应变组合的地质意义及其分解实例

以分析递进变形序列为主线,论述了主有限应变和增量应变的内部旋转所组合的应变扇形区的空间展布。结合发育于剪切带中的一个微细粒浸染型金矿的找矿实际,指出该理论的野外应用方法。     

采用变系数回归模型提取GPS坐标序列季节性信号

提出采用变系数回归模型提取连续GPS坐标序列中包含的振幅时变季节性信号。对模拟数据及实际GPS坐标序列两组数据的分析结果表明,变系数回归模型在提取GPS坐标序列季节信号方面比传统模型更有效。经处理,GPS坐标序列能获得更合理的速度及噪声估计。     

基于位移强度概念分析大坝变形规律

为改变以单个监测点为研究对象分析大坝变形规律的方法,提出位移强度概念,并以此作为分类标准,借鉴决策树算法,根据大坝所有监测点的坐标建立模型,计算并分析大坝在某一方向上的整体变形规律。     

Five dimensional cosmological models in Lyra geometry with time dependent displacement field

In this paper exact solutions of the five-dimensional vacuum cosmological field equations based on Lyra geometry are obtained. Further it is shown that neither dust distribution nor perfect fluid distributions survive for the model. Some properties of the vacuum model are also discussed.     

不同跨高比对多层钢框架内填混凝土深梁结构抗震性能影响

为了研究不同跨高比多层钢框架内填混凝土深梁结构的抗震性能,在钢框架内填混凝土深梁滞回性能试验的基础上,利用ABAQUS对六层纯钢框架（结构一）、钢框架内填跨高比为2混凝土深梁结构（结构二）和钢框架内填跨高比为0.75混凝土深梁结构（结构三）进行弹塑性时程分析。结果表明:内填混凝土深梁使结构整体刚度明显增大;在地震波的作用下,结构二的最大顶点位移降低可达58.3%,结构三的最大顶点位移降低可达89.3%,内填混凝土深梁,结构的抗侧移性能得到了极大改善,且随着深梁跨高比的减小而大幅度提升;结构二滞回曲线饱满,呈现纺锤形,混凝土深梁充分起到了第一道防线作用。经济合理的钢框架内填混凝土深梁结构具有一定的工程应用价值。     

Accurate real‐time hybrid earthquake simulations on large‐scale MDOF steel structure with nonlinear viscous dampers

This paper presents real‐time hybrid earthquake simulation (RTHS) on a large‐scale steel structure with nonlinear viscous dampers. The test structure includes a three‐story, single‐bay moment‐resisting frame (MRF), a three‐story, single‐bay frame with a nonlinear viscous damper and associated bracing in each story (called damped braced frame (DBF)), and gravity load system with associated seismic mass and gravity loads. To achieve the accurate RTHS results presented in this paper, several factors were considered comprehensively: (1) different arrangements of substructures for the RTHS; (2) dynamic characteristics of the test setup; (3) accurate integration of the equations of motion; (4) continuous movement of the servo‐controlled hydraulic actuators; (5) appropriate feedback signals to control the RTHS; and (6) adaptive compensation for potential control errors. Unlike most previous RTHS studies, where the actuator stroke was used as the feedback to control the RTHS, the present study uses the measured displacements of the experimental substructure as the feedback for the RTHS, to enable accurate displacements to be imposed on the experimental substructure. This improvement in approach was needed because of compliance and other dynamic characteristics of the test setup, which will be present in most large‐scale RTHS. RTHS with ground motions at the design basis earthquake and maximum considered earthquake levels were successfully performed, resulting in significant nonlinear response of the test structure, which makes accurate RTHS more challenging. Two phases of RTHS were conducted: in the first phase, the DBF is the experimental substructure, and in the second phase, the DBF together with the MRF is the experimental substructure. The results from the two phases of RTHS are presented and compared with numerical simulation results. An evaluation of the results shows that the RTHS approach used in this study provides a realistic and accurate simulation of the seismic response of a large‐scale structure with rate‐dependent energy dissipating devices. Copyright © 2015 John Wiley & Sons, Ltd.     

On solution of the inverse problem for confined aquifer flow via maximum likelihood

Joint estimation of transmissivity (T) and storativity (S) in a confined aquifer is done via maximum likelihood (ML). The differential equation of groundwater flow is discretized by the finite-element method, leading to equation _t+x _t=u _t. Elements of matrices and , as well as estimated covariance matrix of noise termu _t, are functions of T and S. By minimizing the negative loglikelihood function corresponding to discretized groundwater flow equation with respect to T and S, ML estimators are obtained. The ML approach is found to yield accurate estimates of T and S (within 9 and 10% of their actual values, respectively) and showed quadratic convergence in Newton's search technique. Prediction of aquifer response, using ML estimators, results in estimated piezometric heads accurate to ±0.5 m from their actual, exact values. Statistical properties of ML estimators are derived and some basic results for statistical inference are given.     

辽西医巫闾山地区中生代两期韧性变形的研究

医巫闾山地区的韧性剪切构造是中生代两期韧性变形作用的产物。早期韧性变形中a线理发育,线理走向和糜棱面理走向基本一致,线理在xy面上的侧伏角绝大多数<30°;该期韧性变形是以左行走滑运动为主。晚期韧性变形中a线理发育,线理倾伏向和糜棱岩中糜棱面理倾向相近,线理在xy面上侧伏角主要在45°～90°之间;该期韧性变形是伸展作用的产物。医巫闾山中生代两期韧性剪切变形作用表明,在侏罗纪至早白垩世期间辽西地区不仅发生了强烈挤压推覆作用和伸展作用,也发生了大规模左行走滑作用。该韧性变形作用的发现对进一步研究辽西中生代的构造演化序列、期次和构造格架转换等问题有重要意义。     

Interaction among fractures and stress field computation of fracture systems

ＩｎｔｅｒａｃｔｉｏｎａｍｏｎｇｆｒａｃｔｕｒｅｓａｎｄｓｔｒｅｓｓｆｉｅｌｄｃｏｍｐｕｔａｔｉｏｎｏｆｆｒａｃｔｕｒｅｓｙｓｔｅｍｓＺｈｉ－ＬｉＺＨＡＮＧ（张之立）（ＩｎｓｔｉｔｕｔｅｏｆＧｅｏｐｈｙｓｉｃｓ，ＳｔａｔｅＳｅｉｓｍｏｌｏｇｉｃａｌＢ...     

Stroke构造、移位一体化的道路网示意化方法

针对当前常用示意性地图生成方法中往往存在简化程度不够、未考虑长度信息以及时间效率低等问题,提出了stroke构造、移位一体化的道路网示意化方法。该方法在对道路网进行stroke划分构造的同时,直接对其进行渐进式的移位示意化及拓扑检查。同时本文还提出利用相似分形维数来定量比较并验证不同示意化方法的有效性。试验表明,本算法在考虑原始线形的基础上,示意化过程简单,时间效率较高,减少了拓扑冲突问题,保证了拓扑一致性及路网的均衡分布,具有较好的清晰度和认知度。