Constraints on the application of carbon isotope thermometry in high- to ultrahigh-temperature metamorphic terranes

Nine marble horizons from the granulite facies terrane of southern India were examined in detail for stable carbon and oxygen isotopes in calcite and carbon isotopes in graphite. The marbles in Trivandrum Block show coupled lowering of δ¹³C and δ¹⁸O values in calcite and heterogeneous single crystal δ¹³C values (? 1 to ? 10‰) for graphite indicating varying carbon isotope fractionation between calcite and graphite, despite the granulite facies regional metamorphic conditions. The stable isotope patterns suggest alteration of δ¹³C and δ¹⁸O values in marbles by infiltration of low δ¹³C–δ¹⁸O‐bearing fluids, the extent of alteration being a direct function of the fluid‐rock ratio. The carbon isotope zonation preserved in graphite suggests that the graphite crystals precipitated/recrystallized in the presence of an externally derived CO₂‐rich fluid, and that the infiltration had occurred under high temperature and low f_O2 conditions during metamorphism. The onset of graphite precipitation resulted in a depletion of the carbon isotope values of the remaining fluid+calcite carbon reservoir, following a Rayleigh‐type distillation process within fluid‐rich pockets/pathways in marbles resulting in the observed zonation. The results suggest that calcite–graphite thermometry cannot be applied in marbles that are affected by external carbonic fluid infiltration. However, marble horizons in the Madurai Block, where the effect of fluid infiltration is not detected, record clear imprints of ultrahigh temperature metamorphism (800–1000 °C), with fractionations reaching <2‰. Zonation studies on graphite show a nominal rimward lowering δ¹³C on the order of 1 to 2‰. The zonation carries the imprint of fluid deficient/absent UHT metamorphism. Commonly, calculated core temperatures are > 1000 °C and would be consistent with UHT metamorphism.     

扎赉诺尔煤田水文地球化学特征及成因分析

扎赉诺尔煤田地处山前,有利的地理环境条件形成了独特的水文地质特征—地下水的垂直分带和地下水顺层径流。其特有的水文地球化学环境导致了地下水成分的差异性。本文从水文地球化学的角度,对煤田地下水的水文地球化学特征及成因进行了论述分析。     

考虑入渗和蒸发影响的土坡稳定性分析方法

本研究建议的一种分析方法假定斜坡非饱和土体的水分运动参数及剪强度参数与饱和度的依赖关系均可根据实验或经验确定。通过数值计算方法妥任意给定的入渗和蒸发边界条件下斜坡土体的瞬态含水率分布及与其相对应的瞬态抗剪强度参数分布。在此基础上瞬态斜坡安全因数即可通过常规的稳定性分析方法求得。     

非饱和土壤Richards方程入渗求解探讨

根据理查兹 (Richards)方程求解非饱和土壤垂直一维入渗率历时规律 ,因缺乏土壤水分特性函数K(θ)、D(θ)的一般有效公式 ,而采用与实际相差甚远的定值或线性函数假设 ,使成果隐含过多经验成分或需要反复迭代计算。笔者在文献 [1]中提出的非饱和土壤水分特性函数的一般有效基础公式 ,用分离变量法直接求解Richards方程 ,用土壤水动力学方法分别导出了含有渗前土湿因子的新入渗公式。它摆脱了同类入渗公式对水分函数过于简单的概化假设和经验成分。为放弃迄今水文学产流计算中惯用的下渗容量曲线“截首留尾”的经验做法 ,以直接使用含有渗前土湿因子的下渗公式提供了理论依据 ,从而将有利于产流计算方法的改进和计算精度的提高。     

Urban stormwater thermal gene expression models for protection of sensitive receiving streams

Thermal impact of typical high‐density residential, industrial, and commercial land uses is a major concern for the health of aquatic life in urban watersheds, especially in smaller, cold, and cool‐water streams. This is the first study of its kind that provides simple easy‐to‐use equations, developed using gene expression programming (GEP) that can guide the assessment and the design of urban stormwater management systems to protect thermally sensitive receiving streams. We developed 3 GEP models using data collected during 3 years (2009–2011) from 4 urban catchments; the first GEP model predicts event mean temperature at the inlet of the pond; the second model predicts the stormwater temperature at the outlet of the pond; and the third model predicts the temperature of the stormwater after flowing through a cooling trench and before discharging to the receiving stream. The new models have high correlation coefficients of 0.90–0.94 and low prediction uncertainty of less than 4% of the median value of the predicted runoff temperatures. Sensitivity analysis shows that climatic factors have the highest influence on the thermal enrichment followed by the catchment characteristics and the key design variables of the stormwater pond and the cooling trench. The general method presented here is easily transferable to other regions of the world (but not necessarily the exact equations developed here); also through sensitivity and parametric analysis, we gained insight on the key factors and their relative importance in modelling thermal enrichment of urban stromwater runoff.     

Contrasting hydrological response of coastal and desert biocrusts

Biocrusts abound in southern Israel, covering the Hallamish dune field near Nizzana (NIZ) in the Negev (mean annual precipitation of 95 mm) and the coast of Nizzanim (NIM) near Ashdod (mean annual precipitation of 500 mm). While the hydrological response of the NIZ crust to natural rain events was thoroughly investigated, no data is available on the hydrological response of the NIM crust. Runoff was monitored in runoff plots during the years 2005–2008, and in addition, sprinkling experiments were carried out on NIM and NIZ crusts. For the evaluation of the possible factors that may control runoff initiation, fine content of the parent material, crust thickness, compressional strength, hydrophobicity, surface microrelief, organic matter, biomass (chlorophyll a and total carbohydrates) and the crust's species composition of NIM were studied and compared to that of NIZ. The data showed that in comparison to the NIZ crust that readily generated runoff, no runoff was produced by the NIM crust. This was so despite the fact that (1) Microculeus vaginatus predominated in both crusts, (2) the substantially higher rain intensities in NIM, (3) the greater thickness and higher chlorophyll content and (4) the lower microrelief at NIM in comparison to NIZ. The lack of runoff in NIM was explained by its low amounts of exopolysaccharides that did not suffice to affectively clog the surface and in turn to facilitate runoff initiation. The absence of runoff and its consequences on the NIM ecosystem are discussed. Copyright © 2012 John Wiley & Sons, Ltd.     

Development of a soil moisture‐based distributed hydrologic model for determining hydrologically based critical source areas

A simple grid cell‐based distributed hydrologic model was developed to provide spatial information on hydrologic components for determining hydrologically based critical source areas. The model represents the critical process (soil moisture variation) to run‐off generation accounting for both local and global water balance. In this way, it simulates both infiltration excess run‐off and saturation excess run‐off. The model was tested by multisite and multivariable evaluation on the 50‐km² Little River Experimental Watershed I in Georgia, U.S. and 2 smaller nested subwatersheds. Water balance, hydrograph, and soil moisture were simulated and compared to observed data. For streamflow calibration, the daily Nash‐Sutcliffe coefficient was 0.78 at the watershed outlet and 0.56 and 0.75 at the 2 nested subwatersheds. For the validation period, the Nash‐Sutcliffe coefficients were 0.79 at the watershed outlet and 0.85 and 0.83 at the 2 subwatersheds. The per cent bias was less than 15% for all sites. For soil moisture, the model also predicted the rising and declining trends at 4 of the 5 measurement sites. The spatial distribution of surface run‐off simulated by the model was mainly controlled by local characteristics (precipitation, soil properties, and land cover) on dry days and by global watershed characteristics (relative position within the watershed and hydrologic connectivity) on wet days when saturation excess run‐off was simulated. The spatial details of run‐off generation and travel time along flow paths provided by the model are helpful for watershed managers to further identify critical source areas of non‐point source pollution and develop best management practices.     

Experimental characterization of the impact of temperature and humidity on the breakdown of soil water repellency in sandy soils and composts

Soil water repellency is a widespread phenomenon with the capacity to alter hydrological and geomorphological processes. Water repellency decays with time, and the consequences are only of concern during the timescale at which the water repellency persists. This study aimed to characterize the influence of temperature and humidity on the breakdown of water repellency. Apparent contact angle measurements were carried out on samples consisting of sand treated with stearic acid as well as naturally repellent dune sands and composts. Temperature and humidity were controlled using a cooled incubator and a purpose designed enclosed box in which humidity could be raised or lowered. Results showed the contact angle of the stearic‐acid‐treated sands decayed with time and that there was a significant increase with stearic acid concentration. For all samples, the decay in apparent contact angle could be described with a continuous breakdown model. The stearic‐acid‐treated sands showed a significant increase in contact angle with relative humidity at a temperature of 10 and 20 °C. These differences diminished with increasing temperature. Similar results were seen for the dune sands and composts. Despite the influence of temperature and humidity on contact angles, there was no significant change in the rate at which the contact angle decayed in any sample. Absolute humidity was found to provide a more relevant indicator than relative humidity when assessing the influence of humidity on repellency over a range of temperatures. The contact angle initially increased with absolute humidity before plateauing owing to the confounding effect of temperature. Copyright © 2014 John Wiley & Sons, Ltd.     

Seasonal variations in infiltrability of moss‐dominated biocrusts on aeolian sand and loess soil in the Chinese Loess Plateau

Biocrust effects on soil infiltration have attracted increasing attention in dryland ecosystems, but their seasonal variations in infiltrability have not yet been well understood. On the Chinese Loess Plateau, soil infiltrability indicated by saturated hydraulic conductivity (K_s) of biocrusts and bare soil, both on aeolian sand and loess soil, was determined by disc infiltrometer in late spring (SPR), midsummer (SUM), and early fall (FAL). Then their correlations with soil biological and physiochemical properties and water repellency index (RI) were analysed. The results showed that the biocrusts significantly decreased K_s both on sand during SPR, SUM, and FAL (by 43%, 66%, and 35%, respectively; P < .05) and on loess (by 42%, 92%, and 10%, respectively; P <.05). As compared with the bare soil, the decreased K_s in the biocrusted surfaces was mostly attributed to the microorganism biomass and also to the increasing content of fine particles and organic matter. Most importantly, both the biocrusts and bare soil exhibited significant (F ≥ 11.89, P ≤ .003) seasonal variations in K_s, but their patterns were quite different. Specifically, the K_s of bare soil gradually decreased from SPR to SUM (32% and 42% for sand and loess, respectively) and FAL (29% and 39%); the K_s of biocrusts also decreased from SPR to SUM (59% and 92%) but then increased in FAL (36% and 588%). Whereas the seasonal variations in K_s of the biocrusts were closely correlated with the seasonal variations in RI, the RI values were not high enough to point at hydrophobicity. Instead of that, the seasonal variations of K_s were principally explained by the changes in the crust biomass and possibly by the microbial exopolysaccharides. We conclude that the biocrusts significantly decreased soil infiltrability and exhibited a different seasonal variation pattern, which should be carefully considered in future analyses of hydropedological processes.     

Quantification of river water infiltration in shallow aquifers using acesulfame and anthropogenic gadolinium

This study has investigated the use of the artificial sweetener acesulfame and the magnetic resonance imaging contrast agent gadolinium as quantitative tracers for river water infiltration into shallow groundwater. The influence of a river on alluvial groundwater in a subalpine catchment in western Europe has been assessed using the ‘classical’ hydrochemical tracer chloride and the trace contaminants acesulfame and anthropogenic gadolinium. Mixing ratios for riverine bank filtrate with ambient groundwater and the uncertainties associated with the temporal and spatial tracer variability were calculated using acesulfame and gadolinium and compared with those obtained using chloride. The temporal variability of tracer concentrations in river water of gadolinium (standard deviation SD: 63%) and acesulfame (SD: 71%) both exceeded that of chloride (SD: 27%), and this was identified as the main source of uncertainty in the mixing analysis. Similar spatial distributions were detected in the groundwater for chloride and gadolinium, but not for acesulfame. Mixing analyses using acesulfame resulted in calculated mixing ratios that differed from those obtained using gadolinium and chloride by up to 83% and 92%, respectively. At the investigated site, which had oxic conditions and moderate temperatures, acesulfame was found to be a less reliable tracer than either gadolinium or chloride, probably because of natural attenuation and input from other sources. There was no statistically significant difference between the mixing ratios obtained using chloride or gadolinium, the mixing ratios obtained using gadolinium were 40–50% lower than those obtained using chloride. This is mainly due to a bias of the mean gadolinium concentration in river water towards higher values. In view of the uncertainties of the two tracers, neither could be preferred over the other for the quantification of bank filtrate in groundwater. At this specific site gadolinium was able to reliably identify river water infiltration and was a more precise tracer than chloride at low mixing ratios (<20%), because of the exclusive occurrence of gadolinium in river water and its high dynamic range. Copyright © 2015 John Wiley & Sons, Ltd.