基于小波变换去除遥感图像非高斯条纹噪音方法探讨

遥感图像的条纹噪音,不但影响图像的判读,而且时图像的后续处理影响较大.利用常规处理软件去噪,在去除条纹的同时,也去除了图像的细节纹理,相当于降低了图像的几何分辨率;使用小波阈值去噪方法,效果欠佳.文章使用小波反阈值方法,不仅去除了图像上的条纹噪音,而且对图像的细节纹理不产生目视效果上的影响,达到了较好的效果.     

The Granada ignimbrite: A compound pyroclastic unit and its relationship with Upper Miocene caldera volcanism in the northern Puna

The Granada ignimbrite, an Upper Miocene volcanic unit from the northern Puna, previously has been interpreted as an extensive ignimbrite (>2300 km²) associated with eruptions from the Vilama caldera (trap-door event). On the basis of new data, we revise its correlation and redefine the unit as a compound, high aspect ratio ignimbrite, erupted at approximately 9.8 Ma. Calculated volumes (100 km³) are only moderate in comparison with other large volume (>1000 km³) ignimbrites that erupted approximately 2–6 m.y. later in the region (e.g. Vilama, Panizos, Atana). Six new volcanic units are recognized from sequences previously correlated with Granada (only one sourced from the same center). Consequently, the area ascribed to the Granada ignimbrite is substantially reduced (630 km²), and links to the Vilama caldera are not supported. Transport directions suggest the volcanic source for the Granada ignimbrite corresponds to vents buried under younger (7.9–5 Ma) volcanic rocks of the Abra Granada volcanic complex. Episodes of caldera collapse at some stage of eruption are likely, though their nature and timing cannot be defined from available data. The eruption of the Granada ignimbrite marks the onset of a phase of large volume (caldera-sourced) volcanism in the northern Puna.     

Geomorphological evolution of the Tilcara alluvial fan (Jujuy Province, NW Argentina): Tectonic implications and palaeoenvironmental considerations

The development and evolution of the Tilcara alluvial fan, in the Quebrada de Humahuaca (Andean Eastern Cordillera, NW Argentina), has been analysed by using geomorphological mapping techniques, sedimentological characterisation of the deposits and OSL chronological methods. It is a complex segmented alluvial fan made up of five evolutionary stages (units Qf1, Qf2, Qf3, Qf4 and Qf5) developed under arid climatic environments as well as compressive tectonic conditions. Segmentation processes, including aggradation/entrenchment cycles and changes in the location of the depositional lobe, are mainly controlled by climatic and/or tectonic changes as well as channel piracy processes in the drainage system. Alluvial fan deposits include debris flows, sheet flows and braided channel facies associated with high water discharge events in an arid environment. The best mean OSL age estimated for stage Qf2 is 84.5 ± 7 ka BP. In addition, a thrust fault affecting these deposits has been recognized and, as a consequence, the compressive tectonics must date from the Upper Pleistocene in this area of the Andean Eastern Cordillera.     

Environmental destruction as a counterinsurgency strategy in the Kurdistan region of Turkey

We examine environmental aspects of the conflict between the Turkish state and the insurgent Kurdistan Workers Party (Partiya Karkerên Kurdistan or PKK). Since the early 1990s, several civil society groups have claimed that the Turkish army burned forests and destroyed other livelihood resources in the Kurdistan region of Turkey as it evacuated settlements. We report the results of a case study of destruction in Tunceli, eastern Turkey, undertaken in order to evaluate support for such claims. We demonstrate the use of geospatial techniques in case-specific approaches to the study of armed conflict. Through the analysis of satellite images, we verified eyewitness reports and confirmed that substantial burnings did indeed take place in the study area between 1991 and 1994. We argue that this destruction was not irrational or wanton, but that it was part of a strategy used by the Turkish army in the early 1990s that aimed at actively transforming the war environment.     

Refinement of Phosphorus Determination in Quartz by LA‐ICP‐MS through Defining New Reference Material Values

The aim of this study was to improve the quality of laser ablation inductively coupled plasma‐mass spectrometry (LA‐ICP‐MS) determination of phosphorus in crystalline quartz. Over the last decade, the Geological Survey of Norway has routinely performed trace element determinations on quartz from both operating and potential quartz deposits by LA‐ICP‐MS. The determined phosphorus concentrations were, with but few exceptions, consistently within the range of 10 to 30 μg g^?1, results that seemed to be both too high and too consistent. The multi‐material calibration curve obtained from a suite of reference materials (NIST SRM 610, 612, 614, 1830, BAM No. 1 amorphous SiO₂ glass) did not define a precise regression line. Published phosphorus concentrations for the reference materials are poorly constrained and the observed dispersions along the multi‐material calibration curve suggest that some of the reference values may be inaccurate. Furthermore, the calibration curve did not pass through the origin of the [(cps ³¹P/cps ³⁰Si) · cone. Si] vs. P concentration diagram; thus, in addition to the uncertainties of the literature values of phosphorus, it is difficult to define the calibration curve. Three reference materials (NIST SRM 614, 1830, synthetic quartz KORTH) were sent for phosphorus accelerator implantation, providing an independent and accurate (± 3%) approach for determining phosphorus concentrations in crystalline quartz. The intrinsic phosphorus concentrations of the three implanted samples plus those for NIST SRM 610 and 612 were determined by secondary ion mass spectrometry (SIMS), yielding new phosphorus values for NIST SRM 610, 612, 614 and 1830. Using these new values resulted in a better defined LA‐ICP‐MS calibration curve. However, the source of the ICP‐MS related background could not be defined, such that it must still be empirically corrected for.     

Mercury,Trace Elements and Organic Constituents in Atmospheric Fine Particulate Matter,Shenandoah National Park,Virginia, USA: A Combined Approach to Sampling and Analysis

Compliance with U.S. air quality regulatory standards for atmospheric fine particulate matter (PM_2.5) is based on meeting average 24 hour (35 μ m^?3) and yearly (15 μg m^?3) mass‐per‐unit‐volume limits, regardless of PM_2.5 composition. Whereas this presents a workable regulatory framework, information on particle composition is needed to assess the fate and transport of PM_2.5 and determine potential environmental/human health impacts. To address these important non‐regulatory issues an integrated approach is generally used that includes (1) field sampling of atmospheric particulate matter on filter media, using a size‐limiting cyclone, or with no particle‐size limitation; and (2) chemical extraction of exposed filters and analysis of separate particulate‐bound fractions for total mercury, trace elements and organic constituents, utilising different USGS laboratories optimised for quantitative analysis of these substances. This combination of sampling and analysis allowed for a more detailed interpretation of PM_2.5 sources and potential effects, compared to measurements of PM_2.5 abundance alone. Results obtained using this combined approach are presented for a 2006 air sampling campaign in Shenandoah National Park (Virginia, USA) to assess sources of atmospheric contaminants and their potential impact on air quality in the Park. PM_2.5 was collected at two sampling sites (Big Meadows and Pinnacles) separated by 13.6 km. At both sites, element concentrations in PM₂₅ were low, consistent with remote or rural locations. However, element/Zr crustal abundance enrichment factors greater than 10, indicating anthropogenic input, were found for Hg, Se, S, Sb, Cd, Pb, Mo, Zn and Cu, listed in decreasing order of enrichment. Principal component analysis showed that four element associations accounted for 84% of the PM_2.5 trace element variation; these associations are interpreted to represent: (1) crustal sources (Al, REE); (2) coal combustion (Se, Sb), (3) metal production and/or mobile sources (Mo, Cd, Pb, Cu, Zn) and (4) a transient marine source (Sr, Mg). Concentrations of Hg in PM_2.5 at background levels in the single pg m^?3 were shown by collection and analysis of PM_2.5 on filters and by an automated speciation analyser set up at the Big Meadows air quality site. The speciation unit revealed periodic elevation of reactive gaseous mercury (RGM) that co‐occurred with peaks in SO₂, indicating an anthropogenic source. GC/MS total ion current chromatograms for the two sites were quite similar indicating that organic signatures were regional in extent and/or that the same compounds were present locally at each site. Calculated carbon preference index values for n‐alkanes indicated that plant waxes rather than anthropogenic sources, were the dominant alkane source. Polycyclic aromatic hydrocarbons (PAHs) were detected, with a predominance of non‐alkylated, and higher molecular weight PAHs in this fraction, suggestive of a combustion source (fossil fuel or forest fires).     

Synchronous deposition of massive sulphide deposits in the Iberian Pyrite Belt: New data from Las Herrerías and La Torerera ore-bodies

Two small to medium sized massive sulphide deposits, Las Herrerías and La Torerera, located in the Iberian Pyrite Belt (IPB) are examined from a geological and palynostratigraphic perspective. The palynological assemblages are assignable to the Retispora lepidophyta–Verrucosisporites nitidus (LN) miospore Biozone (Latest Devonian: Latest Famennian/Strunian) of Western Europe. This age permits correlation with some of the main massive sulphide deposits dated so far in the region (viz., Tharsis, Aznalcóllar, Sotiel-Coronada or Neves-Corvo), and validates once again the hypothesis that a single mineralizing event was responsible for the genesis of most of the IPB’s massive sulphide deposits. The present study confirms that palynostratigraphy is an invaluable high-resolution biostratigraphic tool in the IPB, applicable to dating, correlation and ore-exploration.     

Ductile creep and compaction: A mechanism for transiently increasing fluid pressure in mostly sealed fault zones

A simple cyclic process is proposed to explain why major strike-slip fault zones, including the San Andreas, are weak. Field and laboratory studies suggest that the fluid within fault zones is often mostly sealed from that in the surrounding country rock. Ductile creep driven by the difference between fluid pressure and lithostatic pressure within a fault zone leads to compaction that increases fluid pressure. The increased fluid pressure allows frictional failure in earthquakes at shear tractions far below those required when fluid pressure is hydrostatic. The frictional slip associated with earthquakes creates porosity in the fault zone. The cycle adjusts so that no net porosity is created (if the fault zone remains constant width). The fluid pressure within the fault zone reaches long-term dynamic equilibrium with the (hydrostatic) pressure in the country rock. One-dimensional models of this process lead to repeatable and predictable earthquake cycles. However, even modest complexity, such as two parallel fault splays with different pressure histories, will lead to complicated earthquake cycles. Two-dimensional calculations allowed computation of stress and fluid pressure as a function of depth but had complicated behavior with the unacceptable feature that numerical nodes failed one at a time rather than in large earthquakes. A possible way to remove this unphysical feature from the models would be to include a failure law in which the coefficient of friction increases at first with frictional slip, stabilizing the fault, and then decreases with further slip, destabilizing it.     

The Karlsruhe Dynamo Experiment. A Mean Field Approach

At the Forschungszentrum Karlsruhe an experiment is in preparation which it is hoped, in view of the geodynamo and other cosmic dynamos, that a homogeneous dynamo will be demonstrated and investigated. This experiment is discussed within the framework of mean-field dynamo theory. Results are presented concerning kinematic cylindrical mean-field dynamo models reflecting some features of the experimental device, as well as results of detailed calculations of the -effect that apply to arbitrarily high magnetic Reynolds numbers. On this basis estimates of the excitation conditions of the dynamo are given and predictions concerning the geometrical structure of the generated magnetic fields are made.     

The Preparation of Marine Geological Certified Reference Materials - Polymetallic Nodule GSPN-1 and Marine Sediment GSMS-1 from the Central Pacific Ocean*

This report describes the location, collection, preparation, homogeneity testing, analysis, data-processing and assignment of certified values of a polymetallic nodule (GSPN-1) and marine sediment (GSMS-1). Materials used in the preparation of these reference materials were collected in 1986 and 1987 from the central Pacific Ocean, by the Chinese Ministry of Geology and Mineral Resources (MGMR). A total of fifty one recommended element concentrations and five proposed concentrations are reported for GSPN-1. For GSMS-1, a total of fifty recommended and seven proposed values are presented.