REVIEWS OF GEOGRAPHIC SOFTWARE

Reviews of geographic software in this article: DEMO-GRAPHICS: WORLD POPULATIONS AND PROJECTIONS. ESP GAUSS. CEMODEL S. Damus LIMDEP. William H. Greene MICROSTAT 4.1 OTIS PCIPS. (Personal Computer Image Processing System) . H.J. Meyers and R. Bernstein. REGRESSION ANALYSIS OF TIME SERIES (RATS) SPSS/PC+ URBAN DATA MANAGEMENT SOFTWARE (UDMS)     

Sediment transport in analogue flume models compared with real‐world sedimentary systems: a new look at scaling evolution of sedimentary systems in a flume

Evolution of sedimentary systems at large temporal and spatial scales cannot be scaled down to laboratory dimensions by conventional hydraulic Froude scaling. Therefore, many researchers question the validity of experiments aiming to simulate this evolution. Yet, it has been shown that laboratory experiments yield stratigraphic responses to allocyclic forcing that are remarkably similar to those in real‐world prototypes, hinting at scale independency with strong dependence on boundary conditions but weak dependence on the actual sediment transport dynamics. This paper addresses the dilemma by contrasting sediment transport rules that apply in the laboratory with those that apply in real‐world geological systems. It is demonstrated that the generation of two‐dimensional stratigraphy in a flume can be simulated numerically by the non‐linear diffusion equation. Sediment transport theory is used to demonstrate that only suspension‐dominated meandering rivers should be simulated with linear diffusion. With increasing grain‐size (coarse sand to gravel) and shallowness of river systems, the prediction of long‐term transport must be simulated by non‐linear, slope‐dependent diffusion to allow for increasing transport rates and thus change in stratigraphic style. To point out these differences in stratigraphic style, three stages in infill of accommodation have been defined here: (i) a start‐up stage, when the system is prograding to base level (e.g. the shelf edge) with no sediment flux beyond the base‐level point; (ii) a fill‐up stage, when the system is further aggrading while progressively more sediment is bypassing base level with the progression of the infill; and (iii) a keep‐up stage, when more than 90% of the input is bypassing the base level and less than 10% is used for filling the accommodation. By plotting the rate of change in flux for various degrees of non‐linearity (varying the exponent in the diffusion equation) it was found that the error between model and real‐world prototype is largest for the suspension‐dominated prototypes, although never more than 30% and only at the beginning of the fill‐up stage. The error reduces to only 10% for the non‐linear sandy‐gravelly and gravelly systems. These results are very encouraging and open up ways to calibrate numerical models of sedimentary system evolution by such experiments.     

Morphological analysis of the drainage system in the Eastern Alps

We study the morphology of the major rivers draining the Eastern Alps to test whether the active tectonics of this part of the orogen is reflected in the shape of channel profiles of the river network. In our approach we compare channel profiles measured from digital elevation models with numerically modelled channel profiles using a stream power approach. It is shown that regions of high stream power coincide largely with regions of highest topography and largest uplift rates, while the forelands and the Pannonian Basin are characterised by a significantly lower stream power. From stream power modelling we conclude that there is young uplift at the very east of the Eastern Alps, in the Bohemian Massif and in the Pohorje Range. The impact of the Pleistocene glaciations is explored by comparing properties of rivers that drain in proximal and distal positions relative to the ice sheet during the last glacial maximum. Our analysis shows that most knick points, wind gaps and other non-equilibrium features of catchments covered by ice during the last glaciations (Salzach, Enns) can be correlated with glacial processes. In contrast the ice free catchments of the Mur and Drava are characterized by channels in morphological equilibrium at the first approximation and are showing only weak evidence of the strong tectonic activity within these catchments. Finally, the channel profiles of the Adige and the divide between the upper Rhine and Danube catchments differ significantly from the other catchments. We relate this to the fact that the Adige and the Rhine respond to different base levels from the remainder of the Eastern Alps: The Adige may preserve a record from the Messininan base level change and the Rhine is subject to the base level lowering in the Rhine Graben.     

Groundwater flow and contaminant transport modelling at an air weapons range

Numerical modelling was done at the Cold Lake Air Weapons Range, Canada, to test whether the dissolved RDX and nitrate detected in groundwater come from the same sources, and to predict whether contamination poses a threat to the surface water receptors near the site. Military live fire training activities may indeed pose a risk of contamination to groundwater resources, however field investigations on military bases are quite recent, and little information is available on the long-term behaviour of munition residues related contaminants. Very limited information was available about the contaminant source zones, which were assigned based on our knowledge of current training activities. The RDX plume was well represented with the model, but the heterogeneous distribution of nitrate concentrations was more difficult to reproduce. It was nonetheless determined that both contaminants originate from the same areas. According to the model, both contaminants should reach the nearby river, but concentrations in the river should remain very low if the source zone concentration does not change. Finally, the model allowed the recommendation of a new location for the main bombing target, which would offer added protection to the river and the lake into which it flows.     

Assessing soil erosion in Mediterranean karst landscapes of Lebanon using remote sensing and GIS

Maps showing the potential for soil erosion at 1:100,000 scale are produced in a study area within Lebanon that can be used for evaluating erosion of Mediterranean karstic terrain with two different sets of impact factors built into an erosion model. The first set of factors is: soil erodibility, morphology, land cover/use and rainfall erosivity. The second is obtained by the first adding a fifth factor, rock infiltration. High infiltration can reflect high recharge, therefore decreasing the potential of surface runoff and hence the quantity of transported materials. Infiltration is derived as a function of lithology, lineament density, karstification and drainage density, all of which can be easily extracted from satellite imagery. The influence of these factors is assessed by a weight/rate approach sharing similarities between quantitative and qualitative methods and depending on pair-wise comparison matrix.The main outcome was the production of factorial maps and erosion susceptibility maps (scale 1:100,000). Spatial and attribute comparison of erosion maps indicates that the model that includes a measure of rock infiltration better represents erosion potential. Field investigation of rills and gullies shows 87.5% precision of the model with rock infiltration. This is 17.5% greater than the precision of the model without rock infiltration. These results indicate the necessity and importance of integrating information on infiltration of rock outcrops to assess soil erosion in Mediterranean karst landscapes.     

基于霍顿下渗能力曲线的流量过程线连续分割方法研究

在用前期影响雨量代替流域蓄水量的基础上,提出了基于霍顿下渗能力曲线的流量过程线的连续分割方法.选择西峡、猴子岩和东湾三个流域的降雨径流资料,采用该方法对流量过程线进行分割,并与现行的数字滤波法、非线性水库法和Boussinesq方程法相比较.结果表明,该方法具有一定的物理基础、符合产汇流基本规律,而且能够减少涨洪段流量过程线分割的主观性,对于流域时段单位线和降雨径流关系的推求均有重要的意义.     

Three-dimensional Layer-integrated Modelling of Estuarine Flows with Flooding and Drying

Details are given of the refinement and application of a thee-dimensional (3-D) layer-integrated numerical model of tidal circulation, with the aim of simulating severe tidal conditions for practical engineering applications. The mode splitting strategy has been used in the model. A set of depth-integrated 2-D equations are first solved to give the pressure gradient, and the layer-integrated 3-D equations are then solved to obtain the vertical distributions of the flow velocities. Attention has been given to maintaining consistency of the physical quantities derived from the 2-D and 3-D equations. A TWO=layer mixing length turbulence model for the vertical shear stress distribution has been included in the model. Emphasis has been focused on applying the model to a real estuary, which is geometrically complicated and has large tidal ranges giving rise to extensive flooding and drying. The model has been applied to three examples, including: wind-driven flow in a rectangular lake, tidal circulation in a model rectangular harbour, and tidal circulation in a large estuary. Favourable results have been obtained for both the simple and complex flow beds.     

Ensuring confidence in radionuclide-based sediment chronologies and bioturbation rates

Sedimentary records of naturally occurring and fallout-derived radionuclides are widely used as tools for estimating both the ages of recent sediments and rates of sedimentation and bioturbation. Developing these records to the point of data interpretation requires careful sample collection, processing, analysis and data modeling. In this work, we document a number of potential pitfalls that can impact sediment core records and their interpretation. This paper is not intended as an exhaustive treatment of these potential problems. Rather, the emphasis is on potential problems that are not well documented in the literature, as follows: (1) the mere sampling of sediment cores at a resolution that is too coarse can result in an apparent diffusive mixing of the sedimentary record at rates comparable to diffusive bioturbation rates observed in many locations; (2) ²¹⁰Pb profiles in slowly accumulating sediments can easily be misinterpreted to be driven by sedimentation, when in fact bioturbation is the dominant control. Multiple isotopes of different half lives and/or origin may help to distinguish between these two possible interpretations; (3) apparent mixing can occur due simply to numerical artifacts inherent in the finite difference approximations of the advection diffusion equation used to model sedimentation and bioturbation. Model users need to be aware of this potential problem. Solutions to each of these potential pitfalls are offered to ensure the best possible sediment age estimates and/or sedimentation and bioturbation rates can be obtained.