气相色谱法测定地下水中六六六结果的不确定度评定

依照《测量不确定度评定与表示》,对气相色谱法测定地下水中六六六(HCH)四种单体结果进行了不确定度评定。分析了测量过程中引入的不确定度来源,包括提取液体积的量取、样品提取溶液的定容体积、分析仪器的进样量、标准系列溶液的测量以及仪器重复测定等分量引入不确定度及其各参数的采集和计算方法,最后合成标准不确定度,通过乘以95%概率下的扩展因子2,获得测量结果的扩展不确定度。     

Occurrence and evolution of the Xiaotangshan hot spring in Beijing, China

Thermal groundwater occurs in bedrock aquifers consisting of the dolomite of the Wumishan Group of the Jixianin System and the Cambrian carbonate in the Xiaotangshan geothermal field near the northern margin of the North China Plain, China. The hot water in the geothermal field of basin-type discharges partly in the form of the Xiaotangshan hot spring under natural conditions. The hot water has TDS of less than 600 mg/L and is of Na·Ca-HCO₃ type. The geothermal water receives recharge from precipitation in the mountain area with elevation of about 500 m above sea level to the north of the spring. Thermal groundwater flows slowly south and southeast through a deep circulation with a residence time of 224 years estimated with the Ra–Rn method. The Xiaotangshan hot spring dried up in the middle of the 1980s owing to the increasing withdrawal of the hot water in the geothermal field in the past decades. The water level of the geothermal system still falls continually at an annual average rate of about 2 m, although water temperature changes very little, indicating that the recharge of such a geothermal system of basin-type is limited. Over-exploitation has a dramatic impact on the geothermal system, and reduction in exploitation and reinjection are required for the sustainable usage of the hot water.     

Phosphorus transport in shallow groundwater in peri-urban Kampala, Uganda: results from field and laboratory measurements

To understand Phosphorus (P) sources and transport processes in the subsurface in Bwaise III Parish, Kampala, P attenuation and adsorption capacities of soils were studied in situ and from laboratory measurements. Relationships between sorption parameters and soil matrix properties, rates and mechanism of the adsorption process and soil P fractions were also investigated. P was generally higher in the wet than the dry season, but for both seasons, the maximum was 5 mgP/l. P transport mechanisms appeared to be a combination of adsorption, precipitation, leaching from the soil media and by colloids with the latter two playing an important role in the wet season. The sorption process comprised two phases with the first stage rate constants being about fourfold those of the second stage. The Langmuir isotherm described the sorption data well (R ² ≥ 0.95) with the second soil layer exhibiting the highest sorption maximum (C _max) (average value 0.6 ± 0.17 mgP/gDW). The best prediction of C _max had organic carbon, Ca, available P and soil pH. Residual P consisting mostly of organics was the main fraction in all the layers followed by inorganic HCl-P and NaOH-P in the top and middle layers, respectively. Loosely bound P (NH₄Cl-P) was the least fraction (<0.4% of total P) in all layers indicating the high binding capacity of P by the soils. The study results suggest that P dynamics is related to Ca, Fe and organic carbon content of the soils.     

Application of MODFLOW and geographic information system to groundwater flow simulation in North China Plain, China

MODFLOW is a groundwater modeling program. It can be compiled and remedied according to the practical applications. Because of its structure and fixed data format, MODFLOW can be integrated with Geographic Information Systems (GIS) technology for water resource management. The North China Plain (NCP), which is the politic, economic and cultural center of China, is facing with water resources shortage and water pollution. Groundwater is the main water resource for industrial, agricultural and domestic usage. It is necessary to evaluate the groundwater resources of the NCP as an entire aquifer system. With the development of computer and internet information technology it is also necessary to integrate the groundwater model with the GIS technology. Because the geological and hydrogeological data in the NCP was mainly in MAPGIS format, the powerful function of GIS of disposing of and analyzing spatial data and computer languages such as Visual C and Visual Basic were used to define the relationship between the original data and model data. After analyzing the geological and hydrogeological conditions of the NCP, the groundwater flow numerical simulation modeling was constructed with MODFLOW. On the basis of GIS, a dynamic evaluation system for groundwater resources under the internet circumstance was completed. During the process of constructing the groundwater model, a water budget was analyzed, which showed a negative budget in the NCP. The simulation period was from 1 January 2002 to 31 December 2003. During this period, the total recharge of the groundwater system was 49,374 × 10⁶ m³ and the total discharge was 56,530 × 10⁶ m³ the budget deficit was −7,156 × 10⁶ m³. In this integrated system, the original data including graphs and attribution data could be stored in the database. When the process of evaluating and predicting groundwater flow was started, these data were transformed into files that the core program of MODFLOW could read. The calculated water level and drawdown could be displayed and reviewed online.     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.     

Numerical modeling of tide-surge interaction along Orissa coast of India

The Orissa coast of India is one of the most vulnerable regions of extreme sea levels associated with severe tropical cyclones. There was extensive loss of life and property due to the October 1999 super cyclone, which devastated large part of the Orissa coast. The shallow nature of the head bay, presence of a large number of deltas formed by major rivers of Orissa such as Mahanadi and Dhamra, and high tidal range are responsible for storm surge flooding in the region. Specifically, rising and falling tidal phases influence the height, duration, and arrival time of peak surge along the coast. The objective of the present study is to evaluate the tide-surge interaction during the 1999 Orissa cyclone by using nonlinear vertically integrated numerical models. The pure tidal solution for the head bay region of the Bay of Bengal provides the initial condition for the fine resolution nested grid Orissa model. However, the feedback from the Orissa model does not affect the head bay model as the study provides a one-way interaction. Numerical experiments are performed to study the tide-surge interaction by considering various relative phases of the tidal waves with the surge-wave produced by 1999 Orissa cyclone. The comparison, although utilizing only the limited estimates of tidal data, appears adequate to assert that the principal features are reproduced correctly.     

Ground motion estimation during the Kashmir earthquake of 8th October 2005

In this article, analytical methods have been used to estimate ground motion during the 8 October 2005, Kashmir earthquake. Peak ground acceleration (PGA) values at several stations in the epicentral region have been estimated by empirical analytical source mechanism models. As an alternate analysis, PGA estimates have also been obtained using the stochastic finite fault seismological model. The estimated PGAs are compared with that obtained from damage values. A PGA contour map in the near-source region is provided. It is found that very near to the epicenter, PGA would have reached more than 1 g. It is demonstrated that empirical analytical models can be effectively used to estimate ground motion due to rupture of active faults.     

Methodology of hydrogeological characterization of deep carbonate aquifers as potential reservoirs of groundwater. Case of study: the Jurassic aquifer of <Emphasis Type="Italic">El Maestrazgo</Emphasis> (Castellón,Spain)

A methodology for the characterization of deep carbonate aquifers has been developed and applied to El Maestrazgo Jurassic aquifer in Castellón, Spain. Characterization of these aquifer formations, located at more than 300 m deep, consisted of a previous phase of compilation, analysis and synthesis of the existing information about the area, followed by a coordinated combination of different speciality studies: geology, stratigraphy, structural analysis, hydrogeology, hydrochemistry, geophysics and remote sensing. Geological studies included geological mapping, definition of stratigraphical units and facies and structural analysis. The aim of the hydrogeology study was to define aquifer formations, recharge area, aquifer points inventory and groundwater flow directions for the establishment of piezometric and water quality observation nets. Special techniques were applied, like thermal infrared aerial images and the evaluation of submarine groundwater discharge by means of natural radium isotopes. Hydrochemical techniques, including majority elements characterization and stable isotopes (¹⁸O, ²H and ³H) determination, allowed classifying hydrochemical facies and establishing a renewal pattern for water within the system. Geophysics was useful in determining the aquifer geometry, the features of the basement and the petrophysical characteristics of the geological formations. Preliminary results show an important tectonic complexity and the possibilities for groundwater uses in the area of study.     

乌鲁木齐河流域地下水水质监测网设计

文章运用地下水易污性编图及污染源分布图法进行了乌鲁木齐河流域地下水水质监测网设计。共设计了130监测孔,现有46个监测孔,另需要84个新的监测孔。按监测类型分为面源监测点22个,点源监测点87个,重点水源地与泉水监测点21个。按监测运行分长期监测点55个,流域普查监测点75个。普查监测点监测频率为1次/5年,长期监测点监测频率为1次/年。首期有针对性地在污染严重的柴窝堡新化厂排污区、乌鲁木齐河谷老排污区、米泉污灌区、米泉工业污染区、老龙河污染区取了25个污染水样测试分析,结果显示地下水已经受到严重污染。