水平成层场地动剪应变与震动速度关系解析

以SHAKE2000为代表的频域等效线性化是目前主流的土层地震动计算方法。由于该方法在软土场地计算结果严重不合理,其改进方法成为目前研究热点,主要采用频率相关法,但一直没有取得实效。对频率相关法中土体动剪应变和震动速度成恒定比例关系的基本假定进行研究,从波动方程推导出了均匀全空间单向行波、单一均匀半无限场地、成层场地等3种典型场地中土体剪应变与震动速度关系的精确解答,通过数值试验研究了这一假定的合理性与偏差程度。结果表明：动剪应变和震动速度成恒定比例关系这一假定只有在无边界均匀介质单向行波情形下才成立,对于实际成层土场地,动剪应变与震动速度关系强烈依赖于波的频率和观察点的位置,如果在土层地震反应分析中忽略反射波而采用单向行波恒定比例假定将会使计算结果产生显著偏差;动剪应变与震动速度成恒定比例关系的假定导致的偏差达4个量级,即使对于单一均匀半无限空间模型偏差也十分显著;对实际土层地震动的求解,该假定在理论上定性错误,定量上偏差不可接受,必须放弃而另寻其他途径。     

A Numerical Study on the Screening of Blast-Induced Waves for Reducing Ground Vibration

Blasting is often a necessary part of mining and construction operations, and is the most cost-effective way to break rock, but blasting generates both noise and ground vibration. In urban areas, noise and vibration have an environmental impact, and cause structural damage to nearby structures. Various wave-screening methods have been used for many years to reduce blast-induced ground vibration. However, these methods have not been quantitatively studied for their reduction effect of ground vibration. The present study focused on the quantitative assessment of the effectiveness in vibration reduction of line-drilling as a screening method using a numerical method. Two numerical methods were used to analyze the reduction effect toward ground vibration, namely, the “distinct element method” and the “non-linear hydrocode.” The distinct element method, by particle flow code in two dimensions (PFC 2D), was used for two-dimensional parametric analyses, and some cases of two-dimensional analyses were analyzed three-dimensionally using AUTODYN 3D, the program of the non-linear hydrocode. To analyze the screening effectiveness of line-drilling, parametric analyses were carried out under various conditions, with the spacing, diameter of drill holes, distance between the blasthole and line-drilling, and the number of rows of drill holes, including their arrangement, used as parameters. The screening effectiveness was assessed via a comparison of the vibration amplitude between cases both with and without screening. Also, the frequency distribution of ground motion of the two cases was investigated through fast Fourier transform (FFT), with the differences also examined. From our study, it was concluded that line-drilling as a screening method of blast-induced waves was considerably effective under certain design conditions. The design details for field application have also been proposed.     

Experimental Study on Coupled Cross-Flow and in-Line Vortex-Induced Vibration of Flexible Risers

In this work, we study the coupled cross-flow and in-line vortex-induced vibration （VIV） of a fixedly mounted flexible pipe, which is free to move in cross-flow （ Y- ） and in-line （ X- ） direction in a fluid flow where the mass and natural frequencies are precisely the same in both X- and Y-direction. The fluid speed varies from low to high with the corresponding vortex shedding frequency varying from below the first natural frequency to above the second natural frequency of the flexible pipe. Particular emphasis was placed on the investigation of the relationship between in-line and cross-flow vibration. The experimental results analyzed by using these measurements exhibits several valuable features.     

Mitigation of Ice-Induced Vibrations for Offshore Platforms Using Tuned Mass Damper

The problems of ice-induced vibration have been noticed and concerned since the 1960s, but it has not been well resolved. One reason is that the dynamic interaction between ice and structure is so complicated that practical ice force model has not been developed. The recent full-scale tests conducted on jacket platforms in the Bohai Sea presented that ice could cause intense vibrations which endanger the facilities on the deck and make discomfort for the crew. In this paper, the strategy of mitigation of ice-induced offshore structure vibration is discussed. Based on field observations and understanding of the interaction between ice and structure, the absorption mitigation method to suppress ice-induced vibration is presented. The numerical simulations were conducted for a simplified model of platform attached with a Tuned Mass Danlper （TMD） under ice force function and ice force time history. The simulation results show that TMD can fa- vorably reduce ice-induced vibrations, therefore, it can be considered to be an alternative approach to utilize. Finally, the application possibilities of utilizing TMDs on other miniature offshore structures in ice-covered areas of marginal oil fields are discussed.     

Hill Instability Analysis of TLP Tether Subjected to Combined Platform Surge and Heave Motions

This paper presents the Hill instability analysis of Tension keg Platform （TLP） tether in deep sea. The 2-D nonlinear beanl model, which is undergoing coupled axial and transverse vibrations, is applied. The governing equations are reduced to nonlinear Hill equation by use of the Galerkin＇ s method and the modes superposition principle. The Hill instability charted up to large parameters is obtained. An important parameter M is defined and can be expressed as the functions of tether length, the platform surge and heave motion amplitudes. Some example studies are performed for various envirotnnental conditions. The results demonstrate that the nonlinear coupling between the axial and transverse vibrations has a significant effect on the response of structure. It needs to be considered for the accurate dynamic analysis of long TI2 tether subjected to the combined platfolna surge and heave motions.     

浮式平台横荡运动对水下柔性立管涡激振动的影响

由于深水浮式平台的运动幅度较固定式平台增大,其运动与下部立管的动力耦合变得更加明显。研究了上部平台运动对水下立管涡激振动的影响,基于有限元数值模拟,建立了与结构运动耦合的立管尾迹流场的涡激升力、流体阻力模型,进行了"平台运动-立管涡激振动"整体系统的动响应数值模拟,分析了平台横荡运动的幅值、频率等因素对水下立管涡激振动的影响。结果表明,上部平台的振动会在沿着立管展向传播的过程中被放大(称为响应放大);与不考虑平台运动相比,立管的动响应位移增大了多倍,而且振幅放大倍数随着模态阶数的降低而增大;平台横荡振幅越大,立管振动幅值也越大,但是振幅放大倍数的变化不明显。     

Development of Prebored Screw Pile Method and Evaluation of Its Bearing Characteristics

The pile-driving method produces considerable noise and vibrations. Hence, an auger-drilled pile method was developed as a low-noise and -vibration substitute. However, this method does not guarantee the bearing capacity of the pile unless some amount of pile-driving is performed. Therefore, the noise and vibration problems cannot be completely solved. In this study, a prebored screw pile method is proposed to solve these problems. In this method, piles are constructed by the rotary penetration of a screw pile into a prebored hole filled with some cement milk and whose diameter is smaller than that of the screw pile. To determine the shape of the screw pile, laboratory tests with model screw piles were conducted. Also, field load tests were conducted on an actual screw pile fabricated based on the laboratory test result and on a smooth-surfaced pile. In addition, the behavior of the screw pile was estimated by using three-dimensional finite element analysis. The results of the field load test and the numerical simulation showed that the ultimate bearing capacity and the unit skin friction of the screw pile are very superior to those of the smooth-surfaced pile and the cement milk is an important factor in the prebored screw pile method.     

自升式平台冰激动力响应分析

应用ANSYS软件建立了平台和冰相互作用的有限元模型,构建了自升式平台的冰激振动模型,并计算基于2种冰力模型的自升式平台的动力响应。此动力分析方法具有建模方便和计算精度高的特点。以某自升式平台为例,计算了冰和平台结构相互作用的耦合效应,为自升式平台冰激振动安全评估提供了参考依据。     

Analytic Solution of Interaction Between Surface Waves and Floating Elastic Plates with Elastic End-Restraints

Based on the dynamic theories of water waves and Mindlin plates,the analytic solution of interaction between surface waves and two-dimensional floating elastic plates with edge-restraint is constructed by use of the Wiener-Hopf technique.Firstly,without regard for elastic edge restraint,the wave-induced responses of elastic floating plate analyzed by the present method are in good agreement with the results from literature and experimental results.Therefore,it can be shown that the present method is valid.Secondly,three end-restraint cases(i.e.,the left-end elastic restraints,the both-end elastic restraints,and the right-end elastic restraints)are proposed to reduce the vibration of floating plates,in which the spring is used to connect the sea bottom and the floating plate's left(or right)edge.The relations between the spring stiffness and the parameters of wave-induced responses of floating plates are discussed.Moreover,the effective method to reduce the vibration of floating elastic plates can be obtained through comparison.