非潮汐海洋运动对地球动力学扁率变化的贡献

通过考察全球海洋环流数值模型以及TOPEX/Poseidon海洋测高数据,得到结论：1997/1998年后的部分J2异常变化可能来自海洋环流变化导致的质量重新分布,具体地说是太平洋环流变化导致的从高纬地区向低纬地区的质量迁移. 本工作表明来自于海洋内部温盐效应的变化对J2异常变化有重要贡献,进一步证实了卫星激光测距资料所得结果的可靠性.     

Nanodeformation in enstatite single crystals: Simulation of micrometeoroid impacts by femtosecond pulsed laser experiments

Space weathering by micrometeoroid bombardment is a cosmic phenomenon on atmosphere-free celestial bodies, a process that is expected to particularly overprint planetesimals and cosmic dust in debris discs. We reproduced micrometeoroid impact craters by femtosecond pulsed laser irradiation on oriented enstatite single crystals (En₉₃Fs₇) to investigate the deformation behavior and its orientation dependence. All microcraters show typical bowl shaped morphologies, a glass surface layer with splash like ejecta material and subsurface layering. Although we could reproduce melting and vaporization as typical space weathering effects in the enstatite experiments, there is no formation of agglutinate particles or metallic nanoparticles (npFe⁰). The shock effects in the deformation layer consist of planar structures like microfractures and cleavages, amorphous lamellae, stacking faults and clinoenstatite lamellae. Their activation and/or orientation depends on the shock direction. In special orientations we observe the activation of glide systems along specific low indexed crystallographic planes. Due to the short timescale and the high strain rates, the most prominent effect is the failure of enstatite by microfracturing along non-rational crystallographic planes. Common deformation mechanisms reported in meteorites like the formation of clinoenstatite lamellae via shearing along [001] (100) occur less frequently. Shear is apparently the dominant mechanism in the formation of the above-mentioned effects and causes also their modification by frictional heating. The wide-spread formation of amorphous lamellae is, for example, interpreted to be the result of this shear heating along planar structures. We interpret this unconventional deformation behavior as a consequence of the small spatial and temporal scale of the experiments, resulting in a short-lived spherical shock wave with high deviatoric stresses in contrast to a long pressure pulse and quasi-hydrostatic compression in large scale impacts that produce typical shock features.     

激光能量密度对LA-ICP-MS分析数据质量的影响研究

LA-ICP-MS分析矿物元素含量时激光能量密度会影响样品的剥蚀速率,从而影响测试过程的信号强度。激光能量密度变化对测试数据精确度的影响,以及不同天然矿物对激光能量密度的响应尚需进一步明确。本文测定了不同莫氏硬度天然矿物可稳定剥蚀的最小激光能量密度,评估了193nm ArF准分子激光系统中能量密度对地质标准样品(NIST SRM614、USGS BCR-2G、USGS GSC-1G)和天然矿物测试数据质量的影响。研究结果表明:①稳定剥蚀石英和萤石所需的最小激光能量密度为4～5J/cm~2,低于前人的报道值(10J/cm~2),而稳定剥蚀其他矿物(如滑石、磷灰石、刚玉等)所需的最小能量密度一般在1～2J/cm~2;②不同激光能量密度剥蚀条件下,标准样品中大部分微量元素测试结果与推荐值的相对误差小于20%,相对标准偏差(RSD)小于10%,而天然矿物中含量1μg/g的大部分微量元素测试数据的RSD小于20%;③在一定范围内,激光能量密度越大,数据平均相对误差越小,整体质量更好。     

基于CryoSat-2卫星测高数据分析南极海冰厚度的时空变化

利用卫星测高数据能够获取大尺度、长时序的海冰厚度信息。相较于北极,目前南极海冰厚度特别是近期变化信息仍很缺乏。基于2013-2018年的CryoSat-2卫星测高数据,采用最低点高程法和静力平衡方程模型反演了近6年逐月平均海冰厚度并分析其时空变化规律。结果表明：2013-2018年南极海冰厚度整体呈现先上升后下降的趋势,其中,2014-2017年年平均海冰厚度表现为快速变薄。南极较厚的海冰集中在威德尔海西南海域,最大值出现在该海域2014年的7月（6.27 m）。年平均海冰厚度在2017年达到最低值。南极海冰厚度的时空变化研究可为深入研究海冰变化与全球变化的关系提供参考。     

Laser Ablation In Situ Silicon Stable Isotope Analysis of Phytoliths

Silicon is a beneficial element for many plants and is deposited in plant tissue as amorphous bio‐opal called phytoliths. The biochemical processes of silicon uptake and precipitation induce isotope fractionation: the mass‐dependent shift in the relative abundances of the stable isotopes of silicon. At the bulk scale, δ³⁰Si ratios span from ?2 to +6‰. To further constrain these variations in situ, at the scale of individual phytolith fragments, we used femtosecond laser ablation multi‐collector inductively coupled plasma‐mass spectrometry (fsLA‐MC‐ICP‐MS). A variety of phytoliths from grasses, trees and ferns were prepared from plant tissue or extracted from soil. Good agreement between phytolith δ³⁰Si ratios obtained by bulk solution MC‐ICP‐MS analysis and in situ isotope ratios from fsLA‐MC‐ICP‐MS validates the method. Bulk solution analyses result in at least twofold better precision for δ³⁰Si (2s on reference materials ≤ 0.11‰) over that found for the means of in situ analyses (2s typically ≤ 0.24‰). We find that bushgrass, common reed and horsetail show large internal variations up to 2‰ in δ³⁰Si, reflecting the various pathways of silicon from soil to deposition. Femtosecond laser ablation provides a means to identify the underlying processes involved in the formation of phytoliths using silicon isotope ratios.     

A new 3D laser-scanning and GPS combined measurement system

Terrestrial laser scanning (TLS) is widely used because of its ability to quickly acquire high-density and high-precision 3D image and topographic data. However, it can only acquire independent coordinate system points, which restricts its application in large-scale deformation monitoring. In this study, we constructed a measurement system to acquire global coordinate point cloud data by combining TLS and GPS (Global Positioning System). The coordinate values of retro-reflective targets could be acquired in different coordinate systems, the GPS coordinate and the TLS station coordinate, synchronously. Our experiments showed that, after registration with the homonymy points acquired by 30-min short-baseline differential GPS using the ICP algorithm, the positional accuracy of the TLS retro-reflective target center in the global coordinate was better than 10 mm. This high precision meets, for instance, the requirements of coal mining subsidence monitoring. We used our new combined measurement system to acquire and process the point cloud data of a frame structure. The measurements demonstrated the practicability and robustness of the new measurement system.     

An empirical estimate of the diffusion rate of oxygen in diopside

The intracrystalline diffusion rate of oxygen in diopside was constrained based on natural isotopic variations from a granulite facies marble from Cascade Slide, Adirondacks (New York, USA). The oxygen isotope compositions of the diopsides, measured as a function of grain size, are nearly constant (20.9 ± 0.3‰ vs. SMOW) over the entire measured size range (0.3–3.2 mm diameter). The δ¹⁸O values of the cores of calcite grains are 23.0‰. Temperature estimates based on the Δ¹⁸O(calcite-diopside) are 800d?C, in agreement with the highest previous thermometric estimates for these rocks. The lack of isotopic variation in the diopsides as a function of grain size requires that the oxygen intracrystalline diffusion rate in diopside from the Adirondack samples was very slow. The maximum diffusion rates (D_800d?C parallel to the c-axis) were calculated with an infinite reservoir model (IRM) and a finite reservoir model (FRM) that incorporates mineral modal abundances and initial isotopic variations. For an assumed activation energy (Q) = 100 kJ/mol, the IRM diffusion rate estimate of 1.6 times 10^-20cm²/s is two orders of magnitude faster than from the FRM; at Q=500kJ/mol, the D_800d?C estimate for both methods is c. 5.6 times 10^-20 cm²/s. The present results require that a hydrothermal fluid significantly enhances the diffusion rate of oxygen in diopside if previous data are correct. The δ¹⁸O(SMOW) and δ¹³C(PDB) values of the calcite, measured in situ with a CO₂ laser, are 22.9 ± 0.3, 0.1±0.3‰ in the grain cores, 22.1 ±0.3, 0.2 ±0.1‰ at the grain boundaries and 21.7 ±0.4, -0.6±0.1‰ abutting diopside grains. The δ¹⁸O and δ¹³δC values measured conventionally are: crystal cores, 22.96, -0.95‰; abutting diopside grains, 22.38, -0.93‰; bulk, 22.79, -0.95%. Use of the bulk δ¹⁸O(calcite) values for thermometry yields unreasonably high temperatures. The lower δ¹⁸O values at the calcite grain boundaries are not due to retrograde diffusional exchange with the diopside, they are thought to be a result of a late retrograde fluid infiltration.     

Multi-Conjugate Adaptive Optics with Two Deformable Mirrors – Requirements and Performance

In order to increase the corrected field of view of an adaptive optics (AO) system, several deformable mirrors (DM) have to be placed in the conjugate planes of the dominant turbulent layers (multi-conjugate adaptive optics,MCAO (Beckers, 1988)).The performance of MCAO systems depends on the quality of thewavefront sensing ofthe individual layers and on the number of corrected modes in eachindividual layer as in single layer AO systems. In addition, the increase in corrected field of view depends on the number of guide stars providing information about theturbulence over a sufficiently large area in each turbulent layer. In this article, we investigate these points and provide formulae for calculating the increased field of view with a new approach using the spatial correlation functions of the appliedpolynomials (e.g. Zernike). We also present a new scheme of measuring the individual wavefront distortion of each of the dominantlayers with a Shack-Hartmann-Curvature Sensor using gradientinformation as well as scintillation. An example for the performance of a two layer MCAO system is given for the 3.5-m telescope of the Calar Alto Observatory, Spain, using ameasured C_n ²-profile. The corrected field of view in K-band(2.2 m) can be as large as 3 arcmin with a Strehl ratio above 60%.     

A New Machine for Planarity Measurement of CCDs and Mosaics of CCDs

High quality CCD detectors are now being produced with 2048× 4096 square pixels, each 15 m on a side. Evenlarger detector areas are built with several CCDs mounted into amosaic. To be useful in an instrument the light must be in focuson all CCDs, requiring that all CCDs in a mosaic must typicallybe aligned within 30 micron of a flat plane. To achieve thisaccuracy in many cases the measurement and correction of the CCDalignment is necessary. One way allowing a surface measurement,even when the CCD is protected by a window, is to usetriangulation sensor. The principle of a triangulation sensor,its application and its implementation in a measuring machineare presented here.     

The value of ocean reflections of GPS signals to enhance satellite altimetry: data distribution and error analysis

The time and space distribution of general reflection altimetry from two satellites (senders and receivers) via the the oceans surface is examined with specific reference to GPS senders and two current receiving satellites. While a considerable enhancement of conventional altimeter coverage is possible in all configurations if the reflection signals can be used, repeating passes of these (with GPS senders) having reasonably small cycle times (days to tens of days) occur only if the receiving orbit is nearly polar. Results of an analysis of the fundamental geometry show that over a large range of reflection angles the error of recovered sea heights depends almost entirely on the errors in the delay signal and the radial error of the receiving satellite (using current estimates of GPS orbit accuracies). The most critical element is the precision of the delay measurement. Both it and the accuracy of the receiving orbit should be below the decimeter level for the technique to achieve its full potential.