Motive force of Qinghai-Tibet Plateau moving to east

A calculation formula on spherical pattern of Qinghai-Tibet plateau moving model is established. Tibet massif moves norward by east in speed of 28 mm/a, Ganshu-Qinghai massif moves to northeast in speed of 15 mm/a, Qomolangma Feng moves northward by a few east in speed of 35 ～42 mm/a. The low latitude perimeter is longer than the nigh latitude perimeter. When the Tibet massif moves northward, its latitude perimeter must be contracted and the Tibet massif must move eastward by Coriolis. Coriolis force is inertial in earth rotation. It makes the fall body turning to east and the rising block turning westward. In the Northern Hemisphere, it makes the northward body turning to east and the southward block turning to west.This is the reason why the tectonic zones of western Pacific are different from those of eastern Pacific.     

大气垂直折射与时序垂直角值的谱分析

本文介绍了对时序垂直角观测值进行谱分析的方法和所得到的结论。使以往对于大气折射影响及其变化规律的定性认识得以定量化。     

Numerical modeling for analyzing thermal surface anomalies induced by underground coal fires

Coal seams burning underneath the surface are recognized all over the world and have drawn increasing public attention in the past years. Frequently, such fires are analyzed by detecting anomalies like increased exhaust gas concentrations and soil temperatures at the surface. A proper analysis presumes the understanding of involved processes, which determine the spatial distribution and dynamic behavior of the anomalies.In this paper, we explain the relevance of mechanical and energy transport processes with respect to the occurrence of temperature anomalies at the surface. Two approaches are presented, aiming to obtain insight into the underground coal fire situation: In-situ temperature mapping and numerical simulation. In 2000 to 2005, annual temperature mapping in the Wuda (Inner Mongolia, PR China) coal fire area showed that most thermal anomalies on the surface are closely related to fractures, where hot exhaust gases from the coal fire are released. Those fractures develop due to rock mechanical failure after volume reduction in the seams. The measured signals at the surface are therefore strongly affected by mechanical processes.More insight into causes and effects of involved energy transport processes is obtained by numerical simulation of the dynamic behavior of coal fires. Simulations show the inter-relation between release and transport of thermal energy in and around underground coal fires. Our simulation results show a time delay between the coal fire propagation and the observed appearance of the surface temperature signal. Additionally, the overall energy flux away from the burning coal seam into the surrounding bedrock is about 30-times higher than the flux through the surface. This is of particular importance for an estimation of the energy released based on surface temperature measurements. Finally, the simulation results also prove that a fire propagation rate estimated from the interpretation of surface anomalies can differ from the actual rate in the seam.     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

存储式岩心定向取心技术应用研究

采用岩心定向取心技术不仅可以迅速而方便地确定地下矿层和结构面的产状,而且还可以判断矿层的走向,了解地层倾向,预测钻孔弯曲的趋势。介绍了存储式岩心定向取心原理、关键技术问题、器具构成、技术参数以及现场应用情况。     

低围压水平下砂的排水行为(英文)

采用干样沉降法制备样品 ,选用静三轴仪对松砂和密砂样在 10 k Pa至 10 0 k Pa的低围压下的排水行为进行了实验研究 ,并对实验结果作了橡皮膜校正 ,在围压为 10 k Pa的密砂实验中 ,轴向应力的校正值可达到 12 %。实验研究表明低围压下松砂的剪胀性非常明显 ,且存在剪应力极值 ;围压越低 ,松砂和密砂的剪应力极值越小 ,达到最大剪应力所对应的剪应变越小。同时还表明低围压范围内相对密度不同 ,砂的应力应变特性不同 ;此外 ,低围压下砂的内摩擦角高于高围压下的值 ,从而在工程上应重视低围压水平下砂土工程参数的合理选取     

Model Test Study of Dynamic Ice Force on Compliant Conical Structures

To study ice-induced vibration of a compliant conical structure,a series of model tests were performed from 2004 to 2005.In the tests,the ice sheet before the compliant conical structure was found to fail in two-time breaking.From 2005 to 2006,this type of ice failure was studied through more groups of tests.The tests show that two-time breaking is the typical failure of ice before steep conical structures,and is controlled by other factors at the same time,such as ice speed and the angle of the cone.     

Artificial Upwelling of Deep Seawater Using the Perpetual Salt Fountain for Cultivation of Ocean Desert

Deep seawater in the ocean contains a great deal of nutrients. Stommel et al. have proposed the notion of a “perpetual salt fountain” (Stommel et al., 1956). They noted the possibility of a permanent upwelling of deep seawater with no additional external energy source. If we can cause deep seawater to upwell extensively, we can achieve an ocean farm. We have succeeded in measuring the upwelling velocity by an experiment in the Mariana Trench area using a special measurement system. A 0.3 m diameter, 280 m long soft pipe made of PVC sheet was used in the experiment. The measured data, a verification experiment, and numerical simulation results, gave an estimate of upwelling velocity of 212 m/day. This revised version was published online in July 2006 with corrections to the Cover Date.     

基于规则波波形的超声波非接触测量有关问题探讨

波浪波形的非接触测量近年来获得广泛的应用。本文以规则波为讨论对象，针对介质为空气的超声波测量方式进行波形测量误差分析，并结合实验室和实船试验进行对比分析。理论分析表明：在规则波取为坦谷波和ＳＴＯＫＥＳ波的前提下，超声波技术几乎产生相同的最大误差。定量分析表明，在对测量精度限制的条件下，对文中提及的各项参数应作有效的控制