表活剂对低渗裂缝性砂岩油藏渗吸驱油效果影响分析

由于低渗裂缝性油藏储集空间物理性质的复杂性和特殊性,渗吸效果控制着低渗透裂缝性油藏水驱开发动态与开发效果,而现场所采用的表面活性剂对渗吸驱油效果的影响将决定着措施成败。在分析油藏渗吸驱油机理基础上,通过对比实验研究,综合分析了不同种类和浓度表活剂对渗吸驱油效果的影响。总体上岩心渗吸驱油效率随表活剂浓度增加而降低,但一定浓度的,能较好的改善岩石表面润湿性的表活剂溶液将有助于渗吸驱油。这一研究为制定低渗裂缝性油藏合理的渗吸注水开发方式提供了理论依据。     

A traversing system to measure bottom boundary layer hydraulic properties

This study describes a new convenient and robust system developed to measure benthic boundary layer properties, with emphasis placed on the determination of bed shear stress and roughness height distribution within estuarine systems by using velocity measurements. This system consisted of a remotely operated motorised traverser that allowed a single ADV to collect data between 0 and 1 m above the bed. As a case study, we applied the proposed traversing system to investigate bottom boundary layer (BBL) hydraulic properties within Coombabah Creek, Queensland, Australia. Four commonly-employed techniques: (1) Log-Profile (LP); (2) Reynolds stress (RS); (3) Turbulent Kinetic Energy (TKE); and (4) Inertial Dissipation (ID) used to estimate bed shear stresses from velocity measurements were compared. Bed shear stresses estimated with these four methods agreed reasonably well; of these, the LP method was found to be most useful and reliable. Additionally, the LP method permits the calculation of roughness height, which the other three methods do not. An average value of bed shear stress of 0.46 N/m², roughness height of 4.3 mm, and drag coefficient of 0.0054 were observed within Coombabah Creek. Results are consistent with that reported for several other silty bed estuaries.     

Fishermen responses on marine protected areas in the Baltic cod fishery

Much of the research that concerns the impacts of management measures in the eastern Baltic cod fishery has focused on fish stock rather than understanding fishermen's attitudes towards regulations. Hence, there is little information available on fishermen's responses although they are the ones whom the regulations affect most profoundly. This study analyses the views of fishermen towards management measures with an emphasis on fishing closures (marine protected areas, MPAs). Swedish log-book data from 1996 to 2005 were used to describe MPA induced fishing effort displacements. Fishermen argued that MPAs have been inefficient in conservation of cod stock. The enlargement of Bornholm MPA in 2005 caused substantial effort displacement towards areas dominated by smaller sized fish. This contributed to the increased discarding of juvenile cod. Enlarged MPAs also intensified competition between different fleet segments and reallocated fishing areas. To reduce fishing mortality, fishermen suggested days-at-sea (effort) regulation and an effective landings control system for all fleets that exploit cod stocks in the Baltic Sea Main Basin. These measures would better motivate fishermen for mutual rule compliance, which is a prerequisite for a sustainable cod fishery.     

Experimental investigation of the vertical pullout cyclic response of bucket foundations in sand

A series of 1 g model tests was conducted to investigate the accumulated vertical pullout displacement and unloading stiffness of bucket foundations embedded in dry and saturated sands. The foundations were subjected to vertical pullout cyclic loading with different load amplitudes. Cyclic load was applied up to 10⁴ cycles. Test results showed that the accumulated vertical pullout displacement increased with the increase in the number of load cycles and cyclic load amplitudes. The unloading stiffness of the bucket foundations decreased with the increase in load amplitude and number of cycles. Empirical equations were proposed based on the test results to evaluate the accumulated vertical pullout displacement and unloading stiffness of the bucket foundations in saturated sand. These equations can be used for the preliminary design of single or tripod bucket foundations.     

Field Study on the Behavior of Destructive and Non-Destructive Piles Under Compression

This paper presents a series of full-scale load tests on long bored piles instrumented with strain gauges along the shafts, including eight field tests of piles loaded to failure and one non-destructive pile load test. The load-displacement response, skin friction, end resistance, and the threshold of the pile-soil relative displacement for fully mobilizing skin resistance were discussed. A simple softening model was proposed to describe the degradation behavior of the skin friction along the pile-soil interface and the load-displacement relationship developed at the pile base. It is found that the shaft resistance degradation investigated in the non-destructive load test only occurs at a shallow depth, and the skin friction of deeper soil is not fully developed. However, unlike the results of the non-destructive load tests, the softening is accompanied by a reduction in skin friction and observed to be along the whole pile depth. The thresholds of pile-soil relative displacement for fully mobilizing skin resistances in different soils have been found to be in the range 0.6% to 2.4% of the pile diameter. Moreover, in practical applications, a bilinear model is assumed to be feasible in analyzing the load-settlement relationship developed at the end of non-destructive pile, whereas the load transmission curve of the soils below the pile base corresponds to a softening model in the field tests of piles loaded to failure.     

Field and Theoretical Analysis on the Response of Destructive Pile Subjected to Tension Load

Most field tests are carried out using working piles for verification purposes in China, and loading tests are terminated before achieving true pile capacity. In this work, two full-scale destructive loading tests on tension piles instrumented with strain gauges were conducted to capture true pile capacity. The load-displacement response, load transfer, and threshold of the pile-soil relative displacement for fully mobilizing skin resistance in the uplift case were discussed. It was found that the shaft resistance degradation is observed to be along the pile depth with a reduction factor of 0.905 to 0.931, and the thresholds of pile-soil relative displacement for fully mobilizing skin resistance of the tension pile in different soils are found to be in the range 0.67% to 1.34% of the pile diameter. Based on the field test results, a simple softening model was proposed to describe the degradation behavior of skin friction along the pile-soil interface. Further study was conducted to assess the influence of the threshold of pile-soil relative displacement for fully mobilizing skin friction and the reduction factor on the skin friction. As to the analysis of the response of single pile subjected to tension load, a highly effective iterative computer program was developed using the proposed skin friction softening model. Comparisons of the load-settlement response for the well-instrumented tests were given to demonstrate the effectiveness and accuracy of the proposed simple method.     

Critical Top Tension for Static Equilibrium Configuration of A Steel Catenary Riser

This paper aims to present the critical top tension for static equilibrium configurations of a steel catenary riser（SCR） by using the finite element method. The critical top tension is the minimum top tension that can maintain the equilibrium of the SCR. If the top tension is smaller than the critical value, the equilibrium of the SCR does not exist. If the top tension is larger than the critical value, there are two possible equilibrium configurations. These two configurations exhibit the nonlinear large displacement. The configuration with the smaller displacement is stable, while the one with larger displacement is unstable. The numerical results show that the increases in the riser＇s vertical distances, horizontal offsets, riser＇s weights, internal flow velocities, and current velocities increase the critical top tensions of the SCR. In addition, the parametric studies are also performed in order to investigate the limit states for the analysis and design of the SCR.     

西北太平洋累积气旋能量的年代际变化

利用1949—2011年CMA-STI热带气旋最佳路径数据集,分析了西北太平洋累积气旋能量(ACE)的年代际变化特征。结果表明,西北太平洋热带气旋(ACE)的年代际变化主要分为1957—1967高值期、1976—1986过渡期和1998—2008低值期。其中强热带风暴(STS)、台风(TY)和超强台风(SuperTY),特别超强台风是决定成分。副热带高压偏弱,垂直风切变偏小,低纬度低空正涡度异常偏东以及低纬度海表面温度(SST)正异常偏东等背景场的年代际特征,有利于形成ACE的年代高值期。     

基于Track分析日本3·11地震对周围IGS站的影响

2011年3月11日日本宫城县(38.322°N,142.369°E)发生Ms9.0级地震,利用日本本岛及周围IGS站的观测数据,采用GPS静态定位、动态差分定位两种方法进行数据处理,计算出了若干站点地震前后的位移量。地壳变形分析结果表明:地震对周围IGS站的位移有不同程度的影响,最大可达到2.46m,所有观测站都向东方向运动,并且计算得出GPS速度场;通过选择较稳定的IGS站作为参考站,计算了2个观测站的动态变形,同时得到了地震波的传播速度。     

台风期间浮标和潜标上ADCP的空间变化、数据误差及校正#br#

基于南海北部浮标和潜标的声学多普勒流速剖面仪（ADCP）数据,通过一套几何算法计算了台风海鸥（1415）期间ADCP的空间变化和流速误差,并进行数据校正。浮标上,台风过后ADCP的水平位移最大可达2.61 km,水平流速误差最大可达0.27 m/s,垂向流速误差最大仅为5×10^-4 m/s;温跃层流速校正值在台风过后显著大于流速测值,这表明水平校正对于温跃层流速的质量控制很重要。潜标上,ADCP最大垂向位移增量为179 m,最大绳子倾角为35°,最大水平位移为1.5 km; ADCP水平流速误差和倾角误差都很小,在数据校正中可忽略不计,但对台风过后中层流速的垂向校正不能忽略。