航天INSAR复影像对的自动快速匹配

针对航天INSAR主、辅影像数据的特点，提出了加大匹配窗口、加大锚点间隔的匹配策略，以提高匹配的可靠性和速度。在匹配过程中，综合利用轨道参数和强度影像金字塔进行粗匹配，并对强度影像采用相关系数与最小二乘相结合的双向匹配方案，实现了自动、快速、高可靠性和高精度的航天INSAR复影像匹配。最后总结了航天INSAR复影像匹配的特点。     

激光剥蚀等离子体质谱分析中激光剥蚀参数对信号响应的影响

探讨了激光剥蚀等离子体质谱固体微区分析中激光剥蚀参数对元素分析信号灵敏度及稳定性的影响。这些参数包括激光功率、脉冲频率、剥蚀孔经、散焦距离、剥蚀方式等。讨论了优化的激光剥蚀等离子体质谱信号采集及数据处理方式。在全质量范围内选用具有代表性的元素作为研究对象,建立了激光剥蚀的一般性特征规律和266nm紫外激光系统的最佳操作条件。在选定的激光剥蚀参数下,大多数被测元素的检出限为22.8~457ng/g,能够满足固体微区分析的要求。     

ELF propagation parameters for uniform models of the Earth–ionosphere waveguide

Uniform models for the Earth–ionosphere cavity are considered with particular attention to the physical properties of the ionosphere for the extremely low frequency (ELF) range. Two consistent features have long been recognized for the range: the presence of two distinct altitude layers of maximum energy dissipation within the lower ionosphere, and a “knee”-like change in the vertical conductivity profile representing a transition in dominance from ion-dominated to electron-dominated conductivity. A simplified two-exponential version of the Greifinger and Greifinger (1978) technique widely used in ELF work identifies two slopes in the conductivity profile and, providing accurate results in the ELF communication band (45–75 Hz), simulates too flat a frequency dependence of the quality factor within the Schumann resonance frequency range (5–40 Hz). The problem is traced to the upward migration, with frequency increasing, of the lower dissipation layer through the “knee” region resulting in a pronounced decrease of the effective scale height for conductivity. To overcome this shortcoming of the two-exponential approximation and still retain valuable model analyticity, a more general approach (but still based on the Greifinger and Greifinger formalism) is presented in the form of a “knee” model whose predictions for the modal frequencies, the wave phase velocities and the quality factors reasonably represent observations in the Schumann resonance frequency range.     

Optimal placement of dampers and actuators based on stochastic approach

A general method is developed for optimal application of dampers and actuators by installing them at optimal location on seismic-resistant structures. The study includes development of a statistical criterion, formulation of a general optimization problem and establishment of a solution procedure. Numerical analysis of the seismic response in time-history of controlled structures is used to verify the proposed method for optimal device application and to demonstrate the effectiveness of seismic response control with optimal device location. This study shows that the proposed method for the optimal device application is simple and general, and that the optimally applied dampers and actuators are very efficient for seismic response reduction.     

大兴安岭浅覆盖区生态地质评价方法初探——以1∶25万区调呼中镇幅为例

通过野外调查，在收集统计大量基础地质、经济地质、环境地质、旅游地质、农(林)业地质等数据信息的基础上，在GIS技术指导下，采用定量定性相结合的半定量分析评价方法，对森林浅覆盖区生态地质现状及各类资源的开发利用潜力进行了综合评价。在研究和探讨森林浅覆盖区生态地质综合评价方法的基础上，提出了森林浅覆盖区生态地质评价模型，确定了综合参数，划分了生态地质类型。     

软土大变形固结计算中参数识别的遗传算法

含水量很高的饱和软土在外荷载作用下沉降很大,小变形分析误差太大,必须通过大变形非线性固结计算来模拟。遗传算法是一种全局优化和搜索的仿生算法。近年来随着工程领域中复杂的大规模非线性系统的出现,遗传算法日益得到青睐,目前已经广泛应用到各个领域中。本文对遗传算法做了改进,主要体现在杂交算子的选取和轮盘赌模型的模拟退火拉伸,并将其用于饱和软土的大变形固结分析,解决其中的关键参数识别问题。研究表明该方法是行之有效的,值得进一步研究探索。     

Changes in source parameters of foreshocks and aftershocks of the 2001 M_S=6.0 Yajiang, Sichuan, earthquake

Introduction An MS=6.0 earthquake occurred on February 23, 2001 in Yajiang county, Sichuan Province. The earthquake is located on the east of the southeast segment of the Litang-Dewu fault with strike of NW. Before the event, on February 14, an MS=5.0 earthquake took place nearly in the same place. In 1948 an MS=7.3 earthquake occurred on the northwestern segment of the Litang fault. The length of the surface rupture belt caused by the earthquake is 70 km, which extended from Litang to…     

Seismic response predictions of multi‐span steel bridges through pushover analysis

In the new trend of seismic design methodology, the static pushover analysis is recommended for simple or regular structures whilst the time‐history analysis is recommended for complex structures. To this end, the applicable range of the pushover analysis has to be clarified. This study aims at investigating the applicability of pushover analysis to multi‐span continuous bridge systems with thin‐walled steel piers. The focus is concentrated on the response demand predictions in longitudinal or transverse directions. The pushover analysis procedure for such structures is firstly summarized and then parametric studies are carried out on bridges with different types of superstructure‐pier bearing connections. The considered parameters, such as piers' stiffness distribution and pier–0.5ptdeck stiffness ratio, are varied to cover both regular and irregular structures. Finally, the relation of the applicability of pushover analysis to different structural formats is demonstrated and a criterion based on the higher modal contribution is proposed to quantitatively specify the applicable range. Copyright © 2003 John Wiley & Sons, Ltd.     

冲绳海槽南部沉积层序的粒度特征

对取自冲绳海槽南部的A2 3孔经前处理后的沉积物样品进行了粒度测试,探讨了陆源沉积层序的粒度特征。沉积物平均粒径、分选系数、偏态、峰态等粒度参数的变化显示出A2 3孔的沉积层序以 4 0 0cm为界可分为上、下两段,下段各参数稳定,代表了比较稳定的水动力条件的沉积环境;上段则波动较大,小规模浊流沉积频繁发育,暗示了不稳定的沉积环境。浊流层内粗粒与细粒组分含量及粒度分布的变化具有明显的规律性。通过分析A2 3孔陆源沉积层序的各沉积参数特征,认为冲绳海槽南部的沉积环境和动力在时间尺度上有较大的变化,东海陆架物质向南部海槽的输运可能是以峡谷为通道的重力作用引起的床底沉积作用为主。另外,对陆源碎屑和全样粒度结果的对比,显示了前处理方法对于海洋沉积物粒度分析的重要性.