The 3D simulation and optimized management model of groundwater systems based on eco-environmental water demand

Through the study of mutual process between groundwater systems and eco-environmental water demand, the eco-environmental water demand is brought into groundwater systems model as the important water consumption item and unification of groundwater’s economic, environmental and ecological functions were taken into account. Based on eco-environmental water demand at Da’an in Jilin province, a three-dimensional simulation and optimized management model of groundwater systems was established. All water balance components of groundwater systems in 1998 and 1999 were simulated with this model and the best optimal exploitation scheme of groundwater systems in 2000 was determined, so that groundwater resource was efficiently utilized and good economic, ecologic and social benefits were obtained.     

钾-氩和氩-氩定年样品的送样要求及预处理

介绍了K-Ar和Ar-Ar法定年样品的送样要求及实验室预处理程序，样品粒度以250～180μm为宜；用量则视样品的K含量和年龄情况而定，K含量越高、年龄越老，所需样品量越少，多数样品的用量在几十至几百毫克；对于年龄情况不清楚的样品，10～20g手标本或者1～2g合适粒度的样品可以保证用量。全岩样品常受蚀变和捕虏晶的影响，有效的预处理可以在很大程度上消除这些干扰因素。文章还介绍了用稀HNO3消除碳酸盐、1．7mol／L HF消除轻微蚀变的影响以及电磁选剔除捕虏晶的实验过程。     

岩石受压破裂的ULF和LF电磁前兆信号

实验观测到了4类岩性、18块样品在单轴压力下直至破裂发生全过程中的ULF和LF电磁前兆信号。这些不同频率的信号是零散出现的，其形态为一组组脉冲，宽度为4ms～16ms，幅度为0．1mV～1．4mV。实验发现具同一谐振频率的天线收到的信号频次与其相对于裂缝的位置和方位有关。结果还表明，电磁前兆信号的频度与岩样强度有关，抗压强度高的岩样电磁前兆信号多。微破裂可能产生了偶电层，在破裂过程中向外辐射，产生了LF频段的磁信号，ULF磁信号则主要由压磁效应产生。     

Post-emplacement tilting of lava flows inferred from magnetic fabric study: the example of Oligocene lavas in the Jeanne d’Arc Peninsula (Kerguelen Islands)

Statistical analysis of the magnetic fabric of samples from several successive lava flows emplaced under similar conditions can allow determination of the mean flow direction when magnetic fabric data from individual flows do not lead to reliable results. A difference between the obtained flow direction and the present dip direction indicates that the flows were tilted after emplacement. For 2 successive series of flows on the Jeanne d’Arc Peninsula presently NNW dipping, this method shows lava emplacement along a SSW–NNE direction. This indicates a gentle tilting acquired during a period of weak deformation in the whole archipelago. Additionally, the magnetic fabric data allow the reconstruction of the different conditions of emplacement of these two series of lava flows and of formation of the local thick conglomerate interbedded between these series.     

Simplified vibratory characterization of alluvial basins

For the analysis of seismic wave amplification, modal methods are interesting tools to study the modal properties of geological structures. Modal approaches mainly lead to information on such parameters as fundamental frequencies and eigenmodes of alluvial basins. For a specific alluvial deposit in Nice (France), a simplified modal approach involving the Rayleigh method is considered. This approach assumes a set of admissible shape functions for the eigenmodes and allows a fast estimation of the fundamental frequency of the basin. The agreement with other numerical results (Boundary Element Method) and experimental ones is fully satisfactory. The simplified modal method then appears as an efficient mean for the global vibratory characterization of geological structures towards resonance. To cite this article: J.-F. Semblat et al., C. R. Geoscience 335 (2003).     

Magnetic activity inside the auroral zones and field-aligned currents

Big perturbations of the magnetic field (amplitudes larger than 250 nT) are simply detected by subtracting the values of a model from the measurements of CHAMP satellite. Taking a full year of CHAMP data and organizing them in four subsets of three months length (spring, summer, autumn, winter), it is found that: (a) the two domains where such big perturbations mainly exist are limited, in both hemispheres, by a parallel of high latitude of the corrected geomagnetic coordinates system; (b) a conspicuous seasonal (annual) variation affects the density of the perturbations and is opposite in the two hemispheres. We hold that these perturbations are linked to the midday magnetic activity within the auroral zone, long ago described by one of us (Mayaud, 1956). The source of the perturbations observed at the satellite altitude would be field-aligned currents resulting from the penetration of the solar wind into the magnetospheric cusps. To cite this article: J.-L. Le Mouël et al., C. R. Geoscience 335 (2003).     

The anisotropy of magnetic susceptibility in biotite, muscovite and chlorite single crystals

The anisotropy of magnetic susceptibility (AMS) of single crystals of biotite, muscovite and chlorite has been measured in order to provide accurate values of the magnetic anisotropy properties for these common rock-forming minerals. The low-field AMS and the high-field paramagnetic susceptibility are defined. For the high-field values, it is necessary to combine the paramagnetic deviatoric tensor obtained from the high-field torque magnetometer with the paramagnetic bulk susceptibility measured from magnetization curves of the crystals. This leads to the full paramagnetic susceptibility ellipsoid due to the anisotropic distribution of iron cations in the silicate lattice. The ellipsoid of paramagnetic susceptibility, which was obtained for the three phyllosilicates, is highly oblate in shape and the minimum susceptibility direction is subparallel to the crystallographic c-axes. The anisotropy of the susceptibility within the basal plane of the biotite has been evaluated and found to be isotropic within the accuracy of the instrumental measurements. The degree of anisotropy of biotite and chlorite is compatible with previously reported values while for muscovite the smaller than previously published values. The shape of the chlorite AMS ellipsoid for all the samples is near-perfect oblate in contrast with a wide distribution of oblate and prolate values reported in earlier studies. Reliable values are important for deriving models of the magnetic anisotropy where it reflects mineral fabrics and deformation of rocks.     

A mathematical model of concentrate solids content for the wet drum magnetic separator

Low concentrate density from wet drum magnetic separators in dense medium circuits can cause operating difficulties due to inability to obtain the required circulating medium density and, indirectly, high medium solids losses. The literature is almost silent on the processes controlling concentrate density. However, the common name for the region through which concentrate is discharged—the squeeze pan gap—implies that some extrusion process is thought to be at work. There is no model of magnetics recovery in a wet drum magnetic separator, which includes as inputs all significant machine and operating variables.A series of trials, in both factorial experiments and in single variable experiments, was done using a purpose built rig which featured a small industrial scale (700 mm lip length, 900 mm diameter) wet drum magnetic separator. A substantial data set of 191 trials was generated in this work. The results of the factorial experiments were used to identify the variables having a significant effect on magnetics recovery.It is proposed, based both on the experimental observations of the present work and on observations reported in the literature, that the process controlling magnetic separator concentrate density is one of drainage. Such a process should be able to be defined by an initial moisture, a drainage rate and a drainage time, the latter being defined by the volumetric flowrate and the volume within the drainage zone. The magnetics can be characterised by an experimentally derived ultimate drainage moisture. A model based on these concepts and containing adjustable parameters was developed. This model was then fitted to a randomly chosen 80% of the data, and validated by application to the remaining 20%. The model is shown to be a good fit to data over concentrate solids content values from 40% solids to 80% solids and for both magnetite and ferrosilicon feeds.