不同形状振荡浮子入水冲击的实验研究

振荡浮子在波浪能转换装置中应用非常广泛,在其服役期间,由于较小的设计吃水深度或为防避极端海况的需要,它们经常会离开水面;当其再次入水的时候,浮子底部就会受到入水冲击。入水冲击总是伴随着巨大的冲击压强以及冲击载荷,会导致浮子的结构性及疲劳性破坏,从而影响浮子的工作寿命。本文对锥形、半球形和横圆柱形三种形状的浮子入水冲击过程进行了实验研究,分析了浮子表面压强和冲击加速度的变化规律。主要结论如下:(1)在巨大的水阻力作用下,入水瞬间三种浮子表面压强急剧上升,迅速达到最高峰值;之后由于空气垫的作用,压强出现二次峰值现象。(2)在空气垫的作用下,三种浮子的最高压强峰值均未出现在浮子的最低点处,而是出现在外围某处。(3)三种浮子在触水瞬间的加速度均达到hm/s~2的量级,而后急剧下降,并在较短时间内达到一平衡值并沿其小幅震荡。(4)横圆柱形浮子由于其非垂直轴对称性,其表面压强和加速度的震荡更加明显。     

在Zebiak-Cane模式中观测MJO强迫对ENSO可预报性的影响, 第1部分:对最大预报误差的影响

With the observational wind data and the Zebiak-Cane model, the impact of Madden-Julian Oscillation (MJO) as external forcing on El Ni(n)o–Southern Oscillation (ENSO) predictability is studied. The obs...     

莱州湾东岸近岸海域规划围填海后冲淤演变预测

运用Mike21模型中的水动力模块对研究区的潮流场进行了模拟,分析研究区的冲淤趋势;利用经验公式,对波浪和潮流进行耦合,计算出极端条件下的最大冲刷深度,对比规划用海实施前后的最大冲刷深度,以对该区域的海岸防护、工程选址等提供科学依据。结果表明:受到填海工程的影响,龙口湾内有轻微淤积,界河至石虎咀近岸海域的波浪和潮流受工程影响而变小,冲刷强度变弱。     

Genetic parameter estimation for juvenile growth and upper thermal tolerance in turbot (Scophthalmus maximus Linnaeus)

Twenty-six half-sib groups(53 full-sib families) of turbot, Scophthalmus maximus Linnaeus, were obtained by artificial insemination. We measured growth in the offspring(40–50 individuals/family) and subjected them to a thermal tolerance challenge over a period of 34 d. There was no significant difference in daily mortality(range: 0.580%–1.391%) between Days 1–13 during the thermal tolerance challenge. However, daily cumulative mortality increased rapidly between Days 14 and 29, especially on Days 15 and 16(20.232% and 34.377%, respectively). Mortality was highest on Day 16(14.145%). We estimated the genetic parameters using the average information restricted maximum likelihood method. We used a likelihood ratio test to evaluate the significance of effects in models with and without identity as an effect, and compared the final log-likelihoods(maximum log L). Lastly, we estimated phenotypic and genetic correlation between the upper thermal tolerance limit(UTT) and body weight(BW). In this study, the positive phenotypic correlation was low between UTT and BW(0.093±0.029). The genetic correlation between UTT and BW was negative(-0.044±0.239). The heritability for upper thermal tolerance was low(0.087±0.032), which is of approximately moderate heritability. The heritability for body weight was high(0.303±0.074). Our results suggest there is significant potential for improvement in the culture of turbot by selective breeding.     

Dispersal of the Zhujiang River (Pearl River) derived sediment in the Holocene

High-resolution Chirp profiling and coring reveals an elongated(ca. 400 km) Holocene Zhujiang River(Pearl River)-derived mud area(maximum thickness 20 m) extending from the Zhujiang River Delta, southwestward off the Guangdong coast, to the Leizhou Peninsula. Two depo-centers, one proximal and one distal, are identified. On the continental shelf off the west Guangdong Province, the mud is deposited in water depth shallower than 50 m; while to the southeast of the Zhujiang River Estuary, the mud area can extend to the-120 m isobath. A combined analysis with the stratigraphic sequences of other muddy deposits in the Western Pacific marginal seas(mainly Changjiang(Yangtze) and Huanghe(Yellow) Rivers derived) indicates that the initiation of the Zhujiang River muddy deposit can be further divided into two stages: Stage 1 is before the mid-Holocene sea-level highstand(ca. 7.0 cal. ka BP), the proximal mud was mostly deposited after 9.0 cal. ka BP, when the sea-level rose slowly after the Meltwater Pulse-1C; Stage 2, after the mid-Holocene sealevel highstand, clinoform developed on the continental shelf off the west Guangdong Province, extending ca. 400 km from the Zhujiang River Estuary. The proximal clinoform thins offshore, from ca. 10 m thickness around 5–10 m water depth to less than 1–2 m around 20–30 m water depth. In addition, we also find a developed distal clinoform in the east of the Leizhou Peninsula.     

舟山海域风暴潮特征及数值模拟研究

选择20个对舟山海域有较大影响的历史台风案例,开展定海站实测潮位数据的分析与归纳,总结得出20个台风中风暴潮过程增水最大值为5612号台风的207.1 cm,风暴潮高潮位最大值为9711号台风的283.7 cm。同时,在三维斜压水动力模型SELFE的基础上加入台风气压场和风场模块,建立了一个采用非结构三角形网格的天文潮-风暴潮耦合模型,模拟表明定海站的斜压效应较为明显,非线性耦合作用相对较弱,但两潮耦合风暴潮增水结果仍优于风暴潮单因子增水结果,与实际增水更为接近。在此基础上,以一定间隔在5612号台风原路径南北两侧各设计了2条平行路径,分别模拟两潮耦合风暴潮增水,结果表明5612号台风参数沿其原路径偏南1个最大风速半径距离的S1路径运动时可模拟得到定海站可能最大风暴潮增水为243.9 cm。最后,在S1路径下模拟可能最大风暴潮增水分别遭遇天文高、中、低潮位时的风暴潮高潮位,结果表明天文潮高潮时可得到可能最大风暴潮高潮位约为400 cm,天文中潮时次之,而天文低潮时风暴潮高潮位最低。     

小型天文测量计时器研究

以高稳定性数字温补晶振为频率源,以8051内核单片机为核心,设计了一种小型天文测量计时器。用于长时间自主守时,为野外天文大地测量提供可靠的高精度时间基准。在进行天文大地测量计时的同时,可对环境温湿度和大气压强进行自动测量记录。用该计时器进行了长时间连续时间比对实验,收集了20 d实验数据,分析了计时器的稳定性。实验结果表明,计时器运行稳定,20 d计时的中误差优于1.5 ms;小时钟速最大互差小于2 ms·h^(-1);用1 h时间比对数据外推100 d钟差,误差优于0.4 s。     

基于无人机影像样本的遥感图像分类方法

对于遥感图像计算机自动分类而言,样本选择至关重要,直接影响分类结果精度。为了提升样本选取的质量,本文在实验区卫星影像覆盖范围内选取了几个样本点。对每个样本点利用无人机采集了约0.3 km2的数据,通过后期处理生成正射影像。在正射影像中选取耕地、植被、水体、建筑和道路等几类地物的样本,采用最大似然值法对卫星影像进行相应类别信息提取。实验结果表明：在无人机高分辨率影像上解译的样本作用于卫星遥感影像,并利用最大似然值法进行信息提取,其方法可行,分类精度优于在卫星影像上选择的样本。     

0917号台风“芭玛”折向东南向移动原因分析

利用NCEP全球数据同化系统(GDAS)1°×1°分析资料,对0917号台风"芭玛"折向东南向移动原因进行了分析。结果表明,中高纬度环流调整是"芭玛"折向东南向移动的根本原因;0918号台风"茉莉"通过改变外围环境场的强度、形状对"芭玛"台风产生间接影响,而两台风之间逆时针互旋以及台风"茉莉"外围强大的环流对台风"芭玛"的直接作用是台风"芭玛"折向东南向移动的关键。对台风"芭玛"经纬向UV最大风速变化诊断分析表明,"芭玛"经纬向UV最大风速中心的转移对"芭玛"折向东南向移动有重要影响,经纬向UV最大风速差的变化对"芭玛"转向具有预示作用,经纬向最大风速差的合成风方向与台风中心未来移动方向有一定的关系。     

落石冲击混凝土板与缓冲层组合结构的动力响应

钢筋混凝土（RC）板与一定厚度的土颗粒缓冲层组合结构被广泛用于山区高位单体及群发性崩塌落石的防治,为研究此类防护结构在落石作用下的冲击力衰减规律及RC板的破坏模式,开展了室外系列落石冲击试验。结果表明,增大缓冲层厚度能够有效减小最大冲击力,峰值加速度随缓冲层厚度减小而增大,尤其在缓冲层厚度为0.1 m及0.2 m时,最大值急剧增大,峰值加速度与缓冲层厚度的变化满足指数函数关系;根据量纲分析原理得到缓冲层最大冲击深度与动能的平方成正比、与最大入射冲击力成反比的计算公式,且与实测值较吻合;入射冲击力在缓冲层内的衰减率随缓冲层厚度的增加以指数函数递增,在0.6 m缓冲层厚度下可使峰值冲击力衰减70%左右;随累积冲击能级的增大,RC板经历了弯曲起裂及扩展、次级弯曲裂纹和剪裂纹产生及跨中弯曲裂纹贯通的过程,试验结束时RC板整体表现出典型的弯曲破坏特征。