in the seafloor in addition to altering the thermal properties of the backfill. A two-dimensional boundary element model was developed specifically to address to investigate the local steady-state thermal field in the near field of the pipeline. The model allows one to account for the complex geometries in the near field associated with this burial technique, site-specific multi-layered soil conditions and the seawater adjacent to the seafloor. A parametric study was preformed to evaluate effects of the thermal power loss, burial depth, pipe diameter and soil thermal conductivity on the thermal field in the near field of a buried pipeline. The numerical examples illustrate the influence of the backfill thermal property on the temperature at the pipe wall, that the pipe diameter controls the required output thermal power needed to maintain the desired pipe wall temperature, and the importance of pipeline burial depth on seabed temperature distribution above the pipeline.     

Improved spatial delineation of streambed properties and water fluxes using distributed temperature sensing

A new method was developed for analysing and delineating streambed water fluxes, flow conditions and hydraulic properties using coiled fibre‐optic distributed temperature sensing or closely spaced discrete temperature sensors. This method allows for a thorough treatment of the spatial information embedded in temperature data by creating a matrix visualization of all possible sensor pairs. Application of the method to a 5‐day field dataset reveals the complexity of shallow streambed thermal regimes. To understand how velocity estimates are affected by violations of assumptions of one‐dimensional, saturated, homogeneous flow and to aid in the interpretation of field observations, the method was also applied to temperature data generated by numerical models of common field conditions: horizontal layering, presence of lateral flow and variable streambed saturation. The results show that each condition creates a distinct signature visible in the triangular matrices. The matrices are used to perform a comparison of the behaviour of one‐dimensional analytical heat‐tracing models. The results show that the amplitude ratio‐based method of velocity calculation leads to the most reliable estimates. The minimum sensor spacing required to obtain reliable velocity estimates with discrete sensors is also investigated using field data. The developed method will aid future heat‐tracing studies by providing a technique for visualizing and comparing results from fibre‐optic distributed temperature sensing installations and testing the robustness of analytical heat‐tracing models. Copyright © 2016 John Wiley & Sons, Ltd.     

A long‐lived metamorphic history in the contact aureole of the Mooselookmeguntic pluton revealed by in situ dating of monazite grains preserved as inclusions in staurolite porphyroblasts

Emplacement of the Mooselookmeguntic pluton, located in the western Maine region of the northern Appalachians, was thought to have occurred towards the end of the Acadian deformation at around 370 Ma. Crystallization ages from different parts of the pluton suggest a more sequential emplacement history over a period of c. 20 Myr. Foliation inflection/intersection axes (FIAs) within porphyroblasts from its aureole reveal at least five periods of garnet and staurolite growth. The orientation of FIAs in both garnet and staurolite porphyroblasts trend successively from ESE–WNW, NNW–SSE, E–W, ENE–WSW to NE–SW. Electron probe microanalysis dating of monazite grains included in staurolite porphyroblasts containing one of these five periods of FIA development reveals a succession of apparent ages from 410 Ma to 345 Ma. A similar spread of crystallization ages can be observed for plutons from Maine and adjacent regions. This succession indicates that deformation and metamorphism began well before and continued long after what is classically regarded as the Acadian orogeny. The thermal structure of the orogen progressively evolved to enable pluton emplacement, and it continued to develop afterwards with magmatic fluids still forming at depth.     

Structural geometry and controls on basement‐involved deformation in the northern Flinders Ranges,Adelaide Fold Belt,South Australia

In the northern Flinders Ranges, Neoproterozoic and Cambrian sedimentary rocks were deformed and variably metamorphosed during the ca 500 Ma Cambro‐Ordovician Delamerian Orogeny. Balanced and restored structural sections across the northern Flinders Ranges show shortening of about 10–20%. Despite the presence of suitable evaporitic detachment horizons at the basement‐cover interface, the structural style is best interpreted to be thick‐skinned involving basement with only a minor proportion of the overall shortening accommodated along stratigraphically controlled detachments. Much of the contractional deformation was localised by the inversion of former extensional faults such as the Norwest and Paralana Faults, which both controlled the deposition of Neoproterozoic cover successions. As such, both faults represent major, long‐lived structures which effectively define the present boundaries of the northern Flinders Ranges with the Gawler Craton to the west and the Curnamona Craton to the east. The most intense deformation, which resulted in exhumation of the basement along the Paralana Fault to form the Mt Painter and Babbage Inliers, coincides with extremely high heat flows related to extraordinarily high heat‐production rates in the basement rocks. High heat flow in the northern Flinders Ranges suggests that the structural style not only reflects the pre‐Delamerian basin architecture but is also a consequence of the reactivation of thermally perturbed, weakened basement.     

Scaling the Anthropocene: How the stories we tell matter

Ongoing debates in the Earth, planetary, and social sciences examine the merits and implications of traces in the stratigraphic record that would indicate that humans are now one of the ‘great forces of nature’. Candidates for key marker horizons in such a stratal section include noted changes in carbon and nitrogen concentrations, plastics, radionuclides, and metals. Candidates for determining calendar age, include the tipping point in land cover from wildlands to agriculture and the first nuclear detonation. Here we offer a critical review of recent literature contributing to delineating an Anthropogenic stratum, by exploring their interpretation as initiating, sustaining, or indeed ending an Anthropocene epoch. We also offer a reflection on the layer not representing a new period, any more than, for instance, iridium marks a ‘meteoritic’ epoch between the Cretaceous and Palaeogene. We examine temporal scales for their accord with geological methods of definition and delineation, and for the opportunities and constraints each presents for understanding and responding to transformations in the Earth system. Our thesis is that increasingly fortified stances on the ‘right’ definition of the Anthropocene epoch follow traditions of linear and authoritarian historical accounts, and prevent discovering epistemes of human-environment interactions that are open for coexistence. The co-existence of many key transitions will sustain ongoing and fruitful deliberations over human-environment interactions that the Anthropocene proposal has initiated, promoting research that can work with the many scales, discourses, and narratives of environmental change.     

东北地区春季首场透雨的变化特征及与青藏高原地面加热场强度的关系

利用1958—2012年4—5月东北地区(39°~55°N、118°~135°E)101个站点逐日降水资料、青藏高原地区(25°~40°N、73.75°~103.75°E)JRA-55的地面感热和潜热通量月平均再分析资料以及NCEP/NCAR-I大气环流场的月平均再分析资料,分析了春播期首场透雨出现日期的时空变化特征及其与透雨量和播种期降水量间的关系,以及对青藏高原地面加热场强度异常的响应及其可能机制。结果表明:透雨日期自1958年以来在东北地区的西北和东南大部分区域呈现略微偏晚的趋势;中部有略微偏早的趋势。春播期首场透雨出现时间偏早(晚)的地方,首场透雨量小(大),春播期总降水量多(少)。同时,4月青藏高原地面加热场强度增强(减弱),有利于(不利于)来自北方的冷空气和南方的暖湿气流在东北上空交汇,且上升气流增强(减弱),水汽输送充沛(减少),导致该地区春季首场透雨出现的时间偏早(晚)。