董家山隧道小净距段爆破控制的数值模拟

结合都-汶高速公路董家山隧道小净距段的实际情况,应用数值模拟方法,对小净距段在爆破荷载作用下的相互影响问题进行了研究.结果表明在隧道爆破施工中应对迎爆侧进行重点监控,采用合理的开挖和加固方式将有效降低爆破施工对先建隧道的不利影响.研究结论可为类似小净距段隧道的爆破设计、施工及现场监控量测提供参考.     

盾构近距离穿越施工对已运营隧道的扰动影响分析

基于盾构施工对周围土体及构筑物的扰动影响机理,通过实测数据对盾构近距离穿越扰动影响问题进行了定量分析,并讨论了运营隧道对各盾构施工参数的敏感性.研究结果表明盾构穿越对已建地铁隧道的扰动影响主要以隧道的竖向位移为主.随着盾构推进,隧道结构纵向上呈波浪状,其隆起峰值不断沿推进方向移动.盾尾后隧道段受盾构穿越的影响显著,但隆起峰值始终位于盾尾后.     

A Physical and Numerical Investigation on the Stability of Shallow Tunnels in Strain Softening Media

Summary The behaviour up to failure of shallow underground openings is discussed on the basis of some laboratory, small-scale model tests and of finite element simulation. The experimental results are first illustrated. They were obtained from two-dimensional (plane strain) and three-dimensional tunnel models tested under standard gravity conditions. Then, the phenomenon of strain localisation that characterizes the medium surrounding the model tunnels is discussed, recalling two alternative approaches for its numerical interpretation. On this basis, a finite element procedure for strain softening analyses is outlined and applied to the simulation of the tests in both two- and three-dimensional conditions. The comparison between experimental and numerical results leads to some conclusions on the influence of strain localisation on the overall behaviour of shallow tunnels and on the stability of their headings.     

Applicability of a Backprojection Algorithm to Reconstruct Images of Subsurface Horizontal Planes for Laboratory Experiments in Electrical Resistance Tomography

This paper describes the use of a backprojection algorithm to reconstruct subsurface images of the electrical resistivity in horizontal planes parallel to the surface. The algorithm can be applied to detect buried objects such as tanks or pipes and possible leakages from them. Two imaging strategies are compared: juxtaposition of vertical planes, and 3D reconstruction from the sensitivity matrix corresponding to the entire volume whose surface is explored. The electrode arrays used for voltage measurement are the dipole–dipole array and a modified Schlumberger array. A personal computer controls current injection, electrode switching, and voltage detection. The system injects 1 kHz, 20 V peak-to-peak square waveforms, thus avoiding electrode polarization effects. Experimental laboratory measurements show that the algorithm detects localized objects such as an insulating sphere and a conductive cylinder immersed in water. Furthermore, covering half of the cylinder by a rubber sleeve to simulate a nonconductive leak, yields a distinct image for the leak. The backprojection algorithm does not need any regularization parameter and it is very fast in inverting the sensitivity matrix because it approximates the inverse matrix by its transposed. The dipole–dipole array usually yields a lower overall pixel error than the modified Schlumberger array but both allow the detection of simulated underground leaks.     

Effects of temperature and humidity upon the transport of sedimentary particles by wind

Wind tunnel simulations of aeolian transport carried out over a range in mean temperature between 32 °C and ?9 °C suggest that cold airflows support higher mass transport rates (Q) than very warm air. The magnitude of this increase is larger than expected, so that analytical and semi‐empirical models underestimate Q. Extrapolation of the results suggests that, at ?40 °C, as for example in the dry valleys of Antarctica in winter, Q may be as much as 70% higher than for the equivalent wind speed in hot deserts at air temperatures of 40 °C. Temperature‐dependent changes in air density and turbulence contribute to this result. The decreased tension of water adsorbed onto particle surfaces at low temperatures is postulated to reduce interparticle cohesion and, thus, to increase the elasticity of particle impacts on cold beds. Definition of the roles that temperature and humidity play in aeolian transport is relevant to studies of palaeoenvironmental reconstruction and extraterrestrial (or planetary) geology. Investigation of present‐day, cold climate features and of climate change effects also requires knowledge of these fundamental relations.     

Automatic Road Change Detection and GIS Updating from High Spatial Remotely-Sensed Imagery

This paper presents a tramework for road network change detectlon In order to upctate the Canadian National Topographic DataBase (NTDB). The methodology has been developed on the basis of road extraction from IRS-pan images (with a 5.8 m spatial resolution) by using a wavelet approach. The feature matching and conflation techniques are used to road change detection and updating. Elementary experiments have showed that the proposed framework could be used for developing an operational road database updating system.     

GIS数据辅助下的线状目标自动提取

首先介绍了遥感影像中线状目标骨架自动提取的意义和研究现状，然后结合老的GIS数据，提出了一种算法来实现遥感影像中线状目标骨架的自动提取，算法主要包括影像预处理、GIS数据与影像的配准、骨架跟踪、编组连接与数据简化等步骤。最后又利用遥感影像和相应的GIS数据进行了实验，实验证明了算法的可行性和有效性。     

基于典型相关分析的变化检测中变化阈值的确定

以东营市为例 ,把基于典型相关分析的方法运用于多时相遥感影像的变化检测中。对于变化阈值的确定 ,采用了一种基于贝叶斯理论的最小错误率的方法。这种方法实质上是一种非监督分类的方法 ,即不需要地面实况数据或其它先验知识 ,直接对典型相关处理后的差值图像进行分析计算得到阈值 ,使变化检测的错误率达到最小。实验结果证明了这种方法的有效性。     

利用热红外温差识别沙尘

沙尘识别是沙尘灾害监测和沙尘气溶胶特性研究的首要工作。利用辐射传输方程进行了沙尘气溶胶的辐射计算 ,对不同沙尘气溶胶光学厚度下的热红外通道温差ΔT(T11μm-T12 μm)的变化进行了分析。理论分析表明 ,利用热红外通道的温度差ΔT进行陆地沙尘识别是可行的。并利用NOAA AVHRR热红外通道的温度差ΔT进行了陆地沙尘识别的实验 ,经与地面气象站实测的沙尘天气现象相比较 ,结果一致。     

Studies on wind environment around high buildings in urban areas

High buildings or architectural complex in urban areas remarkably distort the urban surface wind fields. As the air flow approaches,local strong wind may appear around the buildings. The strong wind makes the pedestrians on sidewalks, entrances and terrace very uncomfortable and causes the pedestrian level wind environment problem. In this studies, hot-wire wind measurement, wind scouring in wind tunnel and numerical computation were carried out to evaluate the wind environment of tall buildings in the prevailing flow conditions in Beijing areas. The results obtained by three techniques were compared and mutually verified. The conclusions drawn from three approaches agree with each other. Also the advantages and limitations of each method were analyzed. It is suggested that the combination of different techniques may produce better assessment of wind environment around high buildings.