曲线拟合法在地电场资料处理中的应用

地电场和电阻率同场地观测时，电阻率观测会干扰地电场的观测数据发生大幅度变化。本主要探讨通过曲线拟合的方法消除这种干扰及其它随机干扰，并给出了对实际观测数据处理的结果。     

TDP-0844地震前兆数据综合采集器的研制

介绍了TDP—0844型地震前兆数据综合采集器采用的设计方案及工作原理，及各个功能模块的设计准则，并列出了采集器实现的功能。文章还给出了采集器的部分应用图例，证明该采集器能够满足地震前兆观测需要。     

地震前兆仪器嵌入TCP/IP协议的初步试验

根据“十五”总体设计方案的要求，对TCP／IP协议在地震前兆仪器上的实现进行了试验，在有关设备上进行了程序开发，取得了预期的效果。     

Tensor time domain electromagnetic resistivity measurements at Ngatamariki geothermal field, New Zealand

Experimental measurements in the Ngatamariki geothermal field, North Island, New Zealand were made to test the applicability of the time domain electromagnetic method for detailed investigation of the resistivity structure within a geothermal field. Low-frequency square wave signals were transmitted through three grounded bipole current sources sited about 8 km from the measurement lines. Despite high levels of electrical noise, transient electric field vectors could be determined reliably for times between 0.02 and 3.3 s after each step in the source current. Instantaneous apparent resistivity tensors were then calculated. Apparent resistivity pseudosections along the two measurement lines show smooth variations of resistivity from site to site. Over most of the field the images consistently show a three-layer resistivity structure with a conductive middle layer (3–10 Ωm) representing the conductive upper part of the thermal reservoir. A deep-seated region of low resistivity in the northwest of the field may indicate a conductive structure at about 1 km associated with a deeper diorite intrusion. Measurements sited closer than about 100 m to drillholes appear to have been disturbed by metallic casing in the holes. A change in resistivity structure in the east of the field may indicate a major geological or hydrothermal boundary.     

Optimum multiple tuned mass dampers for structures under the ground acceleration based on the uniform distribution of system parameters

The five MTMD models, with natural frequencies being uniformly distributed around their mean frequency, have been recently presented by the first author. They are shown to have the near‐zero optimum average damping ratio (more precisely, for a given mass ratio there is an upper limit on the total number, beyond which the near‐zero optimum average damping ratio occurs). In this paper, the eight new MTMD models (i.e. the UM‐MTMD1～UM‐MTMD3, US‐MTMD1～US‐MTMD3, UD‐MTMD1 and UD‐MTMD2), with the system parameters (mass, stiffness and damping coefficient) being, respectively, uniformly distributed around their average values, have been, for the first time here, proposed to seek for the MTMD models without the near‐zero optimum average damping ratio. The structure is represented by the mode‐generalized system corresponding to the specific vibration mode that needs to be controlled. Through minimization of the minimum values of the maximum dynamic magnification factors (DMF) of the structure with the eight MTMD models (i.e. through the implementation of Min.Min.Max.DMF), the optimum parameters and values of Min.Min.Max.DMF for these eight MTMD models are investigated to evaluate and compare their control performance. The optimum parameters include the optimum mass spacing, stiffness spacing, damping coefficient spacing, frequency spacing, average damping ratio and tuning frequency ratio. The six MTMD models without the near‐zero optimum average damping ratio (i.e. the UM‐MTMD1～UM‐MTMD3, US‐MTMD1, US‐MTMD2 and UD‐MTMD2) are found through extensive numerical analyses. Likewise, the optimum UM‐MTMD3 offers the higher effectiveness and robustness and requires the smaller damping with respect to the rest of the MTMD models in reducing the responses of structures subjected to earthquakes. Additionally, it is interesting to note, by comparing the optimum UM‐MTMD3 with the optimum MTMD‐1 recently investigated by the first author, that the effectiveness and robustness for the optimum UM‐MTMD3 is almost identical to that for the optimum MTMD‐1 (without inclusion of the optimum MTMD‐1 with the near‐zero optimum average damping ratio). Recognizing these performance benefits, it is preferable to employ the optimum UM‐MTMD3 or the optimum MTMD‐1 without the near‐zero optimum average damping ratio, when installing the MTMD for the suppression of undesirable oscillations of structures under earthquakes. Copyright © 2003 John Wiley & Sons, Ltd.     

Evaluation of predictors of non‐linear seismic demands using ‘fishbone’ models of SMRF buildings

Predictors (or estimates) of seismic structural demands that are less computationally time‐consuming than non‐linear dynamic analysis can be useful for structural performance assessment and for design. In this paper, we evaluate the bias and precision of predictors that make use of, at most, (i) elastic modal vibration properties of the given structure, (ii) the results of a non‐linear static pushover analysis of the structure, and (iii) elastic and inelastic single‐degree‐of‐freedom time‐history analyses for the specified ground motion record. The main predictor of interest is an extension of first‐mode elastic spectral acceleration that additionally takes into account both the second‐mode contribution to (elastic) structural response and the effects of inelasticity. This predictor is evaluated with respect to non‐linear dynamic analysis results for ‘fishbone’ models of steel moment‐resisting frame (SMRF) buildings. The relatively small number of degrees of freedom for each fishbone model allows us to consider several short‐to‐long period buildings and numerous near‐ and far‐field earthquake ground motions of interest in both Japan and the U.S. Before doing so, though, we verify that estimates of the bias and precision of the predictor obtained using fishbone models are effectively equivalent to those based on typical ‘full‐frame’ models of the same buildings. Copyright © 2003 John Wiley & Sons, Ltd.     

青藏铁路管道通风试验路基地温变化及热状况分析

基于青藏铁路北麓河试验段管道通风路基在2个冻融循环周期内的地温监测资料，分析了路基温度的发展、温度场分布特征及多年冻土的热流量变化．结果表明：通风管埋设于路堤中部的路基温度变化和发展情况与一般路基类似，路基在施工后的2个冻融周期内仍处于整体升温的过程；通风管埋设于路堤下部的路基，虽然前2个冻融循环周期内土体温度与原始状态相比同样有所升高，但开始出现逐渐降低的趋势，同时地温场的分布在横向上的对称性也比较好，在热交换方面，一般填土路基和通风管位于路堤中部的路基在施工后的前2个冻融循环周期内一直处于吸热过程，而通风管位于路堤下部的路基在经历了第1个周期的持续吸热过程后，在第2个冻融循环周期内已经开始放热。     

电法在濒海及岛屿地区寻找地下淡水中的应用

采用电法的基本原理，研究各种不同岩性和成淡水的电性差畀，划分地下成淡水分界面。在严重缺水的濒海及岛屿地区找到了较好的地下淡水，解决了守岛部队吃水难的问题。     

A hybrid indirect boundary element—discrete wave number method applied to simulate the seismic response of stratified alluvial valleys

A hybrid indirect boundary element – discrete wavenumber method is presented and applied to model the ground motion on stratified alluvial valleys under incident plane SH waves from an elastic half-space. The method is based on the single-layer integral representation for diffracted waves. Refracted waves in the horizontally stratified region can be expressed as a linear superposition of solutions for a set of discrete wavenumbers. These solutions are obtained in terms of the Thomson–Haskell propagators formalism. Boundary conditions of continuity of displacements and tractions along the common boundary between the half-space and the stratified region lead to a system of equations for the sources strengths and the coefficients of the plane wave expansion. Although the regions share the boundary, the discretization schemes are different for both sides: for the exterior region, it is based on the numerical and analytical integration of exact Green's functions for displacements and tractions whereas for the layered part, a collocation approach is used. In order to validate this approach results are compared for well-known cases studied in the literature. A homogeneous trapezoidal valley and a parabolic stratified valley were studied and excellent agreement with previous computations was found. An example is given for a stratified inclusion model of an alluvial deposit with an irregular interface with the half-space. Results are displayed in both frequency and time domains. These results show the significant influence of lateral heterogeneity and the emergence of locally generated surface waves in the seismic response of alluvial valleys.     

高密度电法勘探在岩溶查找中的应用

介绍了武汉市汤逊湖污水处理厂厂址的地质概况和地球物理特征，以及高密度电法勘探的施工方案，分析了视电阻率异常特征，并说明了其异常验证情况。高密度电法勘探结果表明该区存在溶洞，为施工提供了决策依据，建议在有溶洞的地段采取相应措施，以防止工程建设后发生地质灾害。