Reconstructing hydrological variability from testate amoebae analysis in Carpathian peatlands

Peatlands offer the potential for high resolution records of water balance over Holocene timescales, yet this potential is under-exploited in many areas of the world. Within Europe, peatlands are mostly confined to areas north of 55° N, but several areas of southern and eastern Europe contain small peatlands which may be suitable for palaeoclimatic reconstruction. In this paper we test the potential of peatlands in the Carpathian region for deriving quantified estimates of water table changes using testate amoebae analysis. A training set for palaeohydrological reconstruction from testate amoebae assemblages was obtained by collecting surface samples from 13 peatlands, including 9 from Hungary and 4 from Transylvania (Romania). Using a simple measure of mean annual water tables estimated from staining of PVC tape, we found that some peatlands were heavily influenced by runoff and groundwater, and were therefore not suitable as modern analogues of ombrotrophic climatically sensitive sites. The relationship between the testate amoebae assemblages in the modern samples and the environmental variables was explored using CCA. The CCA biplot showed that the most important variables are depth to water table and moisture content, confirming that hydrology is a key control on taxon distribution. pH was a secondary gradient. A transfer function for % moisture and depth to water table was established and applied to fossil assemblages from a sequence from Fenyves-tető, Transylvania, Romania. The reconstructed water table shows a number of variations which have parallels with other palaeoclimatic records from Europe and the North Atlantic prominent phases of higher water tables are associated with the periods 8000–8300 cal BP, 3000–2500 cal BP and after 600 cal BP. We suggest that these were periods of particular intensification of westerly airflow which affected eastern Europe as well as western and central Europe.     

新近沉积粉细砂层地基的试验与评价

通过对邯郸市某车间地基的勘察．分析和探讨了新近沉积粉细砂地层的勘察手段、其物理力学性质，及其利用载荷试验确定承载力的标准取得了较为满意的结果，提出的一些分析方法，对新近沉积的粉细砂地层的勘察具有一定的借鉴作用。     

Site Investigation for the Effects of Vegetation on Ground Stability

The procedure for geotechnical site investigation is well established but little attention is currently given to investigating the potential of vegetation to assist with ground stability. This paper describes how routine investigation procedures may be adapted to consider the effects of the vegetation. It is recommended that the major part of the vegetation investigation is carried out, at relatively low cost, during the preliminary (desk) study phase of the investigation when there is maximum flexibility to take account of findings in the proposed design and construction. The techniques available for investigation of the effects of vegetation are reviewed and references provided for further consideration. As for general geotechnical investigation work, it is important that a balance of effort is maintained in the vegetation investigation between (a) site characterisation (defining and identifying the existing and proposed vegetation to suit the site and ground conditions), (b) testing (in-situ and laboratory testing of the vegetation and root systems to provide design parameters) and (c) modelling (to analyse the vegetation effects).     

非等截面桩超声波成孔质量检测

分析了非等截面超声波成孔质量检测的几个主要影响因素,给出了相应得改进措施。用工程实例说明超声波反射技术是一种保证非等截面桩成孔质量和成桩质量必不可少的检测方法。     

寿阳盆地特深水位成因探讨

寿阳盆地比西部的太原盆地高276m,有“山顶之盆”之称,因地势较高,气候寒冷,又有“冷寿阳”之称.该盆地为新生代断陷盆地,构造条件复杂,具有差异性与继承性的活动特点.其独特的地理条件及地质构造条件,使盆地内奥灰岩溶不断向深处发育,导致岩溶地下水水位埋深达430～550m,具特深水位特征.     

基于VRMap平台上的电子沙盘研制

通过与国内外数字沙盘制作方式及功能的比较，详细介绍了数字沙盘研究方面的一些方法，并以中原油田数字沙盘的研制为例，选择北京灵图公司的VRMap2．3软件作为平台制作中原油田数字沙盘，为油田开发提供基本资料。     

A mathematical hysteretic model for elastomeric isolation bearings

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

Seismic response of self‐centring hysteretic SDOF systems

The seismic response of single‐degree‐of‐freedom (SDOF) systems incorporating flag‐shaped hysteretic structural behaviour, with self‐centring capability, is investigated numerically. For a SDOF system with a given initial period and strength level, the flag‐shaped hysteretic behaviour is fully defined by a post‐yielding stiffness parameter and an energy‐dissipation parameter. A comprehensive parametric study was conducted to determine the influence of these parameters on SDOF structural response, in terms of displacement ductility, absolute acceleration and absorbed energy. This parametric study was conducted using an ensemble of 20 historical earthquake records corresponding to ordinary ground motions having a probability of exceedence of 10% in 50 years, in California. The responses of the flag‐shaped hysteretic SDOF systems are compared against the responses of similar bilinear elasto‐plastic hysteretic SDOF systems. In this study the elasto‐plastic hysteretic SDOF systems are assigned parameters representative of steel moment resisting frames (MRFs) with post‐Northridge welded beam‐to‐column connections. In turn, the flag‐shaped hysteretic SDOF systems are representative of steel MRFs with newly proposed post‐tensioned energy‐dissipating connections. Building structures with initial periods ranging from 0.1 to 2.0s and having various strength levels are considered. It is shown that a flag‐shaped hysteretic SDOF system of equal or lesser strength can always be found to match or better the response of an elasto‐plastic hysteretic SDOF system in terms of displacement ductility and without incurring any residual drift from the seismic event. Copyright © 2002 John Wiley & Sons, Ltd.