基于物方影像匹配和概率松弛的断面自动提取

提出了基于物方影像匹配的断面提取,为了提高匹配的可靠性,引入了概率松弛法,最终获得了高精度的断面.     

基于通量均衡基准的地壳垂直形变场分析模型

根据全球通量均衡假说建立了地壳垂直形变场的分析模型，在球面近似下求得了该模型的球谐函数级数解并拟合了两个不同区域的地壳垂直形变场，编绘了等值线图，继而在密切平面坐标系下导出了该模型的Fourier级数解。结果表明，该方法不仅具有几何意义，而且具有一定的地球动力学意义。     

自动风向转换程序设计思路

由于OSSMO 2004版地面测报业务软件中抄录报表风向不太方便，故长治县气象局自行设计了自动风向角度和方位的转换程序。本程序用OBJECT PASCAL语言编写，在DELPHI中实现，采用Microsoft．Jet．OLEDB．4．0数据库引擎及ADO的方式操作数据库。     

竖向地震动强度包络函数的空间变化规律

利用SMART 1台阵三次地震记录拟合了各个测点在地震中的竖向地震动强度包络曲线及Amin 和Ang的强度包络函数中各模型参数值,分析了各模型参数的空间变化规律,建立了各模型参数随二维空间坐标及土层厚度变化的随机模型,为多点地震动合成中竖向强度包络函数的计算提供了理论依据。     

Slow mass movement in the Kangchenjunga area, eastern Nepal Himalaya

Abstract   The rates of the accumulated and continuous displacement of solifluction lobes in the Kangchenjunga area, eastern Nepal Himalaya, were determined using glass fiber tubes and a strain probe. Ground temperature, precipitation and soil moisture were monitored at two sites, whose altitude differed by approximately 100 m, to understand the solifluction process. The average movement rate of the glass fiber tubes on a 31° slope at altitudes of 5412–5414 m a.s.l. was approximately 11 mm/year, being almost threefold greater than that observed on a 22° slope at 5322–5325 ma.s.l. There was no significant difference in the depth of displacement at these sites. The continuous displacement measurement near the ground surface at 5414 m showed permanent downslope movement from early July. Such movement may be attributed to additional moisture supply during the monsoon season. The amplitude of the displacement cycle was highest at the ground surface, and decreased to virtually zero at and below 20 cm in depth. Probable factors leading to the relatively slow rates of downslope displacement at the surface and depth at the studied altitudes are the lack of concurrence of the freeze–thaw cycles and the high moisture condition in the soil, and the low moisture retention capacity of the soil because of steep slopes and superficial desiccation. The rate of displacement may be more pronounced at altitudes above 5600 m because of the freeze–thaw cycles during the summer season.     

The effective number of cycles of earthquake ground motion

The seismic response of any system that accumulates damage under cyclic loading is dependent not only on the maximum amplitude of the motion but also its duration. This is explicitly recognized in methods for estimating the liquefaction potential of soil deposits. Many researchers have proposed that the effective number of cycles of the ground motion is a more robust indicator of the destructive capacity of the shaking than the duration. However, as is the case with strong‐motion duration, there is no universally accepted approach to determining the effective number of cycles of motion, and the different methods that have been proposed can give widely varying results for a particular accelerogram. Definitions of the effective number of cycles of motion are reviewed, classified and compared. Measurements are found to differ particularly for accelerograms with broad‐banded frequency content, which contain a significant number of non‐zero crossing peaks. The key seismological parameters influencing the number of cycles of motion and associated equations for predicting this quantity for future earthquakes are identified. Correlations between cycle counts and different duration measures are explored and found to be rather poor in the absence of additional parameters. Copyright © 2004 John Wiley & Sons, Ltd.     

The dependence of response spectrum on the tectonic ambient shear stress field

Introduction The acceleration response spectrum and peak ground acceleration are the necessary and im-portant parameters in earthquake-resistant design at present. They are still active research field. With the increase of digital high accurate strong motion observation data, especially the earth-quakes of Loma Prieta (M=7.0) in 1989; Landers (M=7.3) in 1992; Big Bear (M=6.4) in 1994 and Northridge (M=6.7) in 1994 in USA; Kozani (M=6.6) earthquake and afteshocks in 1995 in Greece; Dinar…     

Study on comparison between absolute and relative input energy spectra and effects of ductility factor

Introduction Estimation of an attenuation relationship for strong ground motion parameters has been an interesting research subject in the field of engineering seismology and has played a very important role in seismic safety evaluation, seismic zoning, seismic hazard evaluation of major constructions, etc. At present, the generally used parameters include peak acceleration, peak velocity and elastic response spectrum. Such parameters mentioned above are essentially independent of the duration…     

Study on simulating strong ground motion by fractal stochastic method

The time history of strong ground motion can be synthesized by empirical Green's function (EGF) method.Firstly a large seismic event is discretized into a series of subevents; secondly recordings of earthquakes with proper size and spatial distribution are chosen as time history (EGF) of those subevents; finally the EGFs are summated to get the time history of ground motion caused by the large event.