Lithology-derived structure classification from the joint interpretation of magnetotelluric and seismic models

Magnetotelluric and seismic methods provide complementary information about the resistivity and velocity structure of the subsurface on similar scales and resolutions. No global relation, however, exists between these parameters, and correlations are often valid for only a limited target area. Independently derived inverse models from these methods can be combined using a classification approach to map geologic structure. The method employed is based solely on the statistical correlation of physical properties in a joint parameter space and is independent of theoretical or empirical relations linking electrical and seismic parameters. Regions of high correlation (classes) between resistivity and velocity can in turn be mapped back and re-examined in depth section. The spatial distribution of these classes, and the boundaries between them, provide structural information not evident in the individual models. This method is applied to a 10 km long profile crossing the Dead Sea Transform in Jordan. Several prominent classes are identified with specific lithologies in accordance with local geology. An abrupt change in lithology across the fault, together with vertical uplift of the basement suggest the fault is sub-vertical within the upper crust.     

Using radar direct wave for concrete condition assessment: Correlation with electrical resistivity

This paper demonstrates that the direct wave of a radar ground-coupled antenna may be used for the nondestructive assessment of the physical condition of concrete, which directly influences the corrosion of the reinforcing bars in the structure. The validity of this method was evaluated by a comparison with the electrical resistivity method, which is frequently used for the evaluation of corrosion probability. Both methods were implemented in the laboratory on 72 concrete samples (25 × 25 × 8 cm³) with various degrees of saturation and chloride contamination levels. On-site investigations were also carried out on the concrete slab (1080 m²) of a car-park.The results of the laboratory tests show that the radar direct signal is strongly affected by variations in concrete moisture and chloride contamination level. The tests performed in real conditions confirm the good correlation between radar direct wave attenuation and electrical resistivity and, thus, the aptitude of the radar direct wave to detect concrete conditions leading to reinforcement corrosion.     

用综合物探方法对黎川大桥桥基隐伏异常地质体的研究

运用地震反射波法、电阻率剖面法和电阻率测深法的综合勘察，对黎川大桥河西岩桥基的地质稳定性及隐伏异常地质体进行了研究。结果表明：河西岸桥台位置有长英岩脉存在，脉体SW侧比NE侧花岗岩风化更为严重。     

高密度电法在电力工程勘测中的应用

该文通过工程实例，分析了高密度电法在电力工程勘测中的应用前景、应用效果及发展方向。     

高速公路砂井地基固结度时空变化规律探讨

软基固结度时空变化规律的研究对解决高速公路软基沉降预测问题具有十分重要的意义。本文在讨论固结度时空变化的实质与计算方法的基础上，结合京珠高速公路广珠段某软基试验资料，初步探讨了高速公路砂井地基固结度的时空变化规律，特别提出固结的滞后效应及其对固结沉降曲线形态的影响，并简要讨论了砂井直径和间距对固结度的影响，认为软基沉降中地下水微观动力学过程的研究将有助于揭示固结度时空变化规律。     

BP神经网络识别塔北低阻油气层

简要介绍了塔北低阻油气层岩性剖面、低阻油气层地球物理测井曲线特征,分析了塔北地区低阻油气储层成因,重点论述BP人工神经网络识别油气层、油水同层、水层和干层的方法原理。识别实例表明,BP人工神经网络识别低阻油(气)、水层的结果与实际相符,明显地提高了测井的解释精度。     

测井曲线在地层基准面旋回划分中的应用

利用视电阻率测井曲线的周期性对渤南海油田沙三段中上部地层进行地层基准面旋回的划分对比后发现：该旋回界面与地层基准面由上升到下降期间可容纳空间单向增加的极限位置基本一致；地层基准面旋回的划分与测井分析结合可以进行储层。特别是高渗透储层预测。     

供水管井允许出水量的合理确定

每一眼管井在井结构确定的条件下,有一个最大允许出水量,而盲目追求增大出水量,势必造成管井涌砂,过滤管腐蚀和堵塞的加剧。松散含水层供水管井允许出水量既要满足地下水允许开采量“宏观”定义要求,从供水管井使用寿命考虑又要满足管井两个流速参数:井壁允许进水流速和滤管允许进水流速。本文给出了管井允许出水量确定方法和计算框图,并以实例说明之,在具体应用时某些细节也予以了说明。     

钻井成井中机械洗井方法的适用条件与效果

根据多年来从事水文地质钻井成并工作的经验，结合具体工程实例，对活塞、空压机、泥浆泵、清水泵，接力泵等洗井方法的性能和应用条件作了一些总结，但对于井管直径较大或井水较深的管井，采用联合洗井方法往往可以扬长补短，改善单种洗井方法效果不理想的状况，并取得洗井的最佳效果。     

长白山天池火山区电性结构和岩浆系统

在长白山火山区及其附近 ,沿 5条伞状测线和 1条北西向测线进行了 6 1个大地电磁测深点的观测。用Robust等方法对观测资料进行了处理 ;应用阻抗张量分解方法消除了局部不均匀体的影响 ;计算了反映地下横向不均匀性的地磁感应矢量。利用RRI二维自动反演等技术对资料进行了解释。结果表明 :在近地表存在低阻体 ,并分别与长白山天池水体、聚龙泉温泉、锦江温泉及长白山山门附近的地下水相对应。在长白山天池及其以北和以东地区 ,约 12km深处存在电阻率很低的地质体 ,电阻率为 10到几十Ω·m ,可能是地壳岩浆囊。在测区范围内 ,地壳电性结构在南北方向存在着明显的横向变化 ,而东西方向相对均匀 ,变化比较平缓