The importance of oxygen isotope provenance in relation to solute content of bulk meltwaters at Imersuaq Glacier,West Greenland

Stable oxygen isotope analysis and measurement of several dissolved cations and anions of bulk meltwater samples have provided information about the hydrochemical environment of the glacial hydrological system at Imersuaq Glacier, an outlet tongue from the Greenland ice‐sheet, West Greenland. The samples were collected at frequent intervals during the period 20–28 July 2000 in a small (<20 L s^?1) englacial meltwater outlet at the glacier margin. The results document the following findings: (i) a marked diurnal variation of δ¹⁸O is related to the composition of oxygen isotope provenances, mainly near‐marginal local superimposed ice and basal up‐sheared ice further up‐glacier; (ii) a relationship is seen between all base cations (Na⁺, K⁺, Ca²⁺, Mg²⁺), SO₄^2? and δ¹⁸O, indicating that solute acquisition is provided by solid–solution contact with the up‐sheared ice—as the relationship with Cl^? is weak the influence of seasalt‐derived solutes is small in the area; (iii) when the melt rate is high, two diurnal maxima of δ¹⁸O values and solute concentrations are measured, and it is suggested that a snow meltwater component is responsible for the second maximum of δ¹⁸O—a short residence time leads to a delayed decrease in ion concentrations. Copyright © 2003 John Wiley & Sons, Ltd.     

The Preboreal climate reversal and a subsequent solar‐forced climate shift

Accurate chronologies are essential for linking palaeoclimate archives. Carbon‐14 wiggle‐match dating was used to produce an accurate chronology for part of an early Holocene peat sequence from the Borchert (The Netherlands). Following the Younger Dryas–Preboreal transition, two climatic shifts could be inferred. Around 11 400 cal. yr BP the expansion of birch (Betula) forest was interrupted by a dry continental phase with dominantly open grassland vegetation, coeval with the PBO (Preboreal Oscillation), as observed in the GRIP ice core. At 11 250 cal. yr BP a sudden shift to a humid climate occurred. This second change appears to be contemporaneous with: (i) a sharp increase of atmospheric ¹⁴C; (ii) a temporary decline of atmospheric CO₂; and (iii) an increase in the GRIP ¹⁰Be flux. The close correspondence with excursions of cosmogenic nuclides points to a decline in solar activity, which may have forced the changes in climate and vegetation at around 11 250 cal. yr BP. Copyright © 2004 John Wiley & Sons, Ltd.     

The influence of macrophyte growth,typical of eutrophic conditions,on river flow velocities and turbulence production

The influence of emergent and submerged macrophytes on flow velocity and turbulence production is demonstrated in a 140 m reach of the River Blackwater in Farnborough, Hampshire, UK. Macrophyte growth occurs in patches and is dominated by Sparganium erectum and Sparganium emersum. In May 2001, patches of S. erectum were already established and occupied 18% of the channel area. The flow adjusted to these (predominantly lateral) patches by being channelled through a narrower cross‐section. The measured velocity profiles showed a logarithmic form, with deviations attributable to topographic control. The channel bed was the main source of turbulence. In September 2001, in‐stream macrophytes occupied 27% of the channel, and overhanging bank vegetation affected 32% of the area. Overall flow resistance, described by Manning's n, showed a threefold increase that could be attributed to the growth of S. emersum in the middle of the channel. Velocity profiles showed different characteristic forms depending on their position relative to plant stems and leaves. The overall velocity field had a three‐dimensional structure. Turbulence intensities were generally higher and turbulence profiles tended to mirror the velocity profiles. Evidence for the generation of coherent eddies was provided by ratios of the root mean square velocities. Spectral analysis identified deviations from the Kolmogorov ?5/3 power law and provided statistical evidence for a spectral short‐cut, indicative of additional turbulence production. This was most marked for the submerged vegetation and, in some instances, the overhanging bank vegetation. The long strap‐like leaves of S. emersum being aligned approximately parallel to the flow and the highly variable velocity field created by the patch arrangement of macrophytes suggest that the dominant mechanism for turbulence production is vortex shedding along shear zones. Wake production around individual stems of S. emersum close to the bed may also be important locally. Copyright © 2006 John Wiley & Sons, Ltd.     

黑鲷早期鳞被的形成

黑鲷Sparus macrocephalus(Basilewsky)幼苗鳞被最早出现的部位是在躯干部胸鳍基后至肛门直上方的侧线处。黑鲷只具一个鳞被起始中心。最早出现鳞片的个体为体长9.5—14.1mm,平均11.51±0.85mm,全长11.2—16.5mm,平均13.65±1.01mm,孵后日龄23—35d。鳞被发育完全时的最小个体为体长12.1—18.5mm,平均14.57±1.55mm,全长14.8—23.5mm,平均17.99±2.17mm,孵后日龄27—42d。     

Timing effects on the fragmentation of small scale blocks of granodiorite

A series of small scale tests, simulating multi-hole blasts have been performed to establish the effect of delays on blast fragmentation. The blasts were performed in high quality granodiorite blocks, which were cut from stone prepared by dimensional stone quarry operations. The pattern used was equilateral triangular, with a distance of 10.2 cm between boreholes, which had a diameter of 11 mm, were loaded with detonating cord and the coupling medium was water. The delays used were achieved using different lengths of detonating cord for the cases of delays between 0 and 100 μs between holes and a sequential blasting machine firing seismic detonators for larger delays up to 4 ms. All fragments were collected and screened. The experiments showed that the worst fragmentation was achieved with simultaneous initiation of all charges. Fragmentation improved with the delay time between holes up to 1 ms between holes. If the experiments are scaled up, the results show that in granodiorite, fragmentation optimization requires delays of few milliseconds per metre of burden. The findings, agree with previously published work, involving larger scale experiments and other rock types.     

软土大变形固结计算中参数识别的遗传算法

含水量很高的饱和软土在外荷载作用下沉降很大,小变形分析误差太大,必须通过大变形非线性固结计算来模拟。遗传算法是一种全局优化和搜索的仿生算法。近年来随着工程领域中复杂的大规模非线性系统的出现,遗传算法日益得到青睐,目前已经广泛应用到各个领域中。本文对遗传算法做了改进,主要体现在杂交算子的选取和轮盘赌模型的模拟退火拉伸,并将其用于饱和软土的大变形固结分析,解决其中的关键参数识别问题。研究表明该方法是行之有效的,值得进一步研究探索。     

A rooftop tuned mass damper frame

This article documents the analytical study and feasibility of placing a tuned mass damper in the form of a limber rooftop moment frame atop relatively stiff structures to reduce seismic acceleration response. Six existing structures were analytically studied using a suite of time history and response spectra records. The analyses indicate that adding mass in conjunction with a limber frame results in an increase in the fundamental period of each structure. The fundamental period increase generally results in a decrease in seismic acceleration response for the same time history and response spectra records. Owing to the limber nature of the rooftop frames, non‐linear analysis methods were required to evaluate the stability of the rooftop tuned mass damper frame. The results indicate the addition of a rooftop tuned mass damper frame reduces the seismic acceleration response for most cases although acceleration response can increase if the rooftop frame is not tuned to accommodate the specific structure's dynamic behaviour and localized soil conditions. Appropriate design of the rooftop tuned mass damper frame can result in decreased seismic acceleration response. This translates to safer structures if used as a retrofit measure or a more economical design if used for new construction. Copyright © 2003 John Wiley & Sons, Ltd.     

Seismic response predictions of multi‐span steel bridges through pushover analysis

In the new trend of seismic design methodology, the static pushover analysis is recommended for simple or regular structures whilst the time‐history analysis is recommended for complex structures. To this end, the applicable range of the pushover analysis has to be clarified. This study aims at investigating the applicability of pushover analysis to multi‐span continuous bridge systems with thin‐walled steel piers. The focus is concentrated on the response demand predictions in longitudinal or transverse directions. The pushover analysis procedure for such structures is firstly summarized and then parametric studies are carried out on bridges with different types of superstructure‐pier bearing connections. The considered parameters, such as piers' stiffness distribution and pier–0.5ptdeck stiffness ratio, are varied to cover both regular and irregular structures. Finally, the relation of the applicability of pushover analysis to different structural formats is demonstrated and a criterion based on the higher modal contribution is proposed to quantitatively specify the applicable range. Copyright © 2003 John Wiley & Sons, Ltd.