High Frequency Current Fluctuations and Cross-shelf Flows around the Pycnocline near the Shelf Break in the East China Sea

Relation between internal waves with short time scale and density distribution near the shelf break in the East China Sea is studied utilizing moored current meters, thermometers and conductivity-temperature-depth (CTD) casts. A well developed pycnocline was frequently observed around 150–200 m depth near the shelf break accompanied with the development of internal waves with short time scale. During the cruise in May 1998, the intensified internal wave motion with short time scale and the distinct offshore flow were observed just below the lower pycnocline, which shoaled and extended above the shelf area. It is suggested that vertical mixing generated by amplified internal waves would produce cross-shelf ageostophic density current around the pycnocline. During the cruise in May 1999, on the other hand, the lower pycnocline was located offshore below the shelf break, and the internal wave motion was amplified just above the lower pycnocline. In this case, the offshore flow should be generated above the lower pycnocline, but vertical profiles of current velocity were not obtained because acoustic Doppler current profiler (ADCP) data were not available around the lower pycnocline.     

Exchange flow of oil and sea-water in a ruptured submarine pipeline

The rupture of a submarine oil pipeline starts various mechanisms leading to an oil spill. Among these mechanisms the leakage of oil driven by the difference in specific gravities of oil and sea-water is difficult to estimate. A simple mathematical model has been developed and laboratory experiments have been carried out to obtain an insight into the density-driven exchange flow and to determine the leak rate. The mathematical model is predictive and takes account of the effects of friction, inclination of the pipeline, and inertia of the fluid. The experiments were done in a horizontal model pipeline. Theoretical and experimental results are in satisfactory agreement.     

南海东北部末次冰期以来的沉积环境演变

利用南海东北部上陆坡处所取的D孔柱样进行硅藻分析,结合粒度与碎屑矿物分析结果,探讨该海域末次冰期以来沉积环境演变过程.结果表明：粒度与硅藻分析结果较为吻合,共同显示D孔柱样可分为上下两层.上表层（0～2 cm）的砂质沉积层为冰后期海进过程改造的晚更新世残留沉积层,即变余沉积;下层（2～130 cm）主要是末次冰期形成的浅海沉积.整个柱样可反映出海洋同位素MIS 4期海退至MIS 3期海进与MIS 2期海退至冰后期海进的沉积变化韵律.     

九州西侧海域129°E断面的流速和温盐结构特征

根据中、日合作黑潮调查研究期间（1987－1993年）在九州西侧海域获得的水文资料，计算了129°E断面的地转流速和流量。着重提出129°E断面北侧存在一支较稳定的西向流；分析这支西向流的去向，指出它是向对马暖流输送黑潮水的重要途径；给出了这支西向流及黑潮通过该断面的流速、流轴、流幅及流量的变化特征。     

台风"杜鹃"影响期间福建大风天气的特点及成因

台风“杜鹃”影响期间，福建大风天气出现的比较早，而且范围比较大．本文通过对天气尺度的环境场、具有代表性的单站资料的对比分析，寻求大风出现的原因．还深入利用MM5模式对台风的气压场、风场、流场等进行数值模拟，分析结果表明台湾地形倒槽的形成对此次大风天气出现有着重要的作用，此外从流场分型的角度进一步分析台湾地形倒槽的形成原因．     

长江口枯季悬沙粒度与浓度之间的关系

2003和2004年枯季在长江口采集水样并作水文观测，对所获水样进行过滤和粒度分析，以计算悬沙浓度和悬沙粒度分布。结果表明，2003年11月小潮期间，悬沙中值粒径与悬沙浓度存在着显著的指数关系，在大潮期间没有显著关系；在2004年2月小湖期间，两者之间没有显著关系，但在大潮期间存在着显著的指数关系。枯季水体悬沙以粉砂组份为主，并且随着向口外的推移，细颗粒组份逐渐增加，但在拦门沙最大浑浊带附近，由于絮凝作用，沉积物粒度变幅较大，可产生粒径粗化的现象。小潮期间，砂含量较低，但与悬沙浓度之间有显著相关关系；大潮期间，悬沙粒径粗化，但砂含量与悬沙浓度之间的关系不显著。上述分布趋势与沉积物来源、当地的水动力条件和絮凝作用等因素有密切关系。     

青藏高原中部湖泊沉积物中Zr/Rb值及其环境意义

由于青藏高原及其周边地区构造复杂,湖泊沉积物中的粒级差别很大,单一的测量方法往往难以奏效。Rb、Zr是表生地球化学过程中的稳定元素,但它们之间也存在显著差别,Rb一般富集在细颗粒中,Zr则在粗颗粒中含量较高。研究发现,湖泊沉积物中Zr/Rb比值与粘土(<2μm)含量存在显著相关,Zr/Rb值反映了湖泊沉积物的粒度大小。Zr/Rb比值所揭示的青藏高原中部280万年来经历的3次大的环境演化过程与岩性变化、孢粉指标反映的环境特征是一致的。     

The permeability of faults within siliciclastic petroleum reservoirs of the North Sea and Norwegian Continental Shelf

Faulting in Middle Jurassic reservoirs occurred at shallow depth during regional extension. Clean sandstones (<15% clay) deformed without significant grain fracturing and permeability reduction. Faults in impure sandstones (15–40% clay) experienced significant syn-deformation compaction and permeability reduction. Enhanced compaction during deeper burial reduced their permeabilities further from an average of 0.05 mD at <2.5 km to 0.001 mD at >4 km. Clay-rich sediments (>40% clay) deformed to produce clay smears with very low permeabilities (<0.001 mD). Faulting in the Rotliegendes occurred at greater depth during both basin extension and inversion. Extensional faulting produced cataclasites with permeability reductions of <10–>10⁶; their permeabilities range from 0.2 to 0.0001 mD and are inversely related to their maximum burial depth. Faults formed or reactivated during inversion experienced permeability increase. These results can be extrapolated to other hydrocarbon reservoirs if differences in stress and temperature history are taken into account.The permeability of most (>80%) faults is not sufficiently low, compared to their wallrock, to retard single-phase fluid flow on a km-scale. Nevertheless, most faults could retard the flow of a non-wetting phase if present at low saturations. It may be necessary to incorporate the two-phase fluid flow properties of fault rocks into reservoir simulators using upscaling or pseudoisation techniques. Fault property data should be calibrated against production data before it can be used confidently.