Impact of climate change on wetland ecosystems: A critical review of experimental wetlands

Climate change is identified as a major threat to wetlands. Altered hydrology and rising temperature can change the biogeochemistry and function of a wetland to the degree that some important services might be turned into disservices. This means that they will, for example, no longer provide a water purification service and adversely they may start to decompose and release nutrients to the surface water. Moreover, a higher rate of decomposition than primary production (photosynthesis) may lead to a shift of their function from being a sink of carbon to a source. This review paper assesses the potential response of natural wetlands (peatlands) and constructed wetlands to climate change in terms of gas emission and nutrients release. In addition, the impact of key climatic factors such as temperature and water availability on wetlands has been reviewed. The authors identified the methodological gaps and weaknesses in the literature and then introduced a new framework for conducting a comprehensive mesocosm experiment to address the existing gaps in literature to support future climate change research on wetland ecosystems. In the future, higher temperatures resulting in drought might shift the role of both constructed wetland and peatland from a sink to a source of carbon. However, higher temperatures accompanied by more precipitation can promote photosynthesis to a degree that might exceed the respiration and maintain the carbon sink role of the wetland. There might be a critical water level at which the wetland can preserve most of its services. In order to find that level, a study of the key factors of climate change and their interactions using an appropriate experimental method is necessary. Some contradictory results of past experiments can be associated with different methodologies, designs, time periods, climates, and natural variability. Hence a long-term simulation of climate change for wetlands according to the proposed framework is recommended. This framework provides relatively more accurate and realistic simulations, valid comparative results, comprehensive understanding and supports coordination between researchers. This can help to find a sustainable management strategy for wetlands to be resilient to climate change.     

Effect of fluid pressure on rock compressive failure in a nearly impermeable crystalline rock: Implication on mechanism of borehole breakouts

We conducted laboratory true triaxial experiments in the nearly impermeable Pohang rhyolite to investigate failure mechanisms under ‘dry’ and ‘wet’ rock conditions. Under ‘dry’ conditions prismatic specimens were jacketed all around to prevent confining fluid penetration. Under ‘wet’ conditions one pair of the specimen faces was left unjacketed and in direct contact with the confining fluid (kerosene) applying the least principal stress in an attempt to simulate the case of an unlined borehole wall. In both testing setups the true triaxial compressive strength for a given least principal stress increases significantly as the intermediate principal stress rises. The unjacketed rhyolite strength is, however, only 60 to 85% of the strength under dry conditions, depending on the magnitude of the intermediate principal stress. In dry rhyolite the failure process begins upon dilatancy onset, followed by microcrack localization, and ending in a steeply dipping shear fracture. On the other hand, brittle fracture in wet specimens occurs almost immediately after the onset of dilatancy by the development of one or more through-going extensile fractures subparallel and adjacent to one of the unjacketed faces, resembling the extensile cracks leading to borehole breakouts in crystalline rocks. We infer that upon dilatancy the confining fluid intrudes and quickly propagates newly opened stress-induced microcracks subparallel to the unjacketed faces, leading to ‘early’ failure.     

镇泾地区延安组底界侵蚀谷地震特征及其与煤层和砂体的关系

鄂尔多斯盆地延长组沉积后期的侵蚀谷发育十分广泛。在盆地西南缘镇泾地区三维地震所做的延10底等t₀图上可以识别出沿NE、NW延伸的主谷和沿NW、NE次谷体系。地震剖面上主谷为宽缓的不对称\     

Sequestration of CO2 in geological media: Criteria and approach for site selection in response to climate change

The well-developed coal electricity generation and coal chemical industries have led to huge carbon dioxide (CO₂) emissions in the northeastern Ordos Basin. The geological storage of CO₂ in saline aquifers is an effective backup way to achieve carbon neutrality. In this case, the potential of saline aquifers for CO₂ storage serves as a critical basis for subsequent geological storage project. This study calculated the technical control capacities of CO₂ of the saline aquifers in the fifth member of the Shiqianfeng Formation (the Qian-5 member) based on the statistical analysis of the logging and the drilling and core data from more than 200 wells in the northeastern Ordos Basin, as well as the sedimentary facies, formation lithology, and saline aquifer development patterns of the Qian-5 member. The results show that (1) the reservoirs of saline aquifers in the Qian-5 member, which comprise distributary channel sand bodies of deltaic plains, feature low porosities and permeabilities; (2) The study area hosts three NNE-directed saline aquifer zones, where saline aquifers generally have a single-layer thickness of 3‒8 m and a cumulative thickness of 8‒24 m; (3) The saline aquifers of the Qian-5 member have a total technical control capacity of CO₂ of 119.25 × 10⁶ t. With the largest scale and the highest technical control capacity (accounting for 61% of the total technical control capacity), the Jinjie-Yulin saline aquifer zone is an important prospect area for the geological storage of CO₂ in the saline aquifers of the Qian-5 member in the study area.     

A scaled experiment for the verification of the SeaBed Logging method

SeaBed Logging (SBL) is an application of the marine controlled source electromagnetic (CSEM) method that is used to directly detect and characterize possible hydrocarbon-bearing prospects. Although the CSEM method has been used by academia for more than three decades, the application as a direct hydrocarbon indicator was first introduced about five years ago. The central idea of SBL is the guiding of electromagnetic energy in thin resistive layers within conductive sediments. Even if it has been well known for a long time that electromagnetic signals can propagate from a conductive region to another via resistive regions such as air or resistive parts of the lithosphere, the application to hydrocarbon exploration has not been developed until recently. This might be due to the uncertainty of getting any significant response from thin resistive layers such as hydrocarbon reservoirs since electromagnetic energy is highly attenuated in conductive sediments. Thus, during the early development phase of the SBL technique, a scaled laboratory experiment was performed to validate if a thin resistive layer (e.g. hydrocarbons) buried within conductive media (e.g. sediments) could be remotely detected by using electric dipoles as sources and receivers. Data from this experiment were compared to a forward modelling code for layered media, and the comparison showed good agreement between experimental and theoretical results. This suggested that thin resistive layers buried in conductive media are detectable due to the guiding of the electromagnetic field within the resistor. The successful results were vital for realizing the application of marine CSEM as a hydrocarbon exploration technique. We here present the results of the first scaled SBL experiment.     

预应力混凝土连续弯箱梁桥动力特性分析与试验研究

通过某预应力混凝土连续弯箱梁桥的有限元分析,并借助脉动试验和跑车试验,对预应力混凝土连续弯箱梁桥的动力特性进行研究.结果表明,该桥自振频率略高于理论计算值,结构动力刚度满足设计要求.为研究弯曲程度对连续弯箱梁桥动力特性的影响,对圆心角从0°到76°的弯桥进行计算,结果表明,随着圆心角的增大,该桥纵向频率逐渐增大,而横向频率逐渐减小.     

Estimation of surface roughness (z0) over a stabilizing coastal dune field based on vegetation and topography

Accurate knowledge of the surface roughness and the resultant wind speed are important for many applications, such as climatic models, wind power meteorology, agriculture and erosion hazards, especially on sand dunes in arid and semi‐arid environments, where vegetation cover is scarce. In this study we aimed at quantifying the effects of vegetation cover and topography on surface roughness over a stabilizing dune field on the southern coast of Israel. Forty‐six wind measurements were made at various distances from the coastline, ranging from 10 to 2800 m, and z₀ values were calculated from the wind measurements based on the ratio between the wind gust and the average wind speed. We estimated vegetation cover using the soil adjusted vegetation index (SAVI) from Landsat satellite images for the upwind sector at various lengths, ranging from 15 to 400 m, and based on digital elevation models and differential GPS field measurements we calculated the topographic variable of the relative heights of the stations. z₀ values were positively correlated with the winter SAVI values (r = 0·87 at an upwind length of 200 m) and negatively correlated with the relative height (r = ?0·68 at an upwind length of 200–400 m for the inland dune stations). Using these variables we were able to create a map of estimated z₀ values having an accuracy of over 64%. Such maps provide a better understanding of the spatial variability in both wind speed and sand movement over coastal dune areas. Copyright © 2007 John Wiley & Sons, Ltd.     

汶上县城区砂土地震液化调查分析

通过钻孔、标准贯入试验等手段,对汶上县城区进行砂土地震液化调查分析。划分砂土液化等级,并给出汶上县城区在Ⅶ度、Ⅷ度时的砂土液化分布图,为城市建设工程抗震设防提供依据。     

Response of a scale-model pile group for a jacket foundation of an offshore wind turbine in liquefiable ground during shaking table tests

To investigate the seismic response of a pile group during liquefaction, shaking table tests on a 1/25 scale model of a 2 × 2 pile group were conducted, which were pilot tests of a test project of a scale-model offshore wind turbine with jacket foundation. A large laminar shear box was utilized as the soil container to prepare a liquefiable sandy ground specimen. The pile group model comprising four slender aluminum piles with their pile heads connected by a rigid frame was designed with similitude considerations focusing on soil–pile interaction. The input motions were 2-Hz sinusoids with various acceleration amplitudes. The excess pore water pressure generation indicated that the upper half of the ground specimen reached initial liquefaction under the 50-gal-amplitude excitation, whereas in the 75-gal-amplitude test, almost entire ground was liquefied. Accelerations in soil, on the movable frames composing the laminar boundary of the shear box, and along the pile showed limited difference at the same elevation before liquefaction. After liquefaction, the soil and the movable-frame accelerations that represented the ground response considerably reduced, whereas both the movable frames and the piles exhibited high-frequency jitters other than 2-Hz sinusoid, and meantime, remarkable phase difference between the responses of the pile group and the ground was observed, all probably due to the substantial degradation of liquefied soil. Axial strains along the pile implied its double-curvature bending behavior, and the accordingly calculated moment declined significantly after liquefaction. These observations demonstrated the interaction between soil and piles during liquefaction.     

Morphological and sedimentary features of sandy-muddy transitional beaches in estuaries and bays along mesotidal to macrotidal coasts

Sandy-muddy transitional beaches (SMT-Beaches), representing the transition from sandy beaches to tidal mudflats, should theoretically develop very different morphological and sedimentological characteristics in river estuaries and in semi-enclosed bays due to their contrasting dynamic sedimentary environments. Evidence, however, is rare in the scientific literature. To reveal these morphological and sedimentary differences, the sand–mud transition (SMT) boundary distribution, beach profiles, and surface and downcore sediment grain-size compositions of 27 SMT-Beaches located along mesotidal to macrotidal coasts of the western Taiwan Strait, southeastern China, were investigated. The results show that typical estuarine SMT-Beaches are mainly characterized by an ambiguous SMT, a long distance between the SMT and the coastline (31–302 m), lower SMT and inflection point altitudes (average –0.76 m and –0.04 m), and lower upper beach gradients (~0.068) with fine sand. Estuarine SMT-Beach sediments display clear interbedded mud and sand layers, implying potential SMT migrations over various timescales. By contrast, typical bay SMT-Beaches are characterized by distinct SMT, a short distance between the SMT and the coastline (11–52 m), higher SMT and inflection point altitudes (~0.24 m and ~0.35 m), and narrower upper beaches with higher gradients (~0.095) and coarse sand. Bay SMT-Beaches present relatively stable sedimentary sequences and a narrow gravel belt surrounding the inflection point and/or SMT. These morphological and sedimentary differences between the two SMT-Beach types are initially constrained by sediment supply and transport and are further affected by tide conditions and wave climate. Sediment supply and transport predominately control the sediment structures, while the tidal range strongly influences spatial variations in SMT distances. Wave climate normally drives SMT altitude variations. This study highlights the morphological and sedimentary differences in SMT-Beaches in estuaries and bays, providing important knowledge for further revealing their morphodynamic processes and potential future nourishment. © 2020 John Wiley & Sons, Ltd.