Numerical simulation of migration–accumulation of oil resources

Numerical simulation of oil migration and accumulation is to describe the history of oil migration and accumulation in basin evolution. It is of great value to the evaluation of oil resources and to the determination of the location and amount of oil deposits. This thesis discusses the characteristics of petroleum geology and permeation fluid mechanics. For the three-dimensional problems of Dongying hollow of Shengli Petroleum Oil Field, it puts forward a new model and a kind of modified method of upwind finite difference fractional steps implicit interactive scheme. For the famous hydraulic experiment of secondary migration–accumulation, the numerical simulation test has been done, and both the computational and experimental results are basically identical. For the actual problem of Dongying hollow, the numerical simulation test and the actual conditions are basically coincident. Thus, the well-known problem has been solved.     

A continuous/discontinuous Galerkin framework for modeling coupled subsurface and surface water flow

We consider conjunctive surface-subsurface flow modeling, where surface water flow is described by the shallow water equations and ground water flow by Richards’ equation for the vadose zone. Coupling between the models is based on the continuity of flux and water pressure. Numerical approximation of the coupled model using the framework of discontinuous Galerkin (DG) methods is formulated. In the subsurface, the local discontinuous Galerkin (LDG) method is used to approximate ground water velocity and hydraulic head; a DG method is also used to approximate surface water velocity and elevation. This approach allows for a weak coupling of the models and the use of different approximating spaces and/or meshes within each regime. A simplified LDG method based on continuous approximations to water head is also described. Numerical results that investigate physical and numerical aspects of surface–subsurface flow modeling are presented. This work was supported by National Science Foundation grant DMS-0411413.     

A spectrophotometric measurement of soil cation exchange capacity based on cobaltihexamine chloride absorbance

Among numerous methods for cation exchange capacity (CEC) determination for soils and sediments, the cobaltihexamine chloride method is frequently used due to its ability to measure CEC at soil pH. After exchange with Co(NH₃)₆³⁺ ions, CEC is estimated via the measurement of the Co remaining in solution. The modified method proposed allows a more rapid determination of CEC based on the measurement of the absorbance at 472 nm of the cobaltihexamine chloride solution before and after exchange. This method has been applied to various soil's horizons from four sites, selected to cover a wide range of CEC and pH values. The model obtained allows one to calculate CEC from absorbance at 472 nm with 95% confidence intervals. As CEC is of relevant meaning in agronomical and environmental purposes, and more recently in ecotoxicological studies, this modified method can be proposed as a rapid test for CEC evaluation.     

基于蒙特卡罗法的多级黄土滑坡可靠性分析

滑坡稳定性分析目前工程中一般采用极限平衡算法。为了确定滑坡的稳定性系数,在计算过程中要将岩土体、计算模型简化,忽略一些影响滑坡稳定的次要因素,把影响滑坡稳定的各种主要因素作为确定参数。由于滑坡岩土体本身的非均质性及其参数确定具有随机性和变异性,用唯一的稳定系数不能客观地反映整个滑坡的真实安全程度。以陕西省夏呀河滑坡为例,通过野外详细调查、工程勘探和室内土工试验,初步确定该滑坡存在四级滑动面,难以用简单的单一滑动面计算其稳定性。因此,先采用推力传递系数法对滑坡体上的四级滑坡分别进行滑坡稳定性计算,得到该滑坡体上的四级滑坡稳定系数。再采用蒙特卡罗法对该四级滑坡进行可靠性分析,得到其可靠度,定量地表达夏呀河四级滑坡的安全程度。同时对比分析夏呀河四级滑坡的稳定系数和失稳概率,综合评价该滑坡体上的四级滑坡的稳定性及其风险概率,为滑坡的工程治理及预测预警、灾害危险性评价提供依据。     

利用DInSAR和GPS综合方法估计地表3维形变速率

在分析基于贝叶斯统计和马尔科夫随机场理论的解析优化法的基础上,提出以GPS提供的高精度的水平形变速率作为约束,利用直接分解法,将DInSAR的斜距向形变速率分解成垂直形变速率。试验结果表明,直接分解法有效地综合了GPS的高水平精度与DInSAR的高垂直精度优点,且计算简单,克服了解析优化法可能出现的数值不稳定问题。     

人工边坡潜在滑动面研究——以广州科学城某人工高边坡为例

运用强度参数的改变对边坡破坏面形迹影响不明显这一特点,在数值模拟过程中通过改变岩体强度参数,有效地获取潜在滑动面的位置和形态,较好地解决了滑动面搜索的难题。将该法应用于广州科学城某人工高边坡稳定性的研究,在三维数值模拟过程中,将强度参数大幅度折减,计算后获得各剖面的剪应变增量图,从这些图中可获得潜在滑动面。这与人们通常将此类边坡的中风化面作为滑动面存在较大差别。将该滑动面运用极限平衡法进行计算,计算结果显示各剖面的安全系数基本都大于1.2,边坡稳定但仍需要加固处理,与三维数值模拟结果相一致。由此认为用这种分析法确定出的潜在滑动面合理、计算结果可靠,可作为搜索边坡潜在滑动面并计算安全系数的方法之一。     

电容测试法判断测井电缆系统故障

测井电缆因长途颠簸、拉伸及绞车缠绕挤压,电缆连接器、电缆、绞车滑环、滑环连线等部位极易出现故障。电容测试法是一种简易、快速的检测方法,该法可在现场准确诊断出故障电缆的位置。以四芯铠装电缆为例,每根缆芯的正常阻值约为80Ω/1 000m,两缆芯间的分布电容约为170PPF/1 000m。在实际检测中,根据电容较小时测点的位置,可以有效判断故障部位;而电缆故障位置则可利用电阻及电容的线性关系进行计算予以确定。     

测井仪器的故障分析与排除思路

TYSC-3Q与PSJ-2型数字测井仪是目前煤田测井中常用的二种测井仪器,在使用过程中难免发生诸如测井控制故障、声速探管故障、密度三侧向探管故障、井温、井液电阻率探管故障、电法面板故障、数字测井面板故障、电测井故障等常见故障类型。通过对各类故障因素进行剖析,指出了故障易发生的部位,并详细的介绍了检查的方法及故障的排除步骤。     

贵州糯东井田水文地质条件分析

通过对井田内泉和暗河流量的调查研究,认为永宁镇组一、三段碳酸盐岩裂隙溶洞水为井田的主要含水层,含水层主要接受大气降水及河流的渗透补给;煤层上覆地层飞仙关组为相对隔水层,厚度大于500m,下覆无强含水层,其地下水对煤层的开采影响不大,井田水文地质条件较简单。采用比拟法对井田的涌水量进行了预算,推算该矿井开采设计涌水量为13 238m^3/d。