Three-dimensional model and late stage warping of the Plattengneis Shear Zone in the Eastern Alps

The Plattengneis shear zone is a 250–600 m thick, flat lying, Cretaceous, eclogite facies, mylonitic shear zone, with north-over-south transport direction, that is exposed over almost 1000 km² in the Koralpe region along the eastern margin of the Alps. Although the shear zone is one of the largest in the Alps, its role in the Eoalpine metamorphic evolution and the subsequent exhumation of the region, remain enigmatic and its large-scale geometry is not well understood. The outcrop pattern suggests that the shear zone is made up of a single sheet that is folded into a series of open syn- and antiforms with wavelengths of about 10 km. Eclogite bodies occur above, within and below the shear zone and there is no metamorphic grade change across the shear zone. In the south, the fold axes strike east–west and plunge shallowly to the east. In the north, the fold axes are oriented in north–south direction and form a dome shaped structure of the shear zone. Total shortening during this late stage warping event was of the order of 5%. Indirect evidence constrains this folding event to have occurred between 80 and 50 Ma and the fold geometry implies that the final exhumation in the Koralpe occurred somewhat later than further north. Interestingly, the shear zone appears to strike out of the topography in the south and dip into the topography in the north, so that north of the shear zone only hanging-wall rocks are exposed and south of it only foot-wall rocks. Possibilities for the geometric relationship of the Plattengneis shear zone with the surrounding south dipping detachments are discussed.     

Nature minéralogique et rôle nutritionnel des argiles de sols céréaliers en région subhumide à semi-aride (Tunisie)

The cereal soils of the Northwest of Tunisia derive most of the time, from alluvial deposits or altered remains of carbonated and clayey rocks. Extraction of the clayey fraction permitted to reveal the presence of the following clayey minerals: kaolinite, illite, smectite, chlorite, as well as an illite–smectite interstratified layer, which is present in the deep horizons of the vertisol and in the isohumic soil. The presence of such types of clays shows that the evolution mechanism of soils is weathering of primary minerals inherited from the sedimentary rocks of the Northwest of Tunisia. These clays ensure to soils most of their cationic exchange capacity. Thanks to these clays, which have Ca⁺⁺, Mg⁺⁺ and K⁺ as exchangeable cations, the chemical fertility of these soils is ensured. It may be improved by increasing contents of organic matter, which is naturally few abundant in these soils. To cite this article: H. Ben Hassine, C. R. Geoscience 338 (2006).     

等截面单桩抗拔承载性状试验研究

在基坑中对等截面单桩进行了抗拔静载试验，在桩身设置应变式钢筋计，成功测得桩身各截面的应变数据。分析试验所得数据，对试验抗拔桩抗拔系数的取值、侧摩阻力的发挥、混凝土桩身的开裂等进行了探讨，相应给出了抗拔桩的设计建议。     

Up-temperature flow of surface-derived fluids in the mid-crust: the role of pre-orogenic burial of hydrated fault rocks

The Walter‐Outalpa shear zone in the southern Curnamona Province of NE South Australia is an example of a shear zone that has undergone intensely focused fluid flow and alteration at mid‐crustal depths. Results from this study have demonstrated that the intense deformation and ductile shear zone reactivation, at amphibolite facies conditions of 534 ± 20 °C and 500 ± 82 MPa, that overprint the Proterozoic Willyama Supergroup occurred during the Delamerian Orogeny (c. 500 Ma) (EPMA monazite ages of 501 ± 16 and 491 ± 19 Ma). This is in contrast to the general belief that the majority of basement deformation and alteration in the southern Curnamona Province occurred during the waning stages of the Olarian Orogeny (c. 1610–1580 Ma). These shear zones contain hydrous mineral assemblages that cut wall rocks that have experienced amphibolite facies metamorphism during the Olarian Orogeny. The shear zone rock volumes have much lower δ¹⁸O values (as low as 1‰) than their unsheared counterparts (7–9‰), and calculated fluid δ¹⁸O values (5–8‰) consistent with a surface‐derived fluid source. Hydrous minerals show a decrease in δD_(H2O) from ?14 to ?22‰, for minerals outside the shear zones, to ?28 to ?40‰, for minerals within the shear zones consistent with a contribution from a meteoric source. It is unclear how near‐surface fluids initially under hydrostatic pressure penetrate into the middle crust where fluid pressures approach lithostatic, and where fluid flow is expected to be dominantly upward because of pressure gradients. We propose a mechanism whereby faulting during basin formation associated with the Adelaidean Rift Complex (c. 700 Ma) created broad hydrous zones containing mineral assemblages in equilibrium with surface waters. These panels of fault rock were subsequently buried to depths where the onset of metamorphism begins to dehydrate the fault rock volumes evolving a low δ¹⁸O fluid that is channelled through shear zones related to Delamerian Orogenic activity.     

大变形有限元法分析边坡稳定性

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。     

基于RS和GIS的青藏高原草地生态系统土壤水分保持功能及其经济价值评估——以生长季为例

根据生态系统服务功能理论,利用RS和G IS技术,以土壤含水量为基础因子,对青藏高原区草地生态系统的土壤水分保持功能及其价值的动态变化过程进行有效评价,以直接的货币形式反映出青藏高原主要草地类型的土壤水分保持功能的大小。通过计算和分析发现:(1)由于草地类型分布面积、单位面积保持量的影响,各种类型草地提供的土壤水分保持功能及其价值贡献率有较大差异,按照大小依次为:高寒草原类、高寒草甸类,高寒荒漠类、高寒草甸草原类和温性山地草甸类;(2)草地对土壤水分保持量及其价值呈现出较强的阶段性变化过程;(3)由于各种草地类型所处地理区域不同、草地本身各种自然特点和整体生态功能的不同,青藏高原草地生态系统提供的土壤水分保持功能及其经济价值呈现出明显的地域分布规律:自西北至东南逐渐降低。应该说,由于青藏高原地域、地理和独特气候等原因所致,本文计算得出的青藏高原草地生态系统土壤水分保持功能及其价值的具体数值不一定十分准确,但是能在一定程度上反映出土壤水分保持功能的强大及其在生长季中随时间变化的动态过程和基本规律(这种规律性结论与前人研究结论一致),这是一种在区域尺度上揭示草地生态系统土壤水分保持功能及其价值动态变化过程的方法尝试,这也是对动态评估生态服务功能的一种有益尝试。     

Effect of a submerged bay-mouth breakwater on tsunami behavior analyzed by 2D/3D hybrid model simulation

The hybrid numerical model had been developed to simulate a complicated 3D flow around structures generated by tsunami. In the model, the conventional 2D model is adopted for the wide region far from structures and the 3D non-hydrostatic pressure model is used in the limited region adjacent to structures. The applicability of the model is shown by comparisons of the numerical results with the experimental results of the laboratory model tests and the numerical analysis results of the conventional whole 2D simulation. In addition, the effect of a submerged structure at the opening of a breakwater is discussed from the numerical simulations by the hybrid model. The submerged structure improves the stability of the rubble mound and reduces the tsunami inflow into the bay, while it increases the water surface velocity around the opening of the breakwater. The increase of surface velocity causes the increases of impulsive forces by collision with drafts and so on.     

Water–rock interaction during the process of steam stimulation exploitation of viscous crude oil in Liaohe Shuguang Oil Field, Liaoning, China

In the process of steam stimulation exploitation of viscous crude oil, the injected water, at high temperature and under high pressure, reacts intensively with the host rock. This kind of water–rock interaction in Liaohe Shuguang Oil Field was studied on the basis of analysis of water composition changes, laboratory experiments, mineral saturation indices analysis, and mass balance calculation. Compared with the injected water, the changes of the composition of discharged water are mainly the distinct decrease of pH, Na⁺, SiO₂ and Cl⁻, as well as the increase of K⁺, Ca²⁺, Mg²⁺, SO ₄ ²⁻ and HCO ₃ ⁻ . Laboratory experiments under field conditions showed: the dissolution sequence of minerals quantitatively is quartz>potassium feldspar>albite, and the main change of clay minerals is the conversion of kaolinite to analcime. Mass balance calculation indicated during the process of steam stimulation, large quantities of analcime are precipitated with the dissolution of large amounts of quartz, kaolinite, potassium feldspar, and CO₂. These results correlated very well with the experimental results. The calculated results of Liaohe Shuguang Oil Field showed that during the steam stimulation for viscous crude oil, the amounts of minerals dissolved (precipitated) are huge. To control the clogging of pore spaces of oil reservoirs, increased study of water–rock interaction is needed.     

Assessment of Marine Clay Improvement Under Reclamation Fills by in-situ Testing Methods

In ground improvement projects with prefabricated vertical drains, the duration of the preloading period is set in advance based on the predetermined time rate of consolidation of the compressible layer. If prediction is accurately done, the required degree of consolidation is met at the pre-determined preloading time. As such, there is a requirement for in-situ tests to be carried out just prior to the removal of surcharge to assess the degree of consolidation of the improved ground. In-situ tests were carried out after 23 months of surcharge loading at the In-Situ Test Site within the Changi East Reclamation Project in the Republic of Singapore. In-situ testing works in this research study comprises the use of field vane shear, piezocone, flat dilatometer and self-boring pressuremeter. The in-situ tests were carried out to determine the shear strength and degree of consolidation of the Singapore marine clay at Changi after 23 months of surcharge loading. The In-Situ Test Site consisted of a Vertical Drain Area as well as an untreated Control Area. Both areas were located adjacent to each other and were surcharged simultaneously to the same level and surcharge left in place for a period of 23 months. Comparison was made between the in-situ test results of the Vertical Drain Area and the untreated Control Area.