Snow loads on wire mesh and cable net rockfall slope protection systems

Snow load on mesh systems is complicated by many factors. This paper presents field instrumentation data on snow load variation with temperature, snowfall and snow depth on a mesh system. It was found that snow load pattern on mesh systems changed with temperature even without variation in snow depth. It reached its maximum value when the temperature rose just above freezing to melt the interface. The field data was used to formulate appropriate snow load models for the various conditions of temperature in the field. The snow load models were used to study the performance of a number of mesh systems in North America and estimate the interface friction that was prevalent for the different surface conditions.     

Moving boulders in flash floods and estimating flow conditions using boulders in ancient deposits

Boulders moving in flash floods cause considerable damage and casualties. More and bigger boulders move in flash floods than predicted from published theory. The interpretation of flow conditions from the size of large particles within flash flood deposits has, until now, generally assumed that the velocity (or discharge) is unchanging in time (i.e. flow is steady), or changes instantaneously between periods of constant conditions. Standard practice is to apply theories developed for steady flow conditions to flash floods, which are however inherently very unsteady flows. This is likely to lead to overestimates of peak flow velocity (or discharge). Flash floods are characterised by extremely rapid variations in flow that generate significant transient forces in addition to the mean‐flow drag. These transient forces, generated by rapid velocity changes, are generally ignored in published theories, but they are briefly so large that they could initiate the motion of boulders. This paper develops a theory for the initiation of boulder movement due to the additional impulsive force generated by unsteady flow, and discusses the implications.     

不同近岸河床组成情况下岸坡崩塌试验

在弯道水槽中开展6组试验,分别用非黏性土及黏性土填筑河床,研究相同水力作用下近岸河床组成对黏性岸坡崩塌的影响规律。研究发现,在试验给定的岸坡及河床组成情况下,非黏性河床凹冲凸淤且总体表现为淤积,近岸河床及凹岸岸坡冲刷强度大,凸岸附近床面上泥沙掺混较明显;黏性河床及凹岸岸坡均被冲刷,河床主流区冲刷强度比近岸河床及凹岸岸坡大。相较于黏性河床,非黏性河床近凹岸处较易冲刷,水流结构重新调整,凹岸坡脚处水流流速及紊动能可增至2倍左右,环流强度可增至11倍,加速了岸坡崩塌及崩塌体的分解输移;非黏性河床近凹岸坡脚处变形以及凹岸岸坡崩塌量均相对较大,岸坡崩塌强度为河床淤积强度的2~4倍,崩塌物质可充分补给河床的泥沙来源;经水力冲刷后非黏性河床组成情况下形成的河道滩槽高差相对较小,河道横断面相对宽浅。     

贵州桐梓新桥浑水河的成因再探讨

通过对新桥浑水河上游明流段、中部伏流段、下游浑水河段实地调查,并结合该区1:20万区域地质资料、区域水文地质资料及煤矿勘查资料,在分析浑水河区域构造背景及水文地质特征的基础上,研究了浑水河的水动力条件,包括纵向水动力条件和横向水动力条件,认为浑水河是特殊构造通道、水土流失带来的粘土颗粒物源、携带粘土颗粒的水体进入地下伏流,粘土颗粒在河床中沉积后又被流水带出的一个过程,即"流失→带进→沉积→带出"过程。浑水河的成因:1浑水河的特殊构造,具备了通道条件;2上游水土流失带来的大量细小粘土颗粒提供了物源;3洞湾水体"盲谷"是浑水的物源载体;4地下伏流的水动力条件,包括纵向水动力条件和横向水动力条件,四者共同作用的结果。     

纳米氧化物颗粒对水基钻井液润滑性能影响的试验研究

通过在水基钻井液中添加纳米氧化物颗粒,来改善其润滑性能。选用了Al2O3、TiO2及SiO2三种纳米氧化物颗粒作为钻井液改性添加剂,利用极压润滑仪及销盘摩擦磨损实验仪研究了添加不同种类和浓度纳米颗粒氧化物对水基钻井液的润滑性能及减摩效果的影响。结果表明,所添加的3种球形纳米颗粒均有润滑减阻减摩的效果,其中SiO2颗粒的钻井液的润滑性能、滤失性能以及减摩效果都是最好的。当纳米SiO2颗粒加量为0.4%时,滤失量最小,润滑系数降低率达到15.6%,摩擦系数降低率为32.0%,磨痕轨迹平滑,减摩效果最为明显。当纳米颗粒浓度超过0.5%时,减摩效果降低,磨盘脱层磨损明显。     

Axial friction response of full-scale pipes in soft clays

The axial friction response of subsea pipelines in soft clays is a very important aspect for designers of subsea pipelines but the response is not well understood so far. There is a pressing need for the comprehension of the response. In this paper, model tests are performed using full-scale pipes coated with polyethylene (PE) to study the effects of the set-up period, the pipe diameter, the buried depth of the pipe, the shear strength of soft clays and the loading rate on the axial friction response of pipelines in soft clays. The variations of the axial friction coefficient are analyzed using the effective stress method based on model test results. The results show that the axial friction resistance increases with the increasing pipe diameter but the effect of the pipe diameter on the axial friction coefficient can be neglected. The ultimate axial resistance also increases with the increase of the buried depth of pipelines, the undrained shear strength of soft clays and the loading rate. The axial friction coefficient increases with the increasing loading rate. However, the axial friction coefficient decreases with the increasing buried depth. The method to determine the axial friction coefficient is developed by analyzing model test results, which considers the effects of the diameter, the buried depth, the undrained shear strength of soft clays and the loading rate. The study results not only extend the industry data base but also supply a basis to determine the axial friction coefficient of PE-coated pipes in soft clays for ocean engineering geological investigations.     

高等级海况条件下移动式海上基地动力响应分析

针对半潜式超大型浮式结构中典型的移动式海上基地(Mobile Offshore Base,MOB)在高等级海况下的动力响应问题展开研究。在MOB结构"刚性模块-柔性连接构件(Rigid Modules and Flexible Connectors,RMFC)"模型的前提下,根据动力学基本原理,经理论推导并计算得到MOB分别在6、7、8级海况的随机波激励下,其上各模块的动力响应位移结果。详细分析了MOB结构同一模块在不同海况条件下的动力响应位移随浪向角及连接构件刚度的变化规律。研究成果可为半潜式超大型浮式结构动力响应研究及结构优化设计提供一定的技术支撑。     

活动断裂带岩石的变形机制和摩擦性质—以圣·安德列斯断层为例

岩石的变形机制和力学性质对认识活动断裂带的孕震机制和发震过程都具有重要意义。圣·安德列斯（San Andreas）转换断层是太平洋板块与北美板块的构造边界,也是重要的地震活动带,总结了美国南加州地震中心对圣·安德列斯断层钻孔断层岩的研究进展。对断层泥的高速摩擦实验发现：动力弱化现象只在高速滑移时才发生,伴随着摩擦生热,岩石的摩擦系数显著降低。断层泥中富镁黏土矿物的富集可以显著降低断层的摩擦系数,促进蠕滑,黏土矿物的不均一分布可导致断裂带变形行为和地震分布的突变。与断层泥和碎裂岩不同,粉碎岩形成于快速传播地震的断裂端部,具高孔隙率和高渗透率,流体活动性强。此外,断层岩的有机质成熟度可用来追溯古地震造成的热异常。在川滇中国地震科学实验场开展科学钻探项目,研究断层岩样品的显微结构、物理性质和变形历史,以期为理解大陆汇聚与转换挤压过程中复杂的地震活动提供重要信息。     

射阳港近岸海域沉积物特征及冲淤趋势

海岸是陆地与海洋相互接触和影响的地带,通常指受波浪和潮汐等海洋动力作用的沿岸地带,同时也是人类社会经济发展的重要地带,大型人类工程往往会对其短期地貌变化和沉积物特征产生巨大影响。沉积物粒度分析是研究海洋沉积作用及过程的一个基础的、重要的方法,通过射阳港海岸动力地貌调查,研究了射阳港区不同时期的水下沉积物分布特征,将不同历史时期海图的等深线对海床冲淤变化进行对比分析,认为双导堤完工后导堤口区域出现了明显冲刷,导堤两侧出现淤积,沉积物颗粒变细,表明港口工程等局部影响因素会在短期内显著改变水动力地貌。     

玛湖-盆1井西复合含油气系统二叠系地下水动力场的形成与演化

油气运聚及分布和地下水动力场的形成与演化密切相关,随着盆地的演化,地下水动力场也经历了形成、发展和消亡的过程.对水化学、水动力分布特征研究表明,玛湖-盆1井西复合含油气系统二叠系的现今水动力场由于达巴松凸起而呈现分割性,形成玛湖和盆1井西2个独立的水动力体系,欠压实的存在使凹陷内仍然保持离心流特征,而盆地西北缘则是大气水下渗向心流区.研究区二叠系的水动力场演化具有南移特征.