饱和软土压缩曲线的“反常”现象

饱和软土压缩试验时,经常出现压缩曲线“反常”、压缩系数“倒大”的现象。它是土的原始结构发生破坏前后的不同压缩性的客观反映。饱和软土的结构力很微弱,唯质量好的原状土才能见到这种“反常”。应从成孔、取样、测试及资料整理等多个环节保证其工程意义。     

近45 a来中国西北年极端高、低温的变化及对区域性增暖的响应

利用中国西北五省(区)1960-2004年129个台站逐日最低、最高温度资料,从中统计出年极端高温发生频次、年极端低温发生频次、年极端高温强度、年极端低温强度以及年极端高温和低温开始和结束日期,分析了它们近45 a来的变化情况。结果表明:近45 a来中国西北年极端高温发生频次的增加趋势是明显的,而年极端低温发生频次的减少趋势更显著;中国西北近45 a来年极端高温的强度在不断增强,而极端低温的强度在不断减弱;近45 a来中国西北年极端高温开始日期逐渐提前,结束日期逐渐推迟,而年极端低温的开始日期在逐渐推迟,结束日期在逐渐提前;年极端低温发生频次的减少对于西北区域增暖的响应比年极端高温发生频次增加更显著,而年极端低温强度的减弱要比年极端高温强度的增强对西北区域性增暖的响应偏弱,年极端高温发生频次的增加同年极端高温强度的增强对西北区域性增暖的响应程度基本相当。     

Magnetostratigraphic evidence from the Cold Creek bar for onset of ice-age cataclysmic floods in eastern Washington during the Early Pleistocene

This study provides a detailed magnetostratigraphy of sediments composing the Cold Creek cataclysmic flood bar in the Pasco Basin, Washington. Our interpretation suggests onset of Missoula floods or similar events prior to 1.1 myr, later than previously suggested by Bjornstad et al. [Bjornstad, B.N., Fecht, K.R., Pluhar, C.J., 2001. Long history of pre-Wisconsin, Ice Age cataclysmic floods: evidence from southeastern Washington State. Journal of Geology 109 (6), 695-713]. Nonetheless these data suggest that Channeled Scabland features formed over a much longer timespan than commonly cited, that continental ice sheets of the early Pleistocene reached as far south as those of the late Pleistocene, and that similar physiography existed in eastern Washington and perhaps Montana to both generate and route Missoula-flood-like events. This study adds paleomagnetic polarity results from 213 new samples of silts and sands derived from nine new drill cores penetrating the Cold Creek cataclysmic flood bar to our previous database of 53 samples from four boreholes, resulting in a much more robust and detailed magnetostratigraphy. Rock magnetic studies on these sediments show pure magnetite to be the predominant remanence-carrying magnetic mineral, ruling out widespread remagnetization by secondary mineralization. The magnetostratigraphy at eastern Cold Creek bar is characterized by a normal polarity interval bracketed by reversed polarities. Equating the normal zone with the Jaramillo subchron (0.99-1.07 myr) affords the simplest correlation to the magnetic polarity timescale. Western Cold Creek bar was likely deposited during the Brunhes chron (0-0.78 myr) since it exhibits mainly normal polarities with only two thin reversed-polarity horizons that we interpret as magnetic excursions during the Brunhes.     

Strength and stability of frictional sliding of gabbro gouge at elevated temperatures

To investigate the strength of frictional sliding and stability of mafic lower crust, we conducted experiments on oven-dried gabbro gouge of 1 mm thick sandwiched between country rock pieces (with gouge inclined 35° to the sample axis) at slip rates of 1.22 × 10^− 3 mm/s and 1.22 × 10^− 4 mm/s and elevated temperatures up to 615 °C. Special attention has been paid to whether transition from velocity weakening to velocity strengthening occurs due to the elevation of temperature.Two series of experiments were conducted with normal stresses of 200 MPa and 300 MPa, respectively. For both normal stresses, the friction strengths are comparable at least up to 510 °C, with no significant weakening effect of increasing temperature. Comparison of our results with Byerlee's rule on a strike slip fault with a specific temperature profile in the Zhangbei region of North China shows that the strength given by experiments are around that given by Byerlee's rule and a little greater in the high temperature range.At 200 MPa normal stress, the steady-state rate dependence a − b shows only positive values, probably still in the “run-in” process where velocity strengthening is a common feature. With a normal stress of 300 MPa, the values of steady-state rate dependence decreases systematically with increasing temperature, and stick-slip occurred at 615 °C. Considering the limited displacement, limited normal stress applied and the effect of normal stress for the temperatures above 420 °C, it is inferred here that velocity weakening may be the typical behaviour at higher normal stress for temperature above 420 °C and at least up to 615 °C, which covers most of the temperature range in the lower crust of geologically stable continental interior. For a dry mafic lower crust in cool continental interiors where frictional sliding prevails over plastic flow, unstable slip nucleation may occur to generate earthquakes.     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

Effects of dynamic shear strength and time-histories stress analysis on newmark sliding block analyses

A simplified procedure for evaluating aseismic stability of slope subjected to earthquake shaking, in which the effect of dynamic shear strength and time-history stress on the yielding angular acceleration of sliding block is taken into account, is presented. The fundamental feature of this procedure is the dynamic shear strength. The numerical computations are performed by using the proposed method. It is shown that the computed sliding displacement for a given core dam, with either method of dynamic shear strength properly considered, is more rational compared with the conventional computational results based on static shear strength.     

Early Jurassic rift structures associated with the Soapaga and Boyacá faults of the Eastern Cordillera, Colombia: Sedimentological inferences and regional implications

The NW-trending Bucaramanga fault links, at its southern termination, with the Soapaga and Boyacá faults, which by their NW trend define an ample horsetail structure. As a result of their Neogene reactivation as reverse faults, they bound fault-related anticlines that expose the sedimentary fill of two Early Jurassic rift basins. These sediments exhibit the wedge-like geometry of rift fills related to west-facing normal faults. Their structural setting was controlled further by segmentation of the bounding faults at approximately 10 km intervals, in which each segment is separated by a transverse basement high. Isopach contours and different facies associations suggest these transverse anticlines may have separated depocenters of their adjacent subbasins, which were shaped by a slightly different subsidence history and thereby decoupled. The basin fill of the relatively narrow basin associated with the Soapaga fault is dominated by fanglomeratic successions organized in two coarsening-upward cycles. In the larger basin linked to the Boyacá fault, the sedimentary fill consists of two coarsening-upward sequences that, when fully developed, vary from floodplain to alluvial fan deposits. These Early Jurassic rift fills temporally constrain the evolution of the Bucaramanga fault, which accommodated right-lateral displacement during the early Mesozoic rift event.     

预应力锚索在公路高陡边坡加固整治工程中的应用

预应力锚索锚固技术以其结构合理、工艺灵巧、适应性广、施工速度快、造价低等优势，目前已广泛应用于各工程领域。在桂（林）—柳（州）高速公路高边坡加固工程中采用了该项技术，经过近1年的运转表明，效果良好。对该项工程作了详细讨论，介绍了边坡的地质条件、稳定性分析和设计参数的选取，总结了施工中锚索的造孔、下索、注浆、张拉锁定等设计及施工要点。     

广州科学城保利林语山庄高边坡支护工程的实践

主要介绍了广州科学城保利林语山庄高边坡支护设计方案与施工方法。支护方案综合采用了锚索、锚杆、抗滑桩、钢管桩、格构梁及挡土墙等多种支护方法，有效地提高了边坡的稳定性。应用有限元方法来验证设计方案的合理性，模拟结果与工程实践基本吻合。     

High resolution profiles of trace metals in pore waters of marine and riverine sediments assessed by DET and DGT

In polluted aquatic systems, toxic metals are often accumulated in bottom sediments. They are, however, not necessarily stored definitively because diagenetic processs can modify redox, pH and even the amount of complexing ligands, releasing the trace metals back into the pore waters and the water column. Especially the labile metal fraction in the pore waters is important since this is the bioavailable fraction determining the bio-toxicity of the sediments. The goal of our study was therefore to assess, with novel sampling techniques, this bioavailable metal fraction in the pore waters as well as the flux towards the overlying water column. High-resolution profiles of trace metals in pore waters of marine and riverine sediments were assessed by DET （diffusive equilibrium in thin films） and DGT （diffusive gradients in thin films） gel techniques. The DET technique uses a diffusive gel layer that equilibrates with the aquatic system and with this technique the concentrations of total dissolved trace metals are obtained directly. The DGT technique uses an acrylamide diffusive gel backed by a resin gel （Chelex） which binds trace metals. With the DGT technique only labile species of selected metals can be captured. According to the redox potential measurements, the marine sediments were suboxic （200 mV to -220 mV versus Ag/AgCl electrode）, while the riverine sediments were completely anoxic （-160 mV to -220 mV versus Ag/AgCl electrode）. This redox potential was apparently controlling the trace metals species in the pore waters： for example a strong correlation between Mn and Co was found in the riverine sediments （for DET and DGT sampling）, while in the marine sediments trace metals presented various behaviors.