大跨径钢管混凝土拱桥减震控制装置参数的研究

大跨度桥梁结构的减震控制研究对于桥梁结构的抗震安全具有重要意义。本文以主跨368m的茅草街大桥为研究对象,基于ANSYS建立了该桥的三维有限元模型,并采用子空间迭代法分析了该桥的动力特性。在此基础上进行了大跨度钢管混凝土拱桥的地震响应及减震控制研究,重点进行了弹性连接装置和粘滞阻尼器减震效果的参数敏感性分析,并对比分析了不同位置布设减震装置时的效果。结果表明,纵飘振型对该桥肋纵向相对位移的贡献最大;弹性连接装置和阻尼器均能有效减小地震作用下该桥的肋梁纵向相对位移;综合考虑各关键部位的地震响应时,同时采用两类减震装置并将其分散布置时的减震效果最佳。结论可供大跨度中承式钢管混凝土系杆拱桥的抗震设计参考。     

多国钢结构抗火规范关于受弯构件计算方法的比较与分析

为了研究受弯构件的抗火性能,及对国内外目前的受弯构件抗火设计方法有一个系统的了解,介绍了中国、美国、欧洲、英国和澳大利亚的钢结构抗火设计规范关于受弯构件的计算方法,并对它们的区别和联系进行了分析。设计了一个算例,分别采用不同的规范计算了其临界温度和耐火极限。经对比分析表明:各国规范的计算结果差别较大,相同条件下,澳大利亚规范计算得出的临界温度较低;无防火保护层时,英国规范计算得出的耐火极限较高,而有保护层时,美国规范计算得出的耐火极限较低。     

钢管混凝土叠合边框内藏钢板-钢桁架双肢剪力墙抗震研究

在大连国际会议中心核心筒墙体抗震设计中,采用了一种钢管混凝土叠合边框墙肢内藏钢板、连梁内藏钢桁架的组合双肢剪力墙。为研究其抗震性能,进行了1个1/7缩尺的这种新型组合双肢剪力墙模型的低周反复荷载试验,分析了其承载力、延性、刚度及其退化、滞回特性、耗能能力和破坏特征,重点研究了钢管混凝土叠合边框、墙肢内藏钢板、连梁内藏钢桁架之间的共同工作性能。研究表明:内藏钢板-钢桁架可显著提高钢管混凝土叠合边框双肢剪力墙的承载力和延性性能;钢管混凝土叠合边框可充分发挥其承载力高、不易开裂、延性好的优势。文中提出了该新型组合双肢剪力墙的承载力计算模型,计算结果与实测结果符合较好。     

Mechanical and low-cycle fatigue behavior of stainless reinforcing steel for earthquake engineering applications

Use of stainless reinforcing steel (SRS) in reinforced concrete (RC) structures is a promising solution to corrosion issues. However, for SRS to be used in seismic applications, several mechanical properties need to be investigated. These include specified and actual yield strengths, tensile strengths, uniform elongations and low-cycle fatigue behavior. Three types of SRSs (Talley S24100, Talley 316LN and Talley 2205) were tested and the results are reported in this paper. They were compared with the properties of A706 carbon reinforcing steel (RS), which is typical for seismic applications, and MMFX II, which is a high strength, corrosion resistant RS. Low-cycle fatigue tests of the RS coupons were conducted under strain control with constant amplitude to obtain strain life models of the steels. Test results show that the SRSs have slightly lower moduli of elasticity, higher uniform elongations before necking, and better low-cycle fatigue performance than A706 and MMFX II. All five types of RSs tested satisfy the requirements of the ACI 318 code on the lower limit of the tensile to yield strength ratio. Except Talley 2205, the other four types of RSs investigated meet the ACI 318 requirement that the actual yield strength does not exceed the specified yield strength by more than 18 ksi (124 MPa). Among the three types of SRSs tested, Talley S24100 possesses the highest uniform elongation before necking, and the best low-cycle fatigue performance.     

Preliminary investigation of seismic damage to two steel space structures during the 2013 Lushan earthquake

Severe damage to steel space structures is rarely reported when compared to other structural systems damaged during past major earthquakes around the world.Two gymnasiums of steel space structures in downtown Lushan County that were damaged during the 2013 M7.0 Lushan earthquake in China were investigated and the observations are summarized in this paper.Typical damage to these two steel space structures ranges from moderate to severe.Moderate damage includes global buckling and dislocation of bolted connections of truss members,and inelastic elongation of anchor bolts and sliding of pedestal plates of supports.Severe damage includes member fracture caused by local buckling,and fracture failure of anchor bolts and welds.The distribution of structural damage to these two structures is described in detail and future research opportunities are suggested.     

钢管高强混凝土叠合柱的抗震性能研究

通过周期性往复试验,研究了钢管高混凝土叠合柱柱的破坏形态,耗能能力、延性、承载力以及各种组成部分共同工作等内容,并与钢管高强混凝土核心柱进行了对比;随后通过计算,讨论了叠合柱中有关参数对其极限承载力和影响;最后给出了叠合柱正截面极限承载力的简化计算方法。     

钢框架结构的非线性静力抗震可靠性分析 II:可靠度指标及其灵敏度

将有限元反应及其灵敏度分析与结构可靠度分析的近似解析方法结合起来,可以进行具有隐式功能函数的大型复杂结构的可靠性分析。在基于位移的非线性纤维梁柱单元及其灵敏度直接微分表达式的基础上,通过力学变换、概率变换和反应灵敏度,将结构可靠度计算方法FORM和SORM与有限元方法有机地集成在一起。依据现行抗震设计规范,建立了钢框架结构典型构件承载能力和结构层间变形能力的抗震极限状态方程,利用地震作用的等效随机静力模型,采用非线性有限元静力可靠度方法,对一实际工程结构的抗震可靠度及其灵敏度进行了概率分析和评价,结果表明:尽管在大震作用下该结构的层间弹塑性变形可靠度较高,但是构件极限承载能力的可靠度指标较低,仍然存在失效的可能性。因此,仅验算"小震"作用下结构的承载能力可靠度和"大震"作用下结构的变形能力可靠度是不够的,还需要验算在"中震"和"大震"作用下结构的极限承载能力可靠度。     

安徽两次中等地震发震断层参数测定

根据地震波传播过程中的多普勒效应。利用拐角频率的方向变化,用最小二乘法反演了2005年寿县ML4．1级、2006定远ML4.7级地震的发震断层参数。结果表明,反演得到的中等地震的发震断层参数与震中附近实际断层的参数基本一致,破裂速度均小于S波的速度,且破裂长度为0．2-0．3km。     

Parametric study of ductile moment‐resisting steel frames: A first step towards Eurocode 8 calibration

A parametric study of 13 608 ductile moment‐resisting steel frames designed according to Eurocodes 3 and 8 is performed. A flowchart for the evaluation of the seismic‐resistant capacity of the designed frames is developed based on the N2 method. The design structural overstrength, ductility supply, plastic redistribution parameter, supply reduction factor and performance ratio of the frames are analysed. We determine that the frames have performance ratios higher than 1, mostly due to high values of design structural overstrength, showing that the seismic supply produced by the restraints of Eurocodes 3 and 8 is always higher than the seismic demand. Copyright © 2008 John Wiley & Sons, Ltd.     

圆形空心钢管混凝土柱的耐火性能实验研究

关于实心钢管混凝土的耐火性能已有大量的实验研究,而空心钢管混凝土的耐火实验目前还非常少见。针对这一不足,对空心钢管混凝土进行了耐火实验研究,其中考虑了不同的空心率,并对中空注水对构件耐火性能的影响也进行了实验研究。实验结果表明：在相同的荷栽比下,构件的耐火时间随空心率先增大后减小。当空心率较小时,中空注水对构件耐火时间的提高作用不明显;当空心率较大时,注水对耐火时间的提高才体现出来。