Rotation Center and Horizontal Bearing Capacity of the Bucket Foundation in Soft Ground

In the last 20 years, the bucket foundation has been developed as a new type of offshore platform structure. Because of its short period of application to engineering practices, the theoretical decision on the rotation center and horizontal bearing capacity of the bucket foundation has yet to be agreed. A limit analysis method is used to determine the updated rotation center position and horizontal bearing capacity to evaluate the failure mechanisms of the bucket foundations. The results are compared with numerical simulation and experiments, and also with other theoretical methods. The proposed method can satisfactorily consider the engineering conditions and the result is accurate in determining the rotation center and horizontal bearing capacity.     

应用两次展开法求解系泊柱体慢漂运动方程

在深海中系泊的海洋平台,如Spar平台,水下部分为带有系泊的圆柱结构,其水平方向运动响应往往具有较低的自振频率,容易在低频波浪力(源于非线性的差频效应)作用下发生共振响应,使结构发生大幅水平慢漂。当浮体的瞬时位置大幅偏离初始位置时,基于初始平衡位置的摄动展开法会存在较大误差。针对这一问题,采用两次展开方法,对大幅慢漂运动开展时域模拟研究。对双色波作用下自由漂浮圆柱的大幅运动响应问题进行数值分析,并与采用基于初始平衡位置的摄动展开法的计算结果进行了对比。结果表明,采用新的两次展开法可以计算出波浪遭遇频率的变化和波浪漂移阻尼,而这无法从基于初始平衡位置的常规摄动展开法中得到,体现了两次展开法在分析大幅慢漂问题上的优势。     

基于半数值方法的限弯器剪弯刚度分析

柔性管缆限弯器存在接触非线性导致剪弯刚度分析困难。为此先基于悬臂梁方程建立剪弯刚度理论模型;然后构建考虑接触边界的锁合结构数值模型,得到其扭转刚度曲线;最后结合理论分析和数值计算求得考虑接触非线性的限弯器剪弯刚度曲线,并同传统的整体数值方法相比较,验证该半数值分析方法的有效性。对比发现基于半数值方法的限弯器剪弯计算效率远高于传统数值方法,其结果误差也满足工程需求;并且限弯器锁合结构处受接触边界影响有明显的非线性;限弯器子梁这一短梁结构基于Timoshenko梁理论计算的结果精度更高也更保守。相较于传统数值方法,该半数值方法用方程直接表达部分参数与剪弯刚度关系,并可以高效地分析限弯器剪弯刚度,使设计工作更加高效。     

自升式钻井平台桩靴踩脚印应对措施对比研究

基于现有规范与文献研究提出的减小桩靴踩脚印附加响应的相关措施,首先基于耦合欧拉—拉格朗日(CEL)定量分析了传统纺锤形桩靴与新型桩靴在不同工况条件下插桩时桩靴地基土体相互作用机制,明确了最不利桩靴踩脚印工况时的插桩偏心距与桩坑深度。基于该最不利工况条件,对比分析了新型六孔莲蓬形桩靴、试踩法与地基钻孔法3种桩靴踩脚印应对措施的适用性与有效性。结果表明,相较于传统纺锤形桩靴,采用六孔莲蓬形桩靴使桩靴倾斜角与桩腿偏移距分别降低了33.13%和48.26%,说明结构在位稳定性更高。此外,通过对比分析得出,采用最佳设置方式进行试踩与钻孔处理后再进行桩靴贯入时,桩靴受到的水平滑动力峰值与桩腿RP₁处弯矩峰值相较于未处理时分别降低了29.47%、29.17%、34.7%、37.7%。可见,3种应对措施均能有效降低桩靴踩脚印后产生的不利影响,提高桩靴结构的在位稳定性。以最终减小不利附加响应程度作为评定标准：地基钻孔法>新型六孔莲蓬形桩靴>试踩法,由于地基钻孔法与试踩法均需增设额外机械设备及施工工序,大幅提高了工程造价,因此,在实际工程中,需要根据实际情况恰当选择应对措施。研究成果可为实际工程中应对桩靴踩脚印工况响应提供一定参考与借鉴。     

工程海域波浪特征分析方法比较

通过选取两个典型海外工程项目案例,分别采用波浪特征参数法和波浪谱法对工程海域波浪条件进行分析,并比较这两种方法在作业波浪条件、波浪特征认知程度上的差异,以及对海港水域平面布置产生的影响。对于波浪能量在频域及方向上存在多峰谱情况的海域,基于全谱的波浪特征参数系列数据有可能出现以下两种情况:1)主峰波向掩盖次峰波向;2)主峰波向错配次峰周期。对于上述两种情况,若仅采用波浪特征参数法对工程海域作业波浪条件进行分析,并指导海港水域平面布置,则极可能忽略或误判个别敏感波向、关键频域段的部分波浪能量,从而误导设计,为后续项目运营埋下隐患。对于以上情形,宜采用波浪谱法深入分析工程海域波浪能量在整个频域及各个方向上的详细分布及构成,并对关键波向、关键频域段的波浪能量进行量化,评估其对海港水域平面布置的影响,从而最大程度地避免由于波浪输入条件误判带来的风险。     

对虾体内氯霉素含量测定方法的研究

应用ＨＰＬＣ技术建立常用药物氯霉素的虾体动力学研究方法。该方法的特点是：与微生物法、比色法、气相色谱法、荧光法及免疫法比较．测试准确、快速且灵敏度高。应用该方法可以从虾体内的血液、肌肉、肝胰脏、肠胃中分离出被虾吸收的氯霉素，并定量测定。在１—５０μｇ／ｍｌ范围内线性关系相关系数为０．９９９５。     

确定连续系统参数的时域方法

提出一种确定连续系统参数的时域方法。该方法利用方波输入和系统稳定性，离析出输出采样信号与结构参数的内在联系，推导出确定连续系统结构参数的算法．指出该算法与辨识方法相结合，可实现对含随机干扰的连续系统结构参数的估计．     

Analysis of formation pressure test results in the Mount Elbert methane hydrate reservoir through numerical simulation

Targeting the methane hydrate (MH) bearing units C and D at the Mount Elbert prospect on the Alaska North Slope, four MDT (Modular Dynamic Formation Tester) tests were conducted in February 2007. The C2 MDT test was selected for history matching simulation in the MH Simulator Code Comparison Study. Through history matching simulation, the physical and chemical properties of the unit C were adjusted, which suggested the most likely reservoir properties of this unit. Based on these properties thus tuned, the numerical models replicating “Mount Elbert C2 zone like reservoir”, “PBU L-Pad like reservoir” and “PBU L-Pad down dip like reservoir” were constructed. The long term production performances of wells in these reservoirs were then forecasted assuming the MH dissociation and production by the methods of depressurization, combination of depressurization and wellbore heating, and hot water huff and puff. The predicted cumulative gas production ranges from 2.16 × 10⁶ m³/well to 8.22 × 10⁸ m³/well depending mainly on the initial temperature of the reservoir and on the production method.This paper describes the details of modeling and history matching simulation. This paper also presents the results of the examinations on the effects of reservoir properties on MH dissociation and production performances under the application of the depressurization and thermal methods.     

A simplified approach to design fuzzy logic controller for an underwater vehicle

Fuzzy logic controller (FLC) performance is greatly dependent on its inference rules. In most cases, the more rules being applied to an FLC, the accuracy of the control action is enhanced. Nevertheless, a large set of rules requires more computation time. As a result, an FLC implementation requires fast and high performance processors. This paper describes a simplified control scheme to design a fuzzy logic controller (FLC) for an underwater vehicle namely, deep submergence rescue vehicle (DSRV). The proposed method, known as the single input fuzzy logic controller (SIFLC), reduces the conventional two-input FLC (CFLC) to a single input FLC. The SIFLC offers significant reduction in rule inferences and simplifies the tuning process of control parameters. The performance of the proposed controller is validated via simulation by using the marine systems simulator (MSS) on the Matlab/Simulink^® platform. During simulation, the DSRV is subjected to ocean wave disturbances. The results indicate that the SIFLC, Mamdani and Sugeno type CFLC give identical response to the same input sets. However, an SIFLC requires very minimum tuning effort and its execution time is in the orders of two magnitudes less than CFLC.     

基于"一带一路"建设的环渤海地区港口优势评价

港口作为海陆运输的节点,是一个城市和国家的重要门户,对推动经济发展和对外贸易有着不可忽视的作用。基于国家提出的"一带一路"建设,评估环渤海港口的发展优势,逐步实现从沿海、沿江开放向内陆延伸具有重要意义。文章选取环渤海港口中的大连、天津、唐山、丹东、营口、锦州、秦皇岛、黄骅、日照、青岛、威海和烟台共12个港口进行发展优势对比。从港口吞吐量、港口规模范围、港口城市及腹地、港口未来发展4个方面构建环渤海港口优势评价体系。并利用熵权-TOPSIS法进行深入的实证分析。结果表明,环渤海港口群港口发展优势水平悬殊,基本可以分为4个档次。基于此,环渤海各港口应合理准确定位,通过错位发展和协同合作等方式谋求共赢。