Parametric study on performance of bridge retrofitted by unseating prevention devices

1 Introduction Structural retro?t techniques (Roberts, 2005), such as restrainers, concrete shear keys, steel jackets, CFRPshells, base isolators, or dampers have been widely studied and implemented in actual structures based on the experiences learned from past earthquakes. In the Chi-Chi earthquake (EERI, 2001), the damage to simply-supported PCI girder bridges provided a different view from which to examine the function of a rubber bearing system for simply- supported bridges (NCREE,…     

An evaluation of force-based design vs. direct displacement-based design of jointed precast post-tensioned wall systems

The unique features of jointed post-tensioned wall systems, which include minimum structural damage and re-centering capability when subjected to earthquake lateral loads, are the result of using unbonded post-tensioning to attach the walls to the foundation, along with employing energy dissipating shear connectors between the walls. Using acceptance criteria defined in terms of inter-story drift, residual drift, and floor acceleration, this study presents a multiplelevel performance-based seismic evaluation of two five-story unbonded post-tensioned jointed precast wall systems. The design and analysis of these two wall systems, established as the direct displacement-based and force-based solutions for a prototype building used in the PREcast Seismic Structural Systems （PRESSS） program, were performed at 60% scale so that the analysis model could be validated using the PRESSS test data. Both buildings satisfied the performance criteria at four levels of earthquake motions although the design base shear of the direct displacement-based jointed wall system was 50% of that demanded by the force-based design method. The study also investigated the feasibility of controlling the maximum transient inter-story drift in a jointed wall system by increasing the number of energy dissipating shear connectors between the walls but without significantly affecting its re-centering capability.     

一种基于GA-BP-MC神经网络的高铁桥墩沉降预测模型

提出一种基于马尔科夫链修正的遗传BP神经网络预测模型（GA-BP-MC）,利用遗传算法的全局寻优能力初始化BP神经网络权值和阈值,初步建立GA-BP神经网络预测模型,结合马尔科夫链的无后效性修正模型预测值,形成高精度GA-BP-MC神经网络变形预测模型。结合高铁桥墩沉降数据,分别与BP神经网络、GA-BP神经网络预测模型进行对比,结果表明,该预测模型精度最高。     

大跨径斜拉桥主梁线形测控新方法研究及应用

大跨径斜拉桥结构刚度小、变形大,为保证主梁顺利合龙,施工过程必须快速精确定位主梁上各个节段的平面和竖向线形。区别于传统的极坐标主梁平面线形测控方法,本文提出采用全站仪自由设站法测控主梁平面线形;同时区别于传统的水准测量方法,提出采用全站仪间接高差传递的方法测控主梁竖向线形。介绍了两种新方法的测量原理,通过工程实例论证了新方法的可行性和实用性,且能够大幅度提高测控效率,可为其他大跨径桥梁主梁线形的测控提供一定的参考。     

大气折光系数测定及在悬索桥基准索股线形测量中的应用

大跨度悬索桥基准索股跨中位置处于百米高空,如何测得精确的垂度值,对主缆线形进行控制至关重要。本文分析了影响悬索桥基准索股垂度测量精度的主要因素,提出了基于实时大气折光系数改正的单向三角高程的跨中垂度测量新方法。在桥址区建立高精度的高差基准,通过对桥址区的大气折光系数的测定及改正试验,证明该测量方法切实可行。基准索股跨中垂度采用双测站进行测量,当双测站所测同一点绝对垂度互差小于10 mm时,取双测站所测垂度均值作为该点的垂度值。该方法的测量结果达到设计精度要求,对同类工程测量项目有借鉴意义。     

Effects of wave directionality on extreme response for a long end-anchored floating bridge

Reliable design codes are of great importance when constructing new civil engineering concepts such as floating bridges. Previously only a scarce number of floating bridges have been built in rough wave conditions and only limited knowledge of the extreme environmental conditions and the associated extreme response exists. To form a better design basis an increased understanding of the sensitivity in the structural response towards changes in short-crested sea parameters is needed. Furthermore, acquiring the necessary accuracy in simulated extreme response is often a computationally expensive endeavour and the number of simulations needed is often based on experience. The present study investigates the wave-induced short-term extreme response of a simplified end-anchored floating bridge concept for several wave environments with a return period of 100 years. The study includes convergence of the coefficient of variation for the extreme response for different realization lengths as well as number of realizations. The sensitivity in the structural response towards different main wave directions and spreading exponents is investigated and includes both transverse and vertical displacement response spectra and extreme Von Mises stress in the bridge girder cross-section. The extreme response is based on an accuracy of 2% in the coefficient of variation equivalent to 40 3-h realizations and a low sensitivity in the response is found for natural occurring spreading exponents and for main wave directions within 15° from beam sea.     

桥梁施工高程控制网精度及跨河水准观测设计

分析了水中桥墩施工允许误差,推导了桥梁施工高程控制网的必要精度,研究并设计了不同跨河长度下的桥梁高程控制测量等级和跨河水准测量的测回数及组数,研究成果可供相关规范修订时借鉴。     

桥梁工程跨河水准测量设计与实践

系统地分析和总结桥梁工程跨河水准测量的基本理论、方法和技术要点,对各种跨河水准测量方法的适用条件及其优缺点进行分析比较。最后,以某特大型桥梁工程的三角高程跨河水准测量为例进行了验证。     

跨海大桥建设对胶州湾北部冬季结冰现象的影响

本文利用台站观测、卫星遥感以及专项调查等多种数据,综合分析了近年来胶州湾典型水文气象要素的变化特征及建桥前后水动力环境等的变化对冬季冰情的影响。结果显示,建桥以来冰情较重的年份冬季气温和年最低气温均处于近30年的低位,重冰期与年最低气温时段相吻合,且以跨海大桥为界,北部海湾结冰现象严重,而南部几乎无结冰。基于区域海洋水动力模型(ECOM)的模拟结果显示,跨海大桥建设可以从几个方面影响胶州湾北部海冰的生消,即大桥建设使胶州湾尤其是大桥北侧的水动力环境弱化,落潮时桥北侧水体堆积,涨潮时桥北侧向陆一侧水位减小;大桥对桥位南北1.5 km周围涨、落潮流场产生影响;流场的变化又使得悬浮物对流扩散和沉积物输运发生改变,大桥北侧局部区域水深变浅。     

Analytical investigations of seismic responses for reinforced concrete bridge columns subjected to strong near-fault ground motion

Strong near-fault ground motion, usually caused by the fault-rupture and characterized by a pulse-like velocity- wave form, often causes dramatic instantaneous seismic energy (Jadhav and Jangid 2006). Some reinforced concrete (RC) bridge columns, even those built according to ductile design principles, were damaged in the 1999 Chi-Chi earthquake. Thus, it is very important to evaluate the seismic response of a RC bridge column to improve its seismic design and prevent future damage. Nonlinear time history analysis using step-by-step integration is capable of tracing the dynamic response of a structure during the entire vibration period and is able to accommodate the pulsing wave form. However, the accuracy of the numerical results is very sensitive to the modeling of the nonlinear load-deformation relationship of the structural member. FEMA 273 and ATC-40 provide the modeling parameters for structural nonlinear analyses of RC beams and RC columns. They use three parameters to define the plastic rotation angles and a residual strength ratio to describe the nonlinear load- deformation relationship of an RC member. Structural nonlinear analyses are performed based on these parameters. This method provides a convenient way to obtain the nonlinear seismic responses of RC structures. However, the accuracy of the numerical solutions might be further improved. For this purpose, results from a previous study on modeling of the static pushover analyses for RC bridge columns (Sung et al. 2005) is adopted for the nonlinear time history analysis presented herein to evaluate the structural responses excited by a near-fault ground motion. To ensure the reliability of this approach, the numerical results were compared to experimental results. The results confirm that the proposed approach is valid.