土参数对桩基水平响应影响的研究

桩基的水平响应由桩土间的相互作用决定,通过采用p-y曲线来表示桩土间的非线性相互作用。通过算例,讨论分析了粘性土参数的变化对p-y曲线中土体的极限强度和刚度、桩基水平位移和弯矩分布及最大弯矩和水平荷载关系的影响。     

Hydro-thermal performance of multilayer capillary barriers in arid lands

In this study, a capillary barrier system was designed and tested for an arid land environment. To simulate arid land conditions of high temperature and sub-irrigation systems, the barrier was subjected to thermal and hydraulic gradients in opposite directions; to test the barrier system under these severe conditions, an experimental apparatus was designed and fabricated. The multilayer capillary barrier consisted of three layers made of silica sand, a mixture of sand and bentonite in equal portions, and a mixture of clay (25%) and aggregate (75%). Several one dimensional coupled heat and moisture tests were performed. Temperature variations along the thickness of the barrier were recorded as a function of time, and at the end of each test, the barrier was sliced into small sections, for the determination of volumetric water content as a function of distance from the heat source. The experimental results were discussed in view of the barrier's intended purpose of its ability to store moisture for long time durations. Coupled heat and moisture flow equations were developed and solved numerically via a finite difference method. Diffusivity parameters were calculated by using experimental results, a numerical model, and Powell's conjugate directions method of nonlinear optimization. The model was calibrated and the results were discussed. Good agreement between calculated and experimental results was obtained. This revised version was published online in July 2006 with corrections to the Cover Date.     

GPS广播星历参数拟合算法

介绍了GPS广播星历参数的最小二乘估计方法。推导了相应的计算公式。计算结果表明。文中给出的公式是正确的，其拟合精度以用户距离误差(URE)示时，对预报轨道的损失小于1cm。     

内蒙古中西部地区震源参数和场地响应反演

采用Atkinson方法，基于遗传算法，利用呼和浩特数字地震台网7个子台记录的9次质量较高的地震事件资料，计算了内蒙古中西部地区的品质因子Q值和非弹性衰减系数c（f）。在所研究的频率范围内，前者和频率．厂有很好的线形关系：Q（f）=116．8f^1.000后者与频率．厂的变化关系不明显。在此基础上采用Moya方法反演了7个地震台的场地响应和地震的震源参数，并对它们之间的相互关系进行了讨论。结果显示在所研究的频率域内7个基岩台站的场地均不同程度的存在放大作用，其次震源参数间具有较好的线性关系。本文还详细介绍了Atkinson方法和Moya方法的原理和计算步骤。     

应用遥感方法研究黄河三角洲地表蒸发及其与下垫面关系

文中主要应用遥感方法计算了黄河三角洲地表蒸发量及其地表特征参数。地表特征参数及其合理组合揭示出黄河三角洲下垫面的基本特征:农田植被指数和天然植被的植被指数有不同的变化规律,下垫面覆盖度低,裸地较多,地表较湿润,蒸发量较大。蒸发量时空分布主要受下垫面条件控制,滨海裸地和受人类活动影响较大的农田等地蒸发量较大,年际平均蒸发量在570~860 mm之间。     

Détermination expérimentale des paramètres équivalents d'un milieu poreux hétérogène en écoulements uniforme ou radial

Tracer tests are carried out in a heterogeneous porous medium that has a 3D correlated random distribution of the permeabilities. The fitting of numerical models provides the values of equivalent permeability and macrodispersivity characterizing a 2D homogeneous horizontal medium. Different flow configurations are studied: uniform, radial and pump and treat (doublet). The fitted parameter sets are independent of the flow type, except for the doublet. They are greater than the values predicted by stochastic theories, due to the small number of correlation lengths explored by the tracer and the limited extension of the experimental set-up. To cite this article: C. Danquigny, P. Ackerer, C. R. Geoscience 337 (2005).     

A methodology for regionalizing 3‐D effective porosity at watershed scale in crystalline aquifers

An innovative approach for regionalizing the 3‐D effective porosity field is presented and applied to two large, overexploited, and deeply weathered crystalline aquifers located in southern India. The method derives from earlier work on regionalizing a 2‐D effective porosity field in that part of an aquifer where the water table fluctuates, which is now extended over the entire aquifer using a 3‐D approach. A method based on geological and geophysical surveys has also been developed for mapping the weathering profile layers (saprolite and fractured layers). The method for regionalizing 3‐D effective porosity combines water table fluctuation and groundwater budget techniques at various cell sizes with the use of satellite‐based data (for groundwater abstraction), the structure of the weathering profile, and geostatistical techniques. The approach is presented in detail for the Kudaliar watershed (983 km²) and tested on the 730 km² Anantapur watershed. At watershed scale, the effective porosity of the aquifer ranges from 0.5% to 2% in Kudaliar and between 0.3% and 1% in Anantapur, which agrees with earlier works. Results show that (a) depending on the geology and on the structure of the weathering profile, the vertical distribution of effective porosity can be very different and that the fractured layers in crystalline aquifers are not necessarily characterized by a rapid decrease in effective porosity and (b) that the lateral variations in effective porosity can be larger than the vertical ones. These variations suggest that within a same weathering profile, the density of open fractures and/or degree of weathering in the fractured zone may significantly vary from a place to another. The proposed method provides information on the spatial distribution of effective porosity that is of prime interest in terms of flux and contaminant transport in crystalline aquifers. Implications for mapping groundwater storage and scarcity are also discussed, which should help in improving groundwater resource management strategies.     

Metals discharged during different flow conditions from a mixed agricultural‐forest catchment (NW Spain)

Metal loads were determined from water samples collected under different streamflow conditions (baseflow and storm events) in a rural catchment (NW Spain) during 4 years. A study at annual, seasonal and storm‐event scales was carried out. In all analysed scales, the export order was Fe > Al > Mn > Zn > Cu. A high inter‐annual, seasonal and storm‐event scale variability of metal load was observed. The total metal loads in stream were higher during baseflow conditions than during storm events, which only represented 4% of the duration of the study period and 25% of streamflow. During storm events, both Al and Fe loads accounted 45% of the total load of the study period, whereas Mn, Cu and Zn loads represented 42%, 33% and 24%, respectively. This highlights the role of high flows on metal export. Only four big events exported around 30% of load of each metal transported in events. At all time scales, a prevalence of export of particulate metals over dissolved metals was observed, more pronounced for Al, Fe and Mn than for Cu and Zn. The export of metals in the Corbeira catchment is influenced by runoff and, to a lesser extent, by the rainfall amount. Copyright © 2014 John Wiley & Sons, Ltd.     

Sensitivity of soil parameters in unsaturated zone modelling and the relation between effective,laboratory and in situ estimates

Simulation of soil moisture content requires effective soil hydraulic parameters that are valid at the modelling scale. This study investigates how these parameters can be estimated by inverse modelling using soil moisture measurements at 25 locations at three different depths (at the surface, at 30 and 60 cm depth) on an 80 by 20 m hillslope. The study presents two global sensitivity analyses to investigate the sensitivity in simulated soil moisture content of the different hydraulic parameters used in a one‐dimensional unsaturated zone model based on Richards' equation. For estimation of the effective parameters the shuffled complex evolution algorithm is applied. These estimated parameters are compared to their measured laboratory and in situ equivalents. Soil hydraulic functions were estimated in the laboratory on 100 cm³ undisturbed soil cores collected at 115 locations situated in two horizons in three profile pits along the hillslope. Furthermore, in situ field saturated hydraulic conductivity was estimated at 120 locations using single‐ring pressure infiltrometer measurements. The sensitivity analysis of 13 soil physical parameters (saturated hydraulic conductivity (K_s), saturated moisture content (θ_s), residual moisture content (θ_r), inverse of the air‐entry value (α), van Genuchten shape parameter (n), Averjanov shape parameter (N) for both horizons, and depth (d) from surface to B horizon) in a two‐layer single column model showed that the parameter N is the least sensitive parameter. K_s of both horizons, θ_s of the A horizon and d were found to be the most sensitive parameters. Distributions over all locations of the effective parameters and the distributions of the estimated soil physical parameters from the undisturbed soil samples and the single‐ring pressure infiltrometer estimates were found significantly different at a 5% level for all parameters except for α of the A horizon and K_s and θ_s of the B horizon. Different reasons are discussed to explain these large differences. Copyright © 2004 John Wiley & Sons, Ltd.     

影像全站仪在文物三维数字化测量中的应用与实践

根据影像全站仪的工作原理,总结出在文物测绘中的技术路线,研究点云数据处理过程中拼接、降噪、纹理映射的方法,并通过对模型数据采集精度的分析,给出了合理的数据模型采集值,为影像全站仪快速、可靠的在文物三维数字化建模中提供有益的借鉴。