2003年 8月 21-22日辐合气流暴雨天气过程总结

本文综合应用天气图、静止卫星云图、物理量诊断场,分析了 2003年 8月 21～ 22日黑龙江省大范围强降水过程.分析了乌拉尔山阻高、副热带高压和冷暖空气在暴雨天气过程中的作用.得出有预报指示意义的特征.并对日本传真图的降水预报能力进行了检验分析.在暴雨预报中也具有一定的预报意义.     

新疆冰雹天气过程的基本特征

通过对新疆39a冰雹天气资料的普查，得到76次系统性冰雹天气过程和1279次局地冰雹天气过程，局地冰雹天气的发生远远多于系统性雹天气。冰雹天气过程与地形密切相关，主要发生在山区，冰雹天气以1天为主，多发生于夏季，系统性冰雹天气均由中尺度高压造成。     

台风活动对副热带高压位置和强度的影响

利用一个浅水模式，实施了6组时间积分为4－5个模式日的试验，研究了台风对副热带高压中心位置及强度的影响。结果表明：台风和副热带高压的相互作用可以使高压中心位置西移,强度增加。据此讨论了台风活动和西北地区东部干旱之间统计联系的可能机制。     

CLIMATOLOGICAL CHARACTERISTICS FOR THE ONSET OF ASIAN SUMMER MONSOON AS REVEALED BY HIRS-Tb12 AND DROUGHT AND FLOODS IN EASTERN CHINA

As shown in comparison and study of the HIRS-Tb12 data and conventional data, temperature, humidity and vertical motion are structured differently in the Southern and Northern Hemispheres, which are well depicted with the HIRS-Tb12 data. When high pressures rapidly decrease over the regions of South China Sea and Arabian Sea with the HIRS-Tb12 less than 200 W/m2, monsoons will set off in the South China Sea, Arabian Sea and Bay of Bengal, respectively. From a year of significant drought to one of significant floods, the trend of evolution is significantly different in the downdraft areas of the subtropical highs between the two hemispheres.     

静压预制桩工程性状研究──以河南某电厂技改工程为例

以河南某电厂技改工程为例 ,根据现场检测结果 ,探讨了影响静压预制桩沉桩深度成因 ,分析了静压桩承载力的分布规律。研究结果证明静压桩的沉桩深度和承载力与地基土的性状密切相关。对于河南某电厂技改工程场地 ,尽管桩端进入砂较小深度 ,却可以在桩端平面附近良好土层的作用下提供较大的端阻力。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

H2O-CH4-H2-CO2-CO-O2在高温、高压和高密度条件下的状态方程

为了计算高温，高压和高密度流体的热力学性质，提出了一个具有19个参数的维里型状态方程，其中参数与温度间的函数关系采用由Sutherland位能函数导出的维里系数近似式。除临界点附近以外，在已报道的pVT数据所覆盖的大部分超临界区域内，该方程均可适用。用该方程对H2O，CH4，H2，CO2，CO和O2等流体pVT关系的计算结果令人满意，其中pVT上限分别为：91-610GPa,1.6-11.0cm^3/mol,4000-5000K。计算体积的平均偏 小于0．8％，最大偏差小于5．4％。     

三类高强度悬式瓷绝缘子的成分和物相分析

为探讨高原牌70kN和进口120，210kN瓷绝缘子的成分和结构性能，中采用原子吸收光谱（AAS）和X射线衍射（XRD）方法，对三类产品进行了检测。结果表明，有效成分除K2O外，70kN和210kN的SiO2,Al2O3,Fe2O3含量接近，主晶相基本相同，有刚玉，莫来石、石英和长石等；结晶相总量：70kN35%，120kN40%,210kN48%，这表明机械强度愈大，结晶相含量愈高，只需调整70kN原样的部分成分，粒度和工艺，即生产出高等级（如210kN)瓷绝缘子。