青藏高原Pn波研究进展及问题

简要总结了青藏高原地区Pn波速度结构、各向异性研究进展；介绍了Pn波速度结构、各向异性等在岩石圈结构、构造背景反映等方面的应用研究进展。分析了目前青藏高原Pn波研究中存在的一些问题。     

昆仑山口西MＳ＝8．1级地震的形变应变场研究

根据昆仑山口西8．1级地震前后GPS测点的位移速率，用弹性模型公式计算了地壳应变参数．应变参量的变化表明，震前在地震区附近以压应变为主，应变速率较大．位移速率矢量显示出震前的震中地区相对周围为活动性较弱的“稳定”地区．地壳的形变和应变揭示出孕震体在挤压状态下积累了较高的应变势能．8．1级地震的同时期由于地壳释放了巨大的应变能而应变速率变化显著．计算结果表明，地震所产生的应变达到4．5×10-6以上．发震断裂带的平均左旋走滑量是3．31m（89°E～96°E）．     

中国中西部地区地震的重新定位和三维地壳速度结构

采用中国中西部地区(21~36N， 98~112E)193个地震台在1992～1999年间记录到的9 988次地震的Pg和Sg震相走时的读数资料，用Roecker的SPHYPIT90程序，反演了该地区三维地壳P波速度结构，并用SPHREL3D90程序进行了地震的重新定位．反演结果揭示了中国中西部地区地震P波速度结构明显的横向不均匀性，这些不同深度上波速的横向变化多以该地区的活动断裂为分界线．可以看出活动断裂两侧存在明显的速度反差．通过重新定位，得到了6 459次地震的震源参数，这些精确定位的地震震中明显沿该区活动断裂呈现条带状分布，其范围和尺度清晰地表示了这一地区地震活动与活动断裂的紧密关系．其中，82％重新精确定位的事件的震源深度在20 km以内. 这一结果与笔者用双差地震定位法得到的重新定位的震源深度分布相一致．      

多尺度分解在地震信号处理中的应用

利用小波分析中的多尺度分解及信号消噪技术，对记录不清、信噪比小、震相无法辨认的地震信号进行处理。结果表明：多尺度分解在弱震信号提取和弱震相的识别等方面有很好的效果。     

金矿样品的几种溶样方法

通过王水、封闭和烧杯敞口及聚乙烯溶样瓶封闭溶样等方法，对含Au矿样的试样分解、溶样体系及各种溶样方法的对比表明，利用聚乙烯溶样瓶，采用HNO3 NaCl KMnO4 NH4HF2溶样体系，在水浴锅中封闭溶样40min，矿样中的Au即可完全分解。经国家标准物质分析验证，结果与标准值相符。封闭溶样可以避免样品外溢、进溅，使分析结果更准确可靠，降低成本，减少环境污染，适用于大批量样品分析。     

贵州百花湖分层晚期有机质降解过程与溶解N2O循环

百花湖是一个具有季节性分层的富营养小型湖泊,在秋季湖水倒转期经常发生水质恶化事件,碳氮循环出现异常。文章研究特选择在秋初,湖泊分层开始消失时,测定了湖水中不同深度的N₂O,CH₄,CO₂,有机和无机碳同位素以及其他化学参数变化。结果发现:采样时百花湖在约6m和16m深度附近出现了两个温度不连续层(SDL和PDL),并影响到有机颗粒的沉降和分解。相对而言,有较多的有机质在这两个层内发生降解,但降解的途径有所不同,上部主要是有氧降解,下部则主要是无氧降解过程。N₂O的产生和消耗与有机质的降解过程完全对应:PDL层以上,ΔN₂O与AOU的线性关系反映了N₂O主要形成于硝化作用;PDL层以下反硝化作用导致N₂O严重不饱和;PDL内位于硝化作用和反硝化作用过渡带的N₂O峰,显然是硝化与反硝化联合作用的结果。PDL层内较大的CH₄浓度变化梯度,说明嗜甲烷细菌可能通过氧化NH+4贡献了部分N₂O。百花湖秋、冬季表层湖水N₂O都是过饱和的,都是大气N₂O的源,依据分子扩散模型计算湖泊N₂O的释放通量在12～14μmol/m·day之间,秋、冬季没有明显的差别。秋季底层湖水的反硝化作用是湖泊N₂O的汇,其消耗通量与表层的释放通量基本相当。     

山区三维地震勘探大时差静校正及时深转换

山地煤矿采区地形条件复杂，正确进行大时差静校正是处理好二维地震勘探资料的重要一环。大时差静校正会改变煤层反射波时间(t0)及双曲线特征，为减小校正误差，需设立一个CMP面，将校正量分为高频分量和CMP校正量。在地形高差变化剧烈的山地，不能用高于地表面的统一基准面为零线进行时深转换，须进行充填层时差(△t)校正，将统一基准面校正到地表面，再以地表面为零线进行时深转换成图。以便准确无误的展示煤层赋存形态，提高构造图精度。     

Determination of S-wave velocity structure using microtremors and spac method applied in Thessaloniki (Greece)

Array measurements of microtremors at 16 sites in the city of Thessaloniki were performed to estimate the V_s velocity of soil formations for site effect analysis. The spatial autocorrelation method was used to determine phase velocity dispersion curves in the frequency range from 0.8–1.5 to 6–7 Hz. A Rayleigh wave inversion technique (stochastic method) was subsequently applied to determine the Vs profiles at all the examined sites. The determination of V_s profiles reached a depth of 320 m. Comparisons with V_s values from cross-hole tests at the same sites proved the reliability of the SPAC method. The accuracy of the V_s profiles, the ability to reach large penetration depths in densely populated urban areas and its low cost compared to conventional geophysical prospecting, make Mictrotremor Exploration Method very attractive and useful for microzonation and site effects studies. An example of its application for the site characterization in Thessaloniki is presented herein.     

Evaluation of soil liquefaction in the Chi-Chi, Taiwan earthquake using CPT

During the 1999 Chi-Chi, Taiwan earthquake, many sand boiling phenomena were observed in central Taiwan, which caused severe ground settlement and structure damages. According to the installed accelerograms, the peak ground surface horizontal accelerations in the liquefaction-affected areas range from 774.42 to 121.3 gal. The writers carried out an extensive investigation of soil liquefaction in this earthquake. In this paper, we present results of the CPT exploration and post-earthquake liquefaction analysis. Two hundred and seventy five (275) cone penetration test data were collected from the liquefaction-affected areas, and 46 liquefaction case histories and 88 non-liquefaction case histories were derived that can be used to evaluate the accuracy of existing liquefaction evaluation models. In addition, the strength of the liquefied soils after earthquake and the implication of its liquefaction potential in the future event are discussed.     

Analysis of parameters of ground vibration produced from bench blasting at a limestone quarry

The aim of this study is to predict peak particle velocity level at a limestone quarry located in Istanbul, Turkey. The ground vibration components were measured for 73 blast events during the bench blast optimization studies during a long period. In blasting operations; ANFO (blasting agent), gelatine dynamite (priming) and NONEL detonators (firing) were used as explosives at this site. Parameters of scaled distance (charge quantity per delay and the distance between the source and the station) were recorded carefully and the ground vibration components were measured by means of vibration monitors for every event. Then, the data pairs of scaled distance and particle velocity were analyzed. The equation of scaled distance extensively used in the literature was taken into consideration for the prediction of peak particle velocity. At the end of statistical evaluations, an empirical relationship with good correlation was established between peak particle velocity and scale distance for this site. The established relationship and the results of the study are presented.