浅基础水平场地砂土液化危害性评价

分析了《建筑抗震设计规范》中砂土液化危害性评价方法的不足,通过确立液化土层在不同震害模式情况下的液化震陷计算值,建立了以震陷值S为指标的浅基础水平场地地基液化危害性评价等级,得到了其评价程序.     

基于多格网算法的卫星图像恢复

将求解二次椭圆偏微分方程问题的多格网算法应用到卫星影像的恢复中。其基本思想是在将由总变分求极小生成的偏微分方程离散成为差分方程的过程中,采用不同大小的格网。在取得较好恢复结果的同时,提高了传统图像恢复算法的运算效率,降低了恢复运算所需要的时间。     

复合加载模式作用下地基承载性能数值分析

确定竖向荷载(V)、水平荷载(H)和力矩(M)共同作用下建筑物地基的破坏模式及在荷载空间(H,V,M)中的破坏包络面是地基设计中的关键问题。为提高Swipe试验方法计算精度,提出了改进方案,进而利用有限元方法分析了复合加载模式作用下均质粘性土地基上条形基础的破坏包络面。计算表明,基于改进Swipe试验方法的数值模拟结果明显好于常规Swipe试验方法。针对海洋工程中实际复合加载模式的特点,探讨了竖向荷载分量V对地基破坏模式和H-M荷载平面上的破坏包络线的影响,结果表明竖向荷载分量显著地改变了地基的破坏模式及包络线的形状。     

基于声学调制解调器的声速剖面遥测技术

声速是海洋声呐测量中最重要的声学参数之一。拖缆式声速剖面仪可提供实时测量功能,但其缆长不能满足深海测量要求;自容式声速剖面仪可满足深海测量要求,但工作效率低。如何提高野外深海声速剖面测量工作效率是深海调查一项非常有意义的工作。文中详细介绍了基于声学调制解调器的声速剖面遥测系统的主要结构和功能,揭示了水声通信技术在深海非铠装缆测量中的应用优势。     

软弱地基码头的快速建造方法

文中介绍了软基快速建造码头的方法与技术。在含水量高、孔隙比大、渗透系数小、埋藏深厚、承载力与抗剪强度低、灵敏度高的软弱地基上,采用软基快速筑堤方法和鲎式硬壳堤坝技术,22 d时间完成码头建造,投入使用1 a多时间,一直未出现裂缝等问题。     

Unified numerical study of shallow foundation on structured soft clay under unconsolidated and consolidated-undrained loadings

Abstract

Based on a new elasto-plastic constitutive model, this paper presents a soil–water coupled numerical prediction of the bearing capacity for shallow foundation constructed on Ballina soft clay for unconsolidated undrained (UU) and consolidated undrained (CU) conditions. This elasto-plastic constitutive Shanghai model has an advantage of describing the mechanical behaviour of over-consolidated and structured soil under different loading and drainage conditions, by using one set of material parameter. In this paper, the Shanghai model used for both UU and CU conditions has the same initial parameters obtained from laboratory test results. The loading conditions and consolidation stages vary based on construction details. The predicted bearing pressure-settlement responses for UU and CU, approves the field observation. The phenomenon of gaining the bearing capacity due to consolidation is captured and explained by the use of soil–water coupled numerical analysis with a new elasto-plastic model. The stress strain behaviour, stress paths and the decay of the structure of elements at different depths presented in this study, reveal the mechanism for the difference between UU and CU conditions to understand the foundation behaviour. Effect of the initial degree of soil structure on the bearing capacity is also addressed. Overall, this approach provides the integrated solution for the shallow foundation design problems under short and long-term loadings.     

海上风机吸力式桶形基础承载特性研究综述

风机基础作为海上风机整体结构的重要组成部分,承受着上部风机所受到的风浪流荷载,并且对风机的安全性及可靠性至关重要。吸力式桶形基础由于其安装简单和可重复利用等优点,在海洋平台基础中得到了广泛应用,并逐步应用于海上风机基础中。但由于海上风机与海洋平台在海洋环境中的荷载工况有一定的差别,仍需要通过对其承载特性研究现状进行全面认识,以实现吸力式桶形基础在海上风机基础中的可靠应用。文中通过总结和评价现有研究对桶形基础在不同土体条件以及荷载条件下进行试验及数值模拟分析得到的研究结果,综述了静荷载和循环荷载作用下砂土和黏土中的吸力式桶形基础的承载特性研究现状,以及海上风机吸力式桶形基础的相关研究。文章展望了目前应用于海上风机基础的桶形基础仍缺乏的研究,为海上风机吸力式桶形基础的可靠应用及后续研究提供重要参考。     

桩-网路堤位移应力分析及其应用

由于桩-网复合地基的结构形式比较复杂,难以采用解析法求得其应力和位移。利用有限差分法对某桩-网法路堤进行了数值模拟,并取得了较好结果。计算结果显示,桩间土沉降线为悬链线,与现场位移监测结果吻合较好;桩身弯矩和桩土应力反映了桩-网复合地基的一些受力机理。分析认为,桩间土沉降较大的主要原因是由土体本身压缩及桩侧弯引起的。     

软土地基桥台位移病害分析及防治措施

软土地基桥台存在三方面的主要隐患:桥头与路堤具有较大的沉降差;桥台倾斜或桥台底部出现垂直裂缝;桥台向河心移动。软土层地质结构及物理地学性质、桥台形式、勘探与施工质量是影响桥台位移的主要原因。淮安市高等级公路建设的桥梁建设实践表明,应从设计施工、养护方面采取综合防治措施,使损失减到最低限度。     

Effects of long-term cyclic horizontal loading on bucket foundations in saturated loose sand

A 1-g model experimental study was conducted to investigate the accumulated rotations and unloading stiffness of bucket foundations in saturated loose sand. One-way horizontal cyclic loading was applied to model bucket foundations with embedment ratios 0.5 and 1.0. Up to 10⁴ cycles of loading were applied at a frequency of 0.2 Hz varying load amplitudes. The accumulated rotation of the bucket foundations increased with the number of cycles and the load amplitudes. Empirical equations were proposed to describe the accumulated rotation of the foundations. The unloading stiffness of foundations increased with the number of cycles but decreased with an increase in load amplitude. The initial unloading stiffness of L/D = 1.0 (L is skirt length; D is foundation diameter) was approximately twice that of L/D = 0.5. Excess pore water pressure difference of 50% was observed between L/D = 0.5 and 1.0. The suction and static capacity of the bucket increased with increase of bucket embedment ratio with a difference of 69.5% and 73.6% respectively between L/D = 0.5 and 1.0.