Measurements of higher harmonic wave forces on a vertical truncated circular cylinder

Wave forces on a vertical truncated circular cylinder in Stokes waves with the wave slopes ranging from 0.06 to 0.24, are measured in a wave tank. The higher harmonic wave forces are compared with the available values from theories of the FNV (Faltisen–Newman–Vinje) model and Varyani solution. The first harmonic horizontal forces measured are much larger than the theoretical values from the FNV model, while the first harmonic vertical forces are well predicted by the Varyani theory. It was also found that the FNV model significantly overpredicts the second harmonic horizontal forces in high frequency waves, but under predicts the third harmonic forces. The differences between the actual measurement and the theory, in the second and third harmonic horizontal forces, become smaller at low wave frequencies as the wave slope increases. In addition, the transverse instabilities in the incoming waves with high wave slope were observed, which is due to the nonlinear modulation. Measurements were, thus, carried out before the instability occurred.     

Ekman螺线的动力学结构

介绍了Ekman螺线的动力学结构 ,分析研究了风应力及海水内部的动量传递形式 .结果表明 :动量传递方向与海流方向成 45°左偏 .这对于研究海洋内部的动力结构是有意义的 .     

关于拟共形映照Mori常数的注记

讨论拟共形映照的偏差问题，加强关于拟共形映照Ｈｏｌｄｅｒ连续性的Ｍｏｒｉ偏差定理     

A Note on Soil Structure Resistance of Natural Marine Deposits

It has been well documented that natural normally-consolidated marine soils are generally subjected to the effects of soil structure. The interpretation of the resistance of soil structure is an important issue in the theory study and engineering practice of ocean engineering and geotechnical engineering. It is traditionally considered that the resistance of soil structure gradually disappears with increasing stress level when the applied stress is beyond the consolidation yield stress. In this study, however, it is found that this traditional interpretation of the resistance of soil structure can not explain the strength behavior of natural marine deposits with a normally-consolidated stress history A new interpretation of the resistance of soil structure is proposed based on the strength behavior. In the preyield state, the undrained strength of natural marine deposits is composed of two components: one developed by the applied stress and the other developed by the resistance of soil structure. When the applied stress is beyond the consolidation yield stress, the strength behavior is independent of the resistance of soil structure.     

港口靠船桩工作性状计算的双参数法

港口靠船桩是承受重复性荷载或多循环荷载的一种横向承载桩。双参数法能较好地描述靠船桩 (单桩、群桩 )的桩土工作性状。用双参数法进行计算时 ,所给的地面条件必须由重复荷载或多循环荷载作用下实测出来。根据现场试桩资料 ,标定桩土参数 ,即k =mx1/n的指数l/n、桩土相对柔度系数α、桩土综合刚度EI等值 ,可以用来设计试桩附近局部地区同类条件下的其它长桩。对于没有进行试桩的某些工程 ,可以联合运用双参数法和p -y曲线法进行桩的分析     

A dipole mode at thermocline layer in the tropical Indian Ocean

Temperature data at different layers of the past 45 years were studied and we found adiploe mode in the thermocline layer (DMT): anomalously cold sea temperature off the coast of Sumatra and warm sea temperature in the western Indian Ocean. First, we analyzed the temperature and the temperature anomaly (TA) along the equatorial Indian Ocean in different layers. This shows that stronger cold and warm TA signals appeared at subsurface than at the surface in the tropical Indian O-cean. This result shows that there may be a strong dipole mode pattern in the subsurface tropical Indian Ocean. Secondly we used Empirical Orthogonal Functions (EOF) to analyze the TA at thermocline layer. The first EOF pattern was a dipole mode pattern. Finally we analyzed the correlations between DMT and surface tropical dipole mode (SDM), DMT and Nino 3 SSTA, etc. and these correlations are strong.     

A probability distribution for depth-limited extreme wave heights in a sea state

A model for the depth-limited distribution of the highest wave in a sea state is presented. The distribution for the extreme wave height is based on a probability density function (pdf) for depth-limited wave height distribution for individual waves [Méndez, F.J., Losada, I.J., Medina, R. 2004. Transformation model of wave height distribution. Coastal Eng, Vol. 50, 97:115.] and considers the correlation between consecutive waves. The model is validated using field data showing a good representation of the extreme wave heights in the surf zone. Some important statistical wave heights are parameterized obtaining useful expressions that can be used in further calculations.     

Estimating the underwater light field from remote sensing of ocean color

We present a new approach that incorporates two models to estimate the underwater light field from remote sensing of ocean color. The first employs a series of analytical, semi-analytical, and empirical algorithms to retrieve the spectrum of inherent optical properties (IOPs), including the absorption and the backscatter coefficients, from the spectrum of remote sensing reflectance. The second model computes the profile of photosynthetically available radiation E _0,PAR (z) for a vertically homogeneous water column using the information of the retrieved IOPs and the ambient optical environment. This computation is based on an improved look-up table technology that possesses high accuracy, comparable with the full solution of the radiative transfer equation, and meets the computational requirement of remote sensing application. This new approach was validated by in situ measurements and an extensive model-to-model comparison with a wide range of IOPs. We successfully mapped the compensation depth by applying this new approach to process the SeaWiFS imagery. This research suggests that E _0,PAR (z) can be obtained routinely from ocean-color data and may have significant implications for the estimation of global heat and carbon budget.     

Optimization Mathematical Model of Pile Forces for Offshore Piled Breasting Dolphins

An optimization mathematical model of the pile forces for piled breasting dolphins in the open sea under various loading conditions is presented. The optimum layout with the well distributed pile forces and the least number of piles is achieved by the multiplier penalty function method. Several engineering cases have been calculated and compared with the result of the conventional design method. It is shown that the number of piles can be reduced at least by 10%—20% and the piles‘ bearing state is improved greatly.