大功率激电测深法寻找焦家式深部金矿床的试验应用研究

利用大功率的激电测深法可以寻找焦家式深部金 矿。首先,由物理和数学推导建立多层极化体的数 理模型,其数理模型产生的极化场可由多层若干 个极化单元场相叠加而成。由多次去除极化单元 场的原理而导出大功率激电测深资料进行消除浅 部强激电干扰异常的数据处理公式,从而突出了 深部矿床的激电异常。并利用处理后的激电测深 曲线,定量求取了深部金矿蚀变矿化带的顶界面 埋深。     

Influence of transducer-ground coupling on vibration measurements

Various methods of transducer mounting provide varying degrees of coupling between the transducer and the measurement surface. The influence of four of these methods on vibration measurements was studied. For this purpose, the first transducer was placed freely on a horizontal surface, the second one was 'sandbagged', the third one was 'spiked' and the fourth one was completely buried in soil. These transducers were mounted side by side and ground vibrations were monitored for 14 blasts at an opencast coal mine.

Ground vibrations in terms of peak particle velocity, peak vector sum and frequency with different mounting methods were analysed. Assuming the data of the buried transducer as the most acceptable one, relative values of other transducers were determined and plotted. For the given tolerance for instrumental and human errors, anomalous readings were found in some cases. The waveforms of the buried transducer were then compared with those of others. Clear distortion in the waveforms or a very low correlation coefficient between two waveforms was suspected poor coupling.

The results indicate that decoupling is most likely with the surface transducer. However, the sandbagged and spiked transducers are also prone to decoupling. Decoupling can result in higher or lower ground vibration. Therefore, burial should be the preferred method for mounting of transducers in soil.     

Vertical vibration of a rigid strip footing on viscoelastic half-space

This paper presents an analytical method for modeling the dynamic response of a rigid strip footing subjected to vertical-only loads. The footing is assumed to rest on the surface of a viscoelastic half-space; therefore, effects of hysteretic soil damping on the impedance of the foundation and the generated ground vibrations are considered in the solution. To solve the mixed boundary value problem, we use the Fourier transform to cast a pair of dual integral equations providing contact stresses, which are solved by means of Jacobi orthogonal polynomials. The resulting soil and footing displacements and stresses are obtained by means of the Fourier inverse transform. The solution provides more realistic estimates of footing impedance, compared to existing solutions for elastic soil, as well as of the attenuation of ground vibrations with distance of the footing. The latter is important for the estimation of machine vibration effects on nearby structures and installations.     

Large Eddy Simulation on Interaction Between in-Line and Cross-Flow Oscillation of A Circular Cylinder

This paper discusses numerical results from three-dimensional large eddy simulations of an oscillating cylinder under prescribed movements in uniform flow. Six cases,namely pure in-line,pure cross-flow and two groups of 'Figure of Eight' oscillation patterns are under investigation at Reynolds number Re=24000. The 'Figure of Eight' pattern in each group is with identical shape but opposite orbital directions. The numerical results on hydrodynamic forces,higher order force components,and vortex shedding mode...     

激发极化法在辽宁本溪某矽卡岩型铜多金属矿勘查中的应用

测区燕山期大面积中酸性岩浆侵入寒武系、奥陶系碳酸盐岩,在岩体外接触带上形成大量的矽卡岩,并伴有较强烈的铜多金属矿化。本次物探工作在1∶5万区调工作基础上,采用激电中梯与激电测深两种方法进行金属矿产勘查,圈定激电异常12个,反演了穿过JD3、JD7、JD8高极化异常体的形态,规模及埋深,并解译隐伏断裂2条。结合区内地质特征与钻孔资料,认为异常区的低阻高极化体是岩体外接触带上矽卡岩化蚀变带的反映,断裂为矿液运移、容矿提供了有利条件。该研究成果表明,激发极化法是寻找矽卡岩型铜多金属矿的有效方法。     

荆江三口分流变化及三峡水库蓄水影响

长江中游荆江的水沙通过三口洪道分流入洞庭湖,三口分流是荆江-洞庭湖关系调整的驱动因子,为揭示其变化特征及三峡工程运用的影响,基于大量的原观数据,系统研究了近60年三口分流比的变化过程,提出其显著调整特征及诱发因素,引入径流还原计算方法,量化了三峡水库不同运用方式对三口分流量的影响幅度。结果表明:①特大洪水及重大人类活动等诱发因素作用下,三口分流比出现4~5年持续性减小的趋势调整期,之后进入分流比稳定恢复的平衡调整期;②2003-2014年,三峡水库汛前枯水补偿调度使得三口分流量年均增加8.000亿m3,汛后蓄水使得三口分流量年均减小29.00亿m3,对三口分流综合影响量为年均减少21.00亿m3,占同期三口年均分流量的4.29%。     

Experimental investigation of the effects of the coverage of helical strakes on the vortex-induced vibration response of a flexible riser

The effects of different helical strake coverage on the vortex-induced vibration (VIV) of a model flexible riser were studied experimentally, with the aim of further improving the understanding of VIV responses. Uniform and linearly sheared currents were simulated to study response parameters such as non-dimensional displacement, fatigue damage, suppression efficiency, and the comprehensive evaluation is further studied. Test results of the bare model for a uniform current showed that the behavior of both the standing wave and traveling wave dominated VIV displacement. However, for a linearly sheared current, traveling wave behavior dominated VIV displacement in the high-velocity range. The results of the straked model tests indicated that the response was strongly dependent upon the amount of coverage of helical strakes. The flexible riser with 75% strake coverage gave the best comprehensive evaluation in a uniform current, and 50% strake coverage gave the best comprehensive evaluation in a linearly sheared current.     

Development of Prebored Screw Pile Method and Evaluation of Its Bearing Characteristics

The pile-driving method produces considerable noise and vibrations. Hence, an auger-drilled pile method was developed as a low-noise and -vibration substitute. However, this method does not guarantee the bearing capacity of the pile unless some amount of pile-driving is performed. Therefore, the noise and vibration problems cannot be completely solved. In this study, a prebored screw pile method is proposed to solve these problems. In this method, piles are constructed by the rotary penetration of a screw pile into a prebored hole filled with some cement milk and whose diameter is smaller than that of the screw pile. To determine the shape of the screw pile, laboratory tests with model screw piles were conducted. Also, field load tests were conducted on an actual screw pile fabricated based on the laboratory test result and on a smooth-surfaced pile. In addition, the behavior of the screw pile was estimated by using three-dimensional finite element analysis. The results of the field load test and the numerical simulation showed that the ultimate bearing capacity and the unit skin friction of the screw pile are very superior to those of the smooth-surfaced pile and the cement milk is an important factor in the prebored screw pile method.     

圆回线和矩形回线源瞬变电磁响应差异性计算

在回线源瞬变电磁发展的早期,往往使用圆回线产生的场来近似模拟多边形回线的场。为了对这种近似的影响进行分析,本文以矩形回线为例,对圆回线近似模拟多边形回线的误差进行计算。首先,根据给出的圆回线和矩形回线内外任一点的感生电动势新的计算方法,对两种回线装置内的感生电动势分布进行对比。研究结果表明:在扩散场早期,圆回线和矩形回线场的等值线分布形态存在较大的差别,而在扩散场中晚期,两种回线感生电动势相对误差较小。两种回线感生电动势相对误差的变化特征可以用感应电流烟圈扩散的理论进行解释。通过理论模型的分析可知,圆回线近似矩形回线会对浅层电性结构分析带来较大影响。