淮安市典型土动力特性的试验研究

通过对淮安市典型的全新世沉积粉土和粘性土进行室内自振柱试验及粉土的动三轴液化试验，把粉土和粘性土的自振柱试验结果与Seed和Idriss建议的砂土及饱和粘土的剪切模量比G／Gmax-γ曲线和阻尼比λ-γ曲线的变化范围进行对比，结果表明：粉土的剪模量比要比饱和粘土的大，而比砂土的剪模量比要小，其阻尼比接近于砂土的阻尼比；粘性土的剪模量比要比一般饱和粘土的大，而与砂土的剪模量比相近，其阻尼比要比砂土的略低；粉土的抗液化强度与液化振次之间的关系可以用指数函数来表示，其振动孔隙水压力的发展规律可以用反正弦三角函数拟合；粘粒含量是影响淮安市全新世沉积粉土抗液化强度的主要影响因素。     

瑞雷面波在防渗墙无损检测中的应用

瑞雷面波均匀介质理论和弹性层状介质中的频散理论都是在半无限弹性空间基础上进行的，本文通过理论分析将瑞雷面波引申在水平方向宽度有限的墙状介质中应用，结合室内实验和防渗墙施工问题，得出一套完整的无损检测技术，用以控制防渗墙施工质量。     

A Comparative Study of the Atmospheric Layers below First Lifting Condensation Level for Instantaneous Pre-Monsoon Thunderstorm Ocurence at Agartala(23°30′N,91°15′E) and Ranchi(23°14′N,85°14′E) of India

ＡＣｏｍｐａｒａｔｉｖｅＳｔｕｄｙｏｆｔｈｅＡｔｍｏｓｐｈｅｒｉｃＬａｙｅｒｓｂｅｌｏｗＦｉｒｓｔＬｉｆｔｉｎｇＣｏｎｄｅｎｓａｔｉｏｎＬｅｖｅｌｆｏｒＩｎｓｔａｎｔａｎｅｏｕｓＰｒｅ－ＭｏｎｓｏｏｎＴｈｕｎｄｅｒｓｔｏｒｍＯｃｕｒｅｎｃｅａｔＡｇａ...     

新疆南天山环境应力场特征

基于新疆强震固定台和流动观测记录的主要和余震加速度资料，选用了三个分向记录都完整的３７次地震。震级范围为１．８－６．８级，震中距为几至几十公里。根据用位错理论二维断裂力学模式推导的震源峰值、加速度与环境剪应力场关系式计算了新疆南天山环境剪应力值。计算结果表明，新疆南天山环境应力平均值偏高，这与新疆处于特殊构造环境条件有关。     

垂直切变基流中东西向地形对惯性重力波稳定性的影响

利用分层浅水波方程和小参数(WKB)方法，考虑具有垂直切变的基流和地形的作用，求得惯性重力波的局地频率方程，并根据此方程分析讨论了在多种环境条件下波动的稳定性情况。     

西藏聂拉木高喜马拉雅结晶岩系的伸展变形

西藏聂拉木高喜马拉雅结晶岩系在区域上以单一的叶理和单一的拉伸线理占主要地位，其变形带的组构主要反映了透入性的伸展变形；根据显微构造分析表明早期由北往南推覆，晚期由南向北伸展，且晚期表现非常明显。     

五台山西部狐狸山含金韧性剪切带的地球化学研究

狐狸山金矿区，在无蚀变作用参与的韧性变形过程中，岩石化学成分发生了明显的变化。但大多数微量元素含量变化不大，稀土元素配分模式基本不变，它们可以反映原岩的特点。蚀变糜棱岩型矿体与围岩相比，稀土配分模式、亲硫元素Ａｕ、Ａｇ、Ｃｕ和两性元素Ａｓ、Ｓｂ含量差别显著，尤其是Ａｕ含量，前者是后者的百倍～几万倍，金的成矿作用主要与韧性变形后期富金流体的蚀变作用关系密切。     

剪切带的流体－岩石相互作用

作为大陆岩石圈中的应变局部化带，剪切带中一般都渗透着大量流体。流体的来源与剪切带所处的构造背景、流变域和水文条件有关，而剪切带中流体的流动则受岩石的渗透率、孔隙度、孔隙性质、流体的扩散和渗透能力、环境的温压条件、应力或载荷的梯度等因素所制约。剪切带中流体的成分、通量及赋存状态或流动方式，直接影响着岩石的流变。由应变局部化及力学失稳所引起的化学不平衡和由流体与岩石的相互作用，使剪切带岩石的矿物成分和化学成分发生调整，其变异程度取决于原岩的性质、剪切的温压条件和流体的成分及通量等。由于流体的渗透流动和流体与岩石的相互作用使剪切带的体积有所变化，体积变化过程是一种自组织行为。较大的体积亏损，意味着剪切带中渗透过大量的流体，这对剪切带的流变行为、化学行为和成矿作用都有深刻的影响。     

Rare earth and other trace element mobility during mylonitization: a comparison of the Brevard and Hope Valley shear zones in the Appalachian Mountains, USA

In progressing from a granitoid mylonite to an ultramylonite in the Brevard shear zone in North Carolina, Ca and LOI (H₂O) increase, Si, Mg, K, Na, Ba, Sr, Ta, Cs and Th decrease, while changes in Al, Ti, Fe, P, Sc, Rb, REE, Hf, Cr and U are relatively small. A volume loss of 44% is calculated for the Brevard ultramylonite relative to an Al–Ti–Fe isocon. The increase in Ca and LOI is related to a large increase in retrograde epidote and muscovite in the ultramylonite, the decreases in K, Na, Si, Ba and Sr reflect the destruction of feldspars, and the decrease in Mg is related to the destruction of biotite during mylonitization. In an amphibolite facies fault zone separating grey and pink granitic gneisses in the Hope Valley shear zone in New England, compositional similarity suggests the ultramylonite is composed chiefly of the pink gneisses. Utilizing an Al–Ti–Fe isocon for the pink gneisses, Sc, Cr, Hf, Ta, U, Th and M-HREE are relatively unchanged, Si, LOI, K, Mg, Rb, Cs and Ba are enriched, and Ca, Na, P, Sr and LREE are lost during deformation. In contrast to the Brevard mylonite, the Hope Valley mylonite appears to have increased in volume by about 70%, chiefly in response to an introduction of quartz. Chondrite-normalized REE patterns of granitoids from both shear zones are LREE-enriched and have prominent negative Eu anomalies. Although REE increase in abundance in the Brevard ultramylonites (reflecting the volume loss), the shape of the REE pattern remains unchanged. In contrast, REE and especially LREE decrease in abundance with increasing deformation of the Hope Valley gneisses. Mass balance calculations indicate that ≥95% of the REE in the Brevard rocks reside in titanite. In contrast, in the Hope Valley rocks only 15–40% of the REE can be accounted for collectively by titanite, apatite and zircon. Possible sites for the remaining REE are allanite, fluorite or grain boundaries. Loss of LREE from the pink gneisses during deformation may have resulted from decreases in allanite and perhaps apatite or by leaching ofy REE from grain boundaries by fluids moving through the shear zone. Among the element ratios most resistant to change during mylonitization in the Brevard shear zone are La/Yb, Eu/Eu*, Sm/Nd, La/Sc, Th/Sc, Th/Yb, Cr/Th, Th/U and Hf/Ta, whereas the most stable ratios in the Hope Valley shear zone are K/Rb, Rb/Cs, Th/U, Eu/Eu*, Th/Sc, Th/Yb, Sm/Nd, Th/Ta, Hf/Ta and Hf/Yb. However, until more trace element data are available from other shear zones, these ratios should not be used alone to identify protoliths of deformed rocks.     

用扭剪试验成果求剪切模量的计算公式

土的剪切模量是土工计算重要参数之一，通常是用弹性模量与们松比间接求得。本文结合扭转翼板仪的工作原理及其边界条件，推出用扭转力矩M和扭转剪切角θ直接求取剪切模量的计算公式。