A Note on Tsunami Bore Front

A note is presented on tsunami bore front. This tsunami bore front is an old dynamical problem but also a new problem to be understood. The tsunami event on 2004 December 26 has raised this is an urgent problem. The author introduces here a model in order to see a hydrodynamical specific property of the tsunami bore front. This modeling gives us a new understanding about what mechanics is for the interested tsunami bore front, especially, around a coastal zone. This work adds a new understanding about mechanics of water motions as the tsunamis generated by the earthquake undersea at a distant area from the coast. The model in this work points out a specific transitional pattern as a function of time and space of tsunami bore front. This modeling gives what is essential at considering tsunami bore front.     

An Experi mental Study on Wave-Induced Dynamic Stresses in Seabed

1 .IntroductionEvery year ,Taiwanis subjectedtotwo or three typhoonintrusions in average which always causedisasters . Most of the disasters which occur around the coastal zone are due to seabed instability andcoastal structure destruction caused bytyphoo…     

高精度CTD剖面仪研制过程中的专用设备

本文介绍了“油水分离压力罐”的主要理论依据及该设备采用的特殊的机械结构，实践证明，利用该设备实现了在实验室条件下，模拟深海重力场检测CTD剖面仪中的某些关键传感器的目的。     

土壤吸湿-湿过程中水力传导度的拟合研究

非饱和含水介质在吸湿和脱湿的不同过程中,水力传导度随介质含水率的变化规律是不同的。本文选取大沽河流域两种代表性砂土,对其吸湿-脱湿两个过程分别进行试验观测,并使用VanGenuchten—Mualem模型对其吸湿-脱湿过程进行水力传导度的拟合。研究结果表明：砂土在吸湿过程的非饱和水力传导度与脱湿过程的非饱和水力传导度大小并不相同,在含水率相同的情况下,吸湿过程的水力传导度要比脱湿过程大,在含水率较低时（小于15％）相差可达1个数量级。     

Regional conductance map of Andaman and Nicobar region

To image the electrical conductivity distribution, fluxgate magnetometers are operated at five sites in Andaman and Nicobar region. Transfer functions are estimated for the period range 8–128 min, from nighttime transient geomagnetic variations, using robust regression analysis. The observed induction arrows in Andaman Islands are found to point towards east despite deep sea located towards its west. This indicates that fore-arc basin (Andaman–Nicobar deep) is more conducting than the region of outer non-volcanic Island arc.Thin sheet model requires the conductance of 10,000–35,000 S (with increase conductivity towards the south) for explaining the observed induction pattern. The observed induction pattern at Andaman–Nicobar stations can be explained in terms of high conducting Cretaceous–Tertiary sediments filling the Andaman–Nicobar deep. High conductivity over Invisible bank has been attributed to the partial melts/volatile fluids derived from the subducting Indian plate that are intruding into the eastern margin of fore-arc basin through the West Andaman Fault (WAF).The induction pattern at Great Nicobar station (Campbell Bay) may be related to the highly conducting sediments filling the Mergui basin along with mafic intrusions. Also crustal transition occurs below the Mergui Terrace at the Malayan coast contributing to the enhanced conductivity anomaly.     

Estimating hydraulic conductivity using grain-size analyses, aquifer tests, and numerical modeling in a riverside alluvial system in South Korea

Hydraulic conductivity (K) for an alluvial system in a riverbank filtration area in Changwon City, South Korea, has been studied using grain-size distribution, pumping and slug tests, and numerical modeling. The alluvial system is composed of layers: upper fine sand, medium sand, lower fine sand, and a highly conductive sand/gravel layer at the base. The geometric mean of K for the sand/gravel layer (9.89?×?10^?4 m s^?1), as determined by grain-size analyses, was 3.33 times greater than the geometric mean obtained from pumping tests (2.97?×?10^?4 m s^?1). The geometric mean of K estimates obtained from slug tests (3.08?×?10^?6 m s^?1) was one to two orders of magnitude lower than that from pumping tests and grain-size analyses. K estimates derived from a numerical model were compared to those derived from the grain-size methods, slug tests and pumping tests in order to determine the degree of deviation from the numerical model. It is considered that the K estimates determined by the slug tests resemble the uppermost part of the alluvial deposit, whereas the K estimates obtained by grain-size analyses and pumping tests are similar to those from the numerical model for the sand/gravel layer of the riverside alluvial system.     

The relationship between zooplankton,conductivity and lake-water ionic composition in 111 lakes from the Interior Plateau of British Columbia,Canada

Zooplankton collected from vertical net tows were related to the environmental variables from 98 lakes from the Interior Plateau of British Columbia. Canonical correspondence analysis showed that both salinity and ionic composition (pH and Mg) of the lake-water made major and significant contributions to the first two ordination axes (=0.42 and 0.11 respectively,P<0.05). BothArtemia franciscana andMoina hutchinsoni had their highest relative abundance in meso-hypersaline waters. However,Artemia franciscana preferred waters that were higher in Mg and Ca, whileMoina hutchinsoni was found in waters that were lower in Mg and Ca. Similarly, at intermediate salinities,Daphnia pulex and the calanoid copepods preferred waters slightly lower in Mg and Ca, whereasCeriodaphnia laticaudata andSimocephalus spp. were relatively more common in waters higher in Mg and Ca. Because the freshest lakes studied varied much less in ionic composition, the zooplankton in these lakes did not show a preference to ionic composition. As expected, multi-generic groups, such as the calanoid copepods, cyclopoid copepods and nauplii, had wider tolerances to conductivity than groups identified to lower taxonomic levels. Significant weighted-averaging regression and calibration models of conductivity were developed based on zooplankton species composition from the study lakes (r ²=0.56,P<0.05). Samples composed largely of multi-generic taxa yielded the worst estimates of salinity in the reconstruction model. This study suggests that zooplankton community composition may be developed into a useful proxy for paleosalinity reconstruction.     

Estimation of statistical parameters for censored lognormal hydraulic conductivity measurements

Field tests of hydraulic conductivity (e.g., injection test, pumping test, etc.) in low permeability formations are subject to censoring due to the detection limit of the instruments used. An iterative method of estimating the mean and variance of hydraulic conductivity data with a presumed log-normal distribution function is presented. This method accounts for the data that are actually below the lower detection limit (called truncated data) and thus gives distribution parameters that are more representative for the underlying distribution. The proposed method is then tested on two simulated normally distributed random datasets having different variances. The results show that the means and variances estimated by the proposed method are very accurate. Finally, the method is used to estimate the mean and variance of hydraulic conductivity data from single hole water injection tests in a fractured geological formation.     

The log-normal distribution for hydraulic conductivity of compacted clays: Two or three parameters?

Risk and uncertainty assessments for waste containment systems employing clay barriers often include spatial variability in the hydraulic conductivity as part of the analysis. The two-parameter log-normal distribution is often used to describe the spatial variability, but for compacted clays the three-parameter form can be more appropriate. A statistical hypothesis test was developed that can be used to determine if the two- or three-parameter form of the log-normal distribution is more appropriate. The test is based on a likelihood ratio, comparing likelihood functions for the two- and three-parameter forms at their maximums. Likelihood functions are used assuming that a data set can be segregated into a set of distinct groups of hydraulic conductivities. A step-by-step calculation procedure is described and the test is applied to data collected from 45 sites.