The Mw = 6.0, 7 September 1999 Athens Earthquake

On 7 September 1999 at 11:56 GMT a destructive earthquake (M_w = 6.0) occurred close to Athens (Greece). The rupture process is examined using data from the Cornet local permanent network, as well as teleseismic recordings. Data recorded by a temporary seismological network were analyzed to study the aftershock sequence. The mainshock was relocated at 38.105°N, 23.565°E, about 20 km northwest of Athens. Four foreshocks were also relocated close to the mainshock. The modeling of teleseismic P and SH waves provides a well-constrained focal mechanism of the mainshock (strike = 105°, dip = 55° and rake = -80°) at a depth of 8 km and a seismic moment M₀ = 1.010²⁵ dyn·cm. The obtained fault plane solution represents normal faulting indicating an almost north-south extension. More than 3500 aftershocks were located, 1813 of which present RMS < 0.1 s and ERH, ERZ < 1.0 km. Two main clusters were distinguished, while the depth distribution is concentrated between 2 and 11 km. Over 1000 fault plane solutions of aftershocks were constrained, the majority of which also correspond to N–S extension. No surface breaks were observed but the fault plane solution of the mainshock is in agreement with the tectonics of the area and with the focal mechanisms obtained by aftershocks. The hypocenter of the mainshock is located on the deep western edge of the fault plane. The relocated epicenter coincides with the fringe that represents the highest deformation observed on the differential interferometric image. The calculated source duration is 5 sec, while the estimated dimensions of the fault are 15 km length and 10 km width. The source process is characterized by unilateral eastward rupture propagation, towards the city of Athens. An evident stop phase observed in the recordings of the Cornet local stations is interpreted as a barrier caused by the Aegaleo Mountain.     

A method to predict the group fissuring and faulting caused by regional groundwater decline

Ground fissuring is a recurrent problem in many countries where water extraction surpasses the natural recharge of aquifers. Due to differential settlement, the soil layer undergoes deformation and cracks with serious consequences for civil infrastructure. Here, we propose an approximate analysis of the fissuring process that can be used to predict the location of cracks, which increasingly affect some middle- and large-sized cities in the world. For that purpose, the ground loss theory is applied to sediments overlying a sinusoidal-shaped graben. This analysis shows the existence of a tensile zone at the border of the graben with maximal values on its shoulder where tension cracks are more likely to appear. It also shows that soil deformation under differential settlement may evolve into ground faulting if water withdrawal continues. Finally, when a crack has completely developed, the tensile zone shifts towards the center of the graben, creating a new area for potential cracking and faulting.     

Crack damage stress as a composite function of porosity and elastic matrix stiffness in dolomites and limestones

Twenty-five uniaxial compression tests were performed to determine stress at onset of dilation, referred to herein as “the crack damage stress,” in heterogeneous dolomites and limestones. A simplified model for crack damage stress (σ_cd) is developed here using porosity, elastic modulus, Poisson's ratio and three empirical coefficients. The model shows that when porosity decreases and elastic modulus increases, σ_cd rapidly increases and approaches its maximum value. On the other hand, when porosity increases and elastic modulus decreases, σ_cd rapidly decreases and approaches its minimum value. The proposed model is validated for six heterogeneous limestone and dolomite formations which are widely distributed in Israel.     

井水位气压效率b值动态响应的断层-前兆场主应力组合模式

统计鲁03，04井流水作业闰的气压效率b值发现，在华北及其周缘绝大多数地震前两井前兆异常形态各异，经分析井孔定位断层走向与地震前兆场主应力的组合模式不同是产生上述现象的根本原因。     

半无限空间中圆形孔洞周围SH波的散射

建立了求解在含有圆形孔洞的弹性半空间中SH波散射与圆形孔洞附近动应力集中问题的解析方法。利用SH波散射的对称性和多极坐标的方法，构造了一个可以预先满足半空间自由表面上应力自由边界条件的圆形孔洞对SH波散射的波函数。利用这一波函数，则可将该问题转化成对一个圆形孔洞散射的求解问题。该问题的解答最终又可归结为对一组无究代数方程组的求解问题，并可利用截断有限项的方法对其进行计算，最后给出了有关圆形也洞附近动应力集中问题的算例和数值结果，并讨论了波数与圆孔至自由边界距离变化对动应力集中的影响。     

圆弧状沉积盆地与软土单覆盖层出平面地表运动对比

采用解析方法，通过圆弧状沉积盆地与同样参数的软土均匀单覆盖层的对比，研究沉积盆地对平面SH波二维散射效应和其出平面地表运动。数值对比结果表明：（1）波垂直入射时盆地中央地表位移幅值反应，其随频率变化形式与软土单覆盖层的地表运动有较强的对应性，且此时单覆盖层地表位移幅值为其下降；（2）盆地的二维散射效应特点显著波的汇聚作用使盆地中的地表运动显著放大，总体上较软土单覆盖层的地表位移幅值要大，其频域内的最大反应则明显大于单覆盖层情况，但最大反应在盆地表面出现的位置依赖于入射波角度、盆地深宽比和盆地的软硬程度；（3）沉积盆地中地表位移运动有强烈扭转效应，且随盆地变软和入射波频率增高而增强。     

昆仑山口西8.1级地震前青海省形变及地温前兆特征分析

通过对青海省地倾斜、地应力、深井地温3种前兆手段在昆仑山口西8．1级地震前异常的分析与研究，得出了强地震远场前兆的一些初步特征，并与近场前兆异常特征做了比较，这对该省今后强震短期预报将是有益的。     

2-D viscoelastic FEM simulation on stress state in the deep part of a subducted slab

Introduction It is found that there are some relationships between the thermal structures of subduction zones and the deep seismicity, while the mechanism relates the thermal structure and the deep seismicity is still unsure (Helffrich, Brodholt, 1991; Furukawa, 1994; Kirby, et al, 1996). From 1980s, geoscientists have constituted a series of numerical simulations on the stress states of subduction slabs. Based on the kinetic computation of Sung and Burns (1976a, b), Goto, et al (1983, 1987…     

A comparison of tectonic ambient shear stress value in China with that in western USA

Introduction The stress status of the earths crust is closely related to global structure, the direction of plate movement, the drive mechanism of plate, earthquake cause, etc. Therefore the researches of the stress status of the earths crust and the process of dynamic evolution are paid a great attention to by many people around the world (Zoback, Zoback, 1980; Zoback, et al, 1989; Zoback, 1989; Spence, 1997; Fuchs, 1997; Plenefish, Bonjer, 1997; Muller, et al, 1997; XU, et al, 1989; WAN…     

Principal axes of m-DOF structures PartⅠ:Static loading

This paper is the first in a two-part series that discusses the principal axes of M-DOF structures subjected to static and dynamic loads. The primary purpose of this series is to understand the magnitude of the dynamic response of structures to enable better design of structures and control modification devices/systems. Under idealized design conditions, the structural responses are obtained by using single direction input ground motions in the direction of the intended control devices/systems,and by assuming that the responses of the structure is decoupleable in three mutually perpendicular directions. This standard practice has been applied to both new and retrofitted structures using various seismic protective systems. Very limited information is available on the effects of neglecting the impact of directional couplings (cross effects - of which torsion is a component) of the dynamic response of structures. In order to quantify such effects, it is necessary to examine the principal axes of structures under both static and dynamic loading.This first paper deals with quantitative definitions of principal axes and "cross effects" of three-dimensional structures under static load by using linear algebra. It shows theoretically that, for three-dimensional structures, such principal axes rarely exist. Under static loading conditions, the cross effect is typically small and negligible from the viewpoint of engineering applications. However, it provides the theoretical base for subsequent quantification of the response couplings under dynamic loads, which is reported in part Ⅱ of this series.