Experimental investigation of the effects of the coverage of helical strakes on the vortex-induced vibration response of a flexible riser

The effects of different helical strake coverage on the vortex-induced vibration (VIV) of a model flexible riser were studied experimentally, with the aim of further improving the understanding of VIV responses. Uniform and linearly sheared currents were simulated to study response parameters such as non-dimensional displacement, fatigue damage, suppression efficiency, and the comprehensive evaluation is further studied. Test results of the bare model for a uniform current showed that the behavior of both the standing wave and traveling wave dominated VIV displacement. However, for a linearly sheared current, traveling wave behavior dominated VIV displacement in the high-velocity range. The results of the straked model tests indicated that the response was strongly dependent upon the amount of coverage of helical strakes. The flexible riser with 75% strake coverage gave the best comprehensive evaluation in a uniform current, and 50% strake coverage gave the best comprehensive evaluation in a linearly sheared current.     

An Investigation of Digestion Methods for Trace Elements in Bauxite and Their Determination in Ten Bauxite Reference Materials Using Inductively Coupled Plasma‐Mass Spectrometry

Trace elements from samples of bauxite deposits can provide useful information relevant to the exploration of the ore‐forming process. Sample digestion is a fundamental and critical stage in the process of geochemical analysis, which enables the acquisition of accurate trace element data by ICP‐MS. However, the conventional bomb digestion method with HF/HNO₃ results in a significant loss of rare earth elements (REEs) due to the formation of insoluble AlF₃ precipitates during the digestion of bauxite samples. In this study, the digestion capability of the following methods was investigated: (a) ‘Mg‐addition’ bomb digestion, (b) NH₄HF₂ open vessel digestion and (c) NH₄F open vessel digestion. ‘Mg‐addition’ bomb digestion can effectively suppress the formation of AlF₃ and simultaneously ensure the complete decomposition of resistant minerals in bauxite samples. The addition of MgO to the bauxite samples resulted in (Mg + Ca)/Al ratios ≥ 1. However, adding a large amount of MgO leads to significant blank contamination for some transition elements (V, Cr, Ni and Zn). The NH₄HF₂ or NH₄F open vessel digestion methods can also completely digest resistant minerals in bauxite samples in a short period of time (5 hr). Unlike conventional bomb digestion with HF/HNO₃, the white precipitates and the semi‐transparent gels present in the NH₄HF₂ and NH₄F digestion methods could be efficiently dissolved by evaporation with HClO₄. Based on these three optimised digestion methods, thirty‐seven trace elements including REEs in ten bauxite reference materials (RMs) were determined by ICP‐MS. The data obtained showed excellent inter‐method reproducibility (agreement within 5% for REEs). The relative standard deviation (% RSD) for most elements was < 6%. The concentrations of trace elements in the ten bauxite RMs showed agreement with the limited certified (Li, V, Cr, Cu, Zn, Ga, Sr, Zr and Pb) and information values (Co, Ba, Ce and Hf) available. New trace element data for the ten RMs are provided, some of which for the first time.     

Numerical Analysis of Gravity Coring Using Coupled Eulerian-Lagrangian Method and a New Corer

The shortcomings of gravity corers in sampling marine sediments have been observed extensively in various field tests. In order to optimize the coring, this article provides an alternative numerical way to model the gravity coring and analyze the sampling effect. Based on this analysis, a new hydraulic hammer corer is devised. A coupled Eulerian-Lagrangian method with capability of simulating the problem involving extreme deformation, penetration is used to simulate the coring process. The results show that the hydrostatic pressure and deviator stress increase and reach their peak when the pile tip is slightly above or at the level of the observation point and then drop rapidly when the pile tip slides below the observation point. In addition, the stress path indicates that the soil element sustains plastic compression before yielding and then expands until recovering to the original state. The obvious “under-sampling” phenomenon is also well-captured by the finite element model.     

Coupled Dynamic Response Analysis of A Multi-Column Tension-Leg-Type Floating Wind Turbine

This paper presents a coupled dynamic response analysis of a multi-column tension-leg-type floating wind turbine (WindStar TLP system) under normal operation and parked conditions. Wind-only load cases, wave-only load cases and combined wind and wave load cases were analyzed separately for the WindStar TLP system to identify the dominant excitation loads. Comparisons between an NREL offshore 5-MW baseline wind turbine installed on land and the WindStar TLP system were performed. Statistics of selected response variables in specified design load cases (DLCs) were obtained and analyzed. It is found that the proposed WindStar TLP system has small dynamic responses to environmental loads and it thus has almost the same mean generator power output under operating conditions as the land-based system. The tension mooring system has a sufficient safety factor, and the minimum tendon tension is always positive in all selected DLCs. The ratio of ultimate load of the tower base fore-aft bending moment for the WindStar TLP system versus the land-based system can be as high as 1.9 in all of the DLCs considered. These results will help elucidate the dynamic characteristics of the proposed WindStar TLP system, identify the difference in load effect between it and land-based systems, and thus make relevant modifications to the initial design for the WindStar TLP system.     

Development of Prebored Screw Pile Method and Evaluation of Its Bearing Characteristics

The pile-driving method produces considerable noise and vibrations. Hence, an auger-drilled pile method was developed as a low-noise and -vibration substitute. However, this method does not guarantee the bearing capacity of the pile unless some amount of pile-driving is performed. Therefore, the noise and vibration problems cannot be completely solved. In this study, a prebored screw pile method is proposed to solve these problems. In this method, piles are constructed by the rotary penetration of a screw pile into a prebored hole filled with some cement milk and whose diameter is smaller than that of the screw pile. To determine the shape of the screw pile, laboratory tests with model screw piles were conducted. Also, field load tests were conducted on an actual screw pile fabricated based on the laboratory test result and on a smooth-surfaced pile. In addition, the behavior of the screw pile was estimated by using three-dimensional finite element analysis. The results of the field load test and the numerical simulation showed that the ultimate bearing capacity and the unit skin friction of the screw pile are very superior to those of the smooth-surfaced pile and the cement milk is an important factor in the prebored screw pile method.     

深部地质钻探钻柱失效行为分析

国家的“三深一土”规划确定全面开展深地探测,而在深地探测中钻柱是最重要的连接纽带,其长期在充满钻井液的井眼内工作,受力十分复杂,且受腐蚀、磨损、温度等影响,极易发生钻柱失效事故,造成重大经济损失。研究发现,振动是引起钻柱失效的主要原因,但是深部地质钻探中除了振动引起钻柱失效外,还包括钻柱质量因素、人为因素、钻井质量、套管下入因素、测斜因素以及钻井液因素引起的钻柱失效,本文针对这些影响因素提出了对应的预防措施。同时随着地质钻探井深的不断加深,地质钻探钻柱动力学研究会变得越来越重要,这就需要地质钻探人员在充分考虑地质钻探钻柱失效影响因素的前提下,加大对地质钻探钻柱动力学的研究,以更好地保证深部地质钻探的顺利进行。     

Probabilistic calibration of a coupled hydro-mechanical slope stability model with integration of multiple observations

Multiple types of responses, such as displacements, ground water level, pore water pressures, water contents, etc., are usually measured in comprehensive monitoring programmes for rainfall-induced landslide prevention. In this study, a probabilistic calibration method for coupled hydro-mechanical modelling of slope stability is presented with integration of multiple types of measurements. A numerical example of a soil slope under rainfall infiltration is illustrated to compare the effects of single and multiple types of responses on parameter estimation and model calibration. The results show that the soil parameters can be estimated with less uncertainty and total uncertainty bounds are narrower with multiple types of responses than with a single type of response. Model calibration based on multiple types of responses can compromise different responses and hence the means and standard deviations of model error are the smallest. A feasible correlation coefficient between soil modulus and permeability can be obtained from model calibration with multiple types of responses and single type of response as long as the responses include displacement data.     

免共振沉桩过程对地表振动影响的FLAC3D数值模拟

为研究免共振沉桩过程对地表振动影响,采用密度放大法以消除模型桩弹性模量过大对计算效率的影响,在有限差分软件FLAC^3D中建立了相应的连续振动沉桩模型,并和文献中的现场测试结果进行了比较,分析了激振力幅值和振动频率这两个施工参数对地表振动响应的影响。结果表明：密度放大法可有效提高数值模拟的计算效率,模拟沉桩7.0倍桩径（4.9 m）所需计算时间约为12.0 h,数值结果较好地模拟了现场测试中免共振沉桩的地表振动影响;激振力幅值和振动频率均主要对近场（水平距离为5.0倍桩径范围内）的地表振动有明显影响;临界沉桩深度与地表振动影响峰值相对应,该深度随水平距离先增大后趋于稳定;激振力幅值对临界沉桩深度的改变不明显,振动频率对远场临界沉桩深度则有较明显影响。     

搬迁农户生计策略与土地利用行为耦合协调度分析--以贵州省习水县为例

易地扶贫搬迁改变了搬迁农户生计策略,同时影响了其土地利用行为,二者之间的耦合协调度直接影响着农户的可持续生计。本文以贵州省习水县易地搬迁农户调研数据为基础,构建以农户生计策略和土地利用行为为子系统的耦合协调度模型,分析2个子系统之间的耦合关系和耦合协调关系。研究表明:纯农型农户、农兼型农户、兼农型农户生计策略与土地利用行为之间的耦合度值介于0.4~0.5之间,水平较低,处于拮抗状态;不同类型农户生计策略与土地利用行为系统耦合协调度值均处于0.39~0.49之间,处于濒临失调阶段,存在较大优化空间;传统的农业生产形式对于改善农户生计无明显效果,引导农户向专业农业型农户转变对于促进移民安置区“人地系统”协调发展大有裨益。研究结果可为农户生计与土地利用的可持续发展提供理论依据。     

降雨型地质灾害预报方法研究进展

开展降雨型地质灾害预报是减少灾害损失的有效方法。该文在讨论降雨型地质灾害预报相关概念的基础上,结合国内外已有的研究成果,系统总结了隐式统计模型、显式统计模型和动力模型等降雨型地质灾害预报模型的特点和适用条件。近几年区域降雨型地质灾害的预报技术研究有以下新特点:统计模型简单实用,目前已经由单一考虑降雨特征的第1代隐式统计模型,进一步发展为考虑地质、地貌等静态因子的显示统计模型;动力模型逐渐由基于垂直入渗理论的边坡稳定性模型开始向基于水土耦合机制的复杂预报模型发展;降雨型地质灾害业务预报预警的核心是地质灾害预报模型的本地化运行,我国已经基于统计模型搭建了服务于不同区域的业务预报预警系统。结合多源预报降雨资料,搭建基于水土耦合机制的降雨型地质灾害集合预报预警系统是未来可能的发展方向。