三峡工程大江截流的水文技术

鉴于三峡工程大江截流水深大，流量大，工期紧，特别是截流过程中要考虑不断航因素，因此，在大江截流和二期围堰阶段的施工进程中，应充分考虑到各方面的因素，尽可能采取一切减少大江截流和二期围堰施工难度的手段和措施，其中水文测验，水文气象预报，河道观测，水文分析与计算和水力学计算等水文工作则是为顺利实施高质量大江截流的重要条件。     

遥感技术在化工环境保护中的应用

遥感技术获取的可见光、红外及微波信息，可以对化工企业及化学矿山环境污染（水、粉尘、大气、废渣污染等）及环境地质灾害（滑坡、泥石流、地面塌陷等）进行实时动态监测，并可获得较高的社会经济效益，达到地面环保及常规环境地质工作难以达到的效果。特别是对重点大中型化工企业及化学矿山建立环境遥感信息动态监测系统，可以为国家决策部门及时准确地提供环境治理和改造的依据。     

岩质边坡设计坡角和锚固方案的确定

本文运用赤平极射投影、块体理论和岩体力学的基本原理, 试探求一种可供边坡工程设计采用的确定人工岩质边坡最大安全设计坡角和锚固方案的简易方法。     

测氡法快速确定油气田边界及深度

本介绍了运用测氡法快速确定大庆××油气田边界，估算其埋藏深度试验，结果表明，该方法具有可行性和实用性。由于所做工作有限，尚属经验性探讨，还必须从理论和实践上进一步地工作，进而充实、完善它。     

用扭剪试验成果求剪切模量的计算公式

土的剪切模量是土工计算重要参数之一，通常是用弹性模量与们松比间接求得。本文结合扭转翼板仪的工作原理及其边界条件，推出用扭转力矩M和扭转剪切角θ直接求取剪切模量的计算公式。     

ADVANCES IN MEASURING TECHNIQUES OF BED LOAD

I.m~UCrIONBedloadisthesedimentwhichmovesalongtheriverbedintheformofrolling,slidingandsaltation.BedloadmaycreatemanyproblemsintheoperationandmaintenanceofnavigationchannelandinthedevelOPmentofhydroelectricity.Dataofbedloaddischargearealsorequiredinthedesignofreservoir,inwhichtheinflowbedloadareallactuallytrapped.Thewaysofbedloadmotionaredifferentfordifferentsizes.Thus,itisextremelydifficulttodeterminethebedloaddischargeaccurately.Manyequationshavebeenproposedtocalculatethebedloaddischarge.H…     

氡射气测量在西安地裂缝勘察中的应用研究

为了避免大量开挖揭露工作量, 加快地裂缝的勘察速度, 研究出一种简便易行的探测方法是目前西安地裂缝勘察中迫切需要解决的问题。本文研究了氡射气测量在西安地裂缝勘察应用的地质基础, 结合近十几年工程勘察实践, 讨论了氡射气异常的特征, 分析了氡射气的探测效果, 结果认为:氡射气测量在西安地裂缝探测中的有效率为:８０％左右。     

山西地堑系的最新水平运动

利用山西断裂带布设的GPS监测网的6期复测资料(1996—2001),分析了山西断陷带的水平运动特征。结果表明,整体呈现逆时针的差异活动,主压应力场的方位角为72°,断裂两侧不存在明显的走滑运动。2001年的运动显示,代县附近是差异活动的分界区段。     

Influence of the zone of weakness on dip angle and shear heating of subducted slabs

We study the importance of the zones of weakness and the pattern of downgoing flow in steady-state models of subducting lithosphere, which interacts mechanically and thermally with the ambient mantle. The non-linear system of governing equations consists of (i) the momentum equation in stream function formulation and (ii) the steady-state heat transfer equation including conduction and advection of heat and dissipation. A finite element method has been applied to this system. We consider the viscosity to be a non-linear function of both the temperature and the stream function. In steady-state two-dimensional (2D) flow, the stream function isolines follow material trajectories. They are used to follow the top of the subducting slab, which because of its possible increase in water content, is assumed to have a lower viscosity. The zone of weakness has been thus obtained in the self-consistent fashion since the stream function as well as the temperature are the output from our modeling and no a priori assumptions about the shape of the bending lithosphere are taken into account. It was shown that several orders decrease of viscosity in the zone of weakness is required to obtain the dip angle of about 45°. If the decrease of viscosity is not sufficient enough, the subducted slab either sinks almost vertically or does not exhibit a plate-like behavior. We have also demonstrated that shear heating can unrealistically increase at the zone of weakness for fast subductions if decrease of viscosity is underestimated.     

Measurement of the spatial distribution of fluvial bedload transport velocity in both sand and gravel

Maps are presented of the spatial distribution of two‐dimensional bedload transport velocity vectors. Bedload velocity data were collected using the bottom tracking feature of an acoustic Doppler current pro?ler (aDcp) in both a gravel‐bed reach and a sand‐bed reach of Fraser River, British Columbia. Block‐averaged bedload velocity vectors, and bedload velocity vectors interpolated onto a uniform grid, revealed coherent patterns in the bedload velocity distribution. Concurrent Helley‐Smith bedload sampling in the sand‐bed reach corroborated the trends observed in the bedload velocity map. Contemporaneous 2D vector maps of near‐bed water velocity (velocity in bins centered between 25 cm and 50 cm from the bottom) and depth‐averaged water velocity were also generated from the aDcp data. Using a vector correlation coef?cient, which is independent of the choice of coordinate system, the bedload velocity distribution was signi?cantly correlated to the near‐bed and depth‐averaged water velocity distributions. The bedload velocity distribution also compared favorably with variations in depth and estimates of the spatial distribution of shear stress. Published in 2004 by John Wiley & Sons, Ltd.