A new soil freeze/thaw discriminant algorithm using AMSR‐E passive microwave imagery

The soil freeze–thaw controls the hydrological and carbon cycling and thus affects water and energy exchanges at land surface. This article reported a newly developed algorithm for distinguishing the freeze/thaw status of surface soil. The algorithm was based on information from Advanced Microwave Scanning Radiometer Enhanced (AMSR‐E) which records brightness temperature (Tb) in the afternoon and after midnight. The criteria and discriminant functions were obtained from both radiometer observations and model simulations. First of all, the microwave radiation from freeze–thaw soil was examined by carrying out experimental measurements at 18·7 and 36·5 GHz using a Truck‐mounted Multi‐frequency Microwave Radiometer (TMMR) in the Heihe River of China. The experimental results showed that the soil moisture is a key component that differentiates the microwave radiation behaviours during the freeze–thaw process, and the differences in soil temperature and emissivity between frozen and thawed soils were found to be the most important criteria. Secondly, a combined model was developed to consider the impacts of complex ground surface conditions on the discrimination. The model simulations quite followed the trend of in situ observations with an overall relation coefficient (R) of approximately 0·88. Finally, the ratio of Tb18·7H (horizontally polarized Tb at 18·7 GHz) to Tb36·5V was considered primarily as the quasi‐emissivity, which is more reasonable and explicit in measuring the microwave radiation changes in soil freezing and thawing than the spectral gradient. By combining Tb36·5V to indicate the soil temperature variety, a Fisher linear discrimination analysis was used to establish the discriminant functions. After being corrected by TMMR measurements, the new discriminant algorithm had an overall accuracy of 86% when validated by 4‐cm soil temperature. The multi‐year discriminant results also provided a good agreement with the classification map of frozen ground in China. Copyright © 2011 John Wiley & Sons, Ltd.     

Limiting equilibrium method for slope/drilled shaft system

The use of drilled shafts to stabilize an unstable slope has been a widely accepted practice. There are two basic design and analysis issues involved: one is to determine the global factor of safety of the drilled shafts stabilized slope and the other one is to determine the design earth thrust on the drilled shafts for structural design of the shafts. In this paper, a limiting equilibrium method of slices based solution for calculating global factor of safety (FS) of a slope with the presence of a row of drilled shafts is developed. The arching mechanisms due to the presence of the drilled shafts on slope were taken into account by a load transfer factor. The method for calculating the net force applied to the drilled shaft from the soil mass was also developed. The interrelationships among the drilled shaft location on the slope, the load transfer factor, and the global FS of the slope/shaft system were derived utilizing the developed numerical closed‐form solution. An illustrative example is presented to elucidate the use of the solution in optimizing the location of the drilled shafts on slope to achieve the desired global factor of safety of the slope/shaft system. Copyright © 2009 John Wiley & Sons, Ltd.     

A density‐dependent elastoplastic hydro‐mechanical model for unsaturated compacted soils

This paper presents a three‐dimensional elastoplastic constitutive model for predicting the hydraulic and mechanical behaviour of unsaturated soils. It is based on experimental results obtained from a series of controlled‐suction triaxial tests on unsaturated compacted clay with different initial densities. Hydraulic hysteresis in the water‐retention behaviour is modelled as an elastoplastic process, with the elastic part modelled by a series of scanning curves and the elastoplastic part modelled by the main drying and wetting curves. The effect of void ratio on the water‐retention behaviour is studied using data obtained from controlled‐suction wetting–drying cyclic tests on unsaturated compacted clay with different initial densities. The effect of the degree of saturation on the stress–strain‐strength behaviour and the effect of void ratio on the water‐retention behaviour are considered in the model, as is the effect of suction on the hydraulic and mechanical behaviour. The initial density dependency of the compacted soil behaviour is modelled by experimental relationships between the initial density and the corresponding yield stress and, thereby, between the initial density and the normal compression line. The model is generalized to three‐dimensional stress states by assuming that the shapes of the failure and yield surfaces in the deviatoric stress plane are given by the Matsuoka–Nakai criterion. Model predictions of the stress–strain and water‐retention behaviour are compared with those obtained from triaxial tests with different initial densities under isotropic compression, triaxial compression and triaxial extension, with or without variation in suction. The comparisons indicate that the model accurately predicts the hydraulic and mechanical behaviour of unsaturated compacted soils with different initial densities using the same material constant. Copyright © 2006 John Wiley & Sons, Ltd.     

Importance of footing–soil separation on dynamic stiffness of piled embedded footings

Different phenomena such as soil consolidation, erosion, and scour beneath an embedded footing supported on piles may lead to loss of contact between soil and the pile cap underside. The importance of this separation on the dynamic stiffness and damping of the foundation is assessed in this work. To this end, a numerical parametric analysis in the frequency domain is performed using a rigorous three‐dimensional elastodynamic boundary element–finite element coupling scheme. Dimensionless plots relating dynamic stiffness functions computed with and without separation effects are presented for different pile–soil configurations. Vertical, horizontal and rocking modes of oscillation are analyzed for a wide range of dimensionless frequencies. It is shown that the importance of separation is negligible for frequencies below those for which dynamic pile group effects start to become apparent. Redistribution of stiffness contributions between piles and footing is also addressed. Copyright © 2009 John Wiley & Sons, Ltd.     

Streambank dewatering for increased stability

Streambank erosion is often the dominant source of sediment leaving modified watersheds. Mass failure of high, steep banks is one of the most serious forms of streambank erosion. The risk of a given bank experiencing mass failure is a function of bank height, angle, and soil strength, which is governed by soil moisture. Two methods for bank dewatering were tested in adjacent sections of streambank bordering a deeply incised channel in northern Mississippi: a low‐cost pump system and subsurface horizontal drains. Pore water pressures (both positive and negative pressures, or matric suction) were continuously monitored for 2 years at the pumped site, at an adjacent untreated control section, and for 1 year at the site stabilized with horizontal drains. Resulting data were used to calculate a time series of the factor of safety using a computer model. Over the course of two wet seasons, average bank retreats for the control and pumped plots were 0·43 and 0·21 m, respectively. More limited monitoring revealed that the site with passive drains retreated about 0·23 m. At the pumped site pore water pressure was 3–4 kPa lower than at the control site during the most critical periods. Accordingly, computed factors of safety were above the failure threshold at the pumped site, but fell below unity at the control site on 11 occasions over the period of observation. Similarly, the drained site displayed generally lower pore water pressure and higher safety factors except for two events when drains were evidently overwhelmed with the volume of local surface and subsurface flows. These results suggest, but do not prove, that bank dewatering promoted lower rates of bank retreat and higher levels of stability since the three sites had slight differences in soils, geometry and boundary conditions. Initial cost of the dewatering treatments were significantly less than orthodox bank stabilization measures, but operation and maintenance requirements may be greater. Published in 2009 by John Wiley & Sons, Ltd.     

Composite analytical solutions for a soil vapour extraction system

Soil vapour extraction (SVE) is a common remediation technique for cleaning up unsaturated soils contaminated by volatile organic compounds (VOCs). Analytical solutions, which result from simple mathematical models, can allow the fast approximation of the time‐dependent effluent concentration and the gaining of insight into the processes that take place during soil remediation. Deriving the analytical solutions to advection–dispersion equations that simultaneously take into account the mechanical dispersion and molecular diffusion is very difficult because of the variable dependence of governing equations' coefficients. In this study, we first present two simplified analytical solutions that only consider mechanical dispersion or molecular diffusion. The two developed analytical solutions are compared with the numerical solution that simultaneously considers both mechanical dispersion and molecular diffusion to examine the applicability of the two simplified analytical solutions and distinguishes the individual contribution of the mechanical dispersion and molecular diffusion to total VOCs transport in an SVE system. Results show that dispersion plays an important role during SVE decontamination and neither the diffusion‐dominated solution nor the dispersion‐dominated solution can agree well with the numerical solution when both mechanical dispersion and molecular diffusion have significant contributions to the total VOCs transport flux. A composite analytical solution that linearly couples the diffusion‐ and dispersion‐dominated analytical solutions, which is proposed herein to eliminate the discrepancy between the analytical solutions and the numerical solution. Results indicate that the proposed composite analytical solution agrees well with the numerical solution and is an effective tool for quickly and accurately evaluating the time‐dependent effluent concentration for parameters of the different ranges of interest in an SVE remedial system. Copyright © 2006 John Wiley & Sons, Ltd.     

Managing Soil Erosion Potential by Integrating Digital Elevation Models with the Southern China＇s Revised Universal Soil Loss Equation——A Case Study for the West Lake Scenic Spots Area of Hangzhou, China

In China, many scenic and tourism areas are suffering from the urbanization that results from physical development of tourism projects, leading to the removal of the vegetative cover, the creation of areas impermeable to water, in-stream modifications, and other problems. In this paper, the risk of soil erosion and its ecological risks in the West Lake Scenic Spots （WLSS） area were quantitatively evaluated by integrating the revised universal soil loss equation （RUSLE） with a digital elevation model （DEM） and geographical information system （GIS） software. The standard RUSLE factors were modified to account for local climatic and topographic characteristics reflected in the DEM maps, and for the soil types and vegetation cover types. An interface was created between the Areinfo software and RUSLE so that the level of soil erosion and its ecological risk in the WLSS area could be mapped immediately once the model factors were defined for the area. The results from an analysis using the Areinfo-RUSLE interface showed that the risk value in 93 % of the expanding western part of the WLSS area was moderate or more severe and the soil erosion risk in this area was thus large compared with that in the rest of the area. This paper mainly aimed to increase the awareness of the soil erosion risk in urbanizing areas and suggest that the local governments should consider the probable ecological risk resulting from soil erosion when enlarging and developing tourism areas.     

Substrate selection and seasonal variation in abundance and size composition of isopod Lirceus fontinalis in Ontario streams, Canada

The abundance and size composition of stream isopods Lirceus fontinalis were investigated from April 2001 to August 2002 in 3 streams in southern Ontario, Canada. Effects of current speed was released from the analysis by choosing slow flowing water. The effects of substrate, season and water depth on the abundance, distribution and size composition of the isopods were analyzed. It was found that substrate and season influence isopods the most. The rocky substrate with attached filamentous macro-algae contains an isopod abundance 7.05 times that of bare rock substrate and 14.6 times that of fine-sand and mud substrate. There was a large variation with respect to seasonality in both abundance and size composition of the isopods, with the highest abundance occurring in summer and the lowest in winter and spring; individual isopods also tend to be larger in the winter and spring. In all substrates, shallow areas tend to support higher densities of isopods than deeper areas.     

Lateral flow thresholds for aspen forested hillslopes on the Western Boreal Plain,Alberta, Canada

To predict the long‐term sustainability of water resources on the Boreal Plain region of northern Alberta, it is critical to understand when hillslopes generate runoff and connect with surface waters. The sub‐humid climate (P ≤ ET) and deep glacial sediments of this region result in large available soil storage capacity relative to moisture surpluses or deficits, leading to threshold‐dependent rainfall‐runoff relationships. Rainfall simulation experiments were conducted using large magnitude and high intensity applications to examine the thresholds in precipitation and soil moisture that are necessary to generate lateral flow from hillslope runoff plots representative of Luvisolic soils and an aspen canopy. Two adjacent plots (areas of 2·95 and 3·4 m²) of contrasting antecedent moisture conditions were examined; one had tree root uptake excluded for two months to increase soil moisture content, while the second plot allowed tree uptake over the growing season resulting in drier soils. Vertical flow as drainage and soil moisture storage dominated the water balances of both plots. Greater lateral flow occurred from the plot with higher antecedent moisture content. Results indicate that a minimum of 15–20 mm of rainfall is required to generate lateral flow, and only after the soils have been wetted to a depth of 0·75 m (C‐horizon). The depth and intensity of rainfall events that generated runoff > 1 mm have return periods of 25 years or greater and, when combined with the need for wet antecendent conditions, indicate that lateral flow generation on these hillslopes will occur infrequently. Copyright © 2008 John Wiley & Sons, Ltd.