北京昌平地震台TJ-1体积钻孔应变仪潮汐参数动态特征及其稳定性研究

介绍了北京昌平地震台 TJ- 1型钻孔体积应变仪 1 989年 7月～ 2 0 0 0年 1 2月期间的观测结果 ,分析了潮汐响应函数的动态特征及其稳定性。由全序列观测数据调和分析所得 :O1波潮汐因子 VO1=0 .791 6± 0 .0 1 2 8、相位滞后 ΔΦ0 1=1 .9°;K1波潮汐因子 Vk1=0 .6 4 42±0 .0 0 88、相位滞后ΔΦk1=- 4.2°;M2 波潮汐因子 VM2 =0 .6 5 0 0± 0 .0 0 3 8、相位滞后ΔΦM2 =-2 .9°。液态地核振荡因子 A=VO1/VK1=1 .2 2 8,比理论值小 6 .5 %。     

粘弹性介质中的地震波

给出了三元件的标准线性粘弹性固体在半平面内传播的地震波的解析解，它是由已知的弹性半平面内的解析解迭粘滞性解而得，从而克服了视地壳为二元件粘弹性体的Voigt模型或Maxell模型的缺点。     

正常固结饱和粘性土的不排水强度

本文以有效应力强度理论和Henkel孔隙水压力公式为基础,建立了各种类三轴与平面应变试验条件下正常固结饱和粘土的不排水强度公式及相互关系;初步估计了粘土强度随固结增长的计算公式.     

浅谈野外岩心地质编录工作

岩心地质编录是收集和观察研究岩心中所赋存的各种地质信息和地质现象的一项重要的基础性地质工作。本文根据具体实践经验，简要介绍了岩心地质编录工作的3个阶段以及贯穿于编录工作始终的取样工作。     

Strain and tilt changes measured during a water injection experiment at the Nojima Fault zone, Japan

Abstract In order to make geophysical and geological investigations of the Nojima Fault on Awaji Island, Japan, three boreholes measuring 1800 m, 800 m and 500 m deep were drilled into the fault zone. The fault is one of the seismic source faults of the 1995 Hyogo-ken Nanbu earthquake of M 7.2. A new multicomponent borehole instrument was installed at the bottom of the 800 m borehole and continuous observations of crustal strain and tilt have been made using this instrument since May 1996. A high-pressure water injection experiment within the 1800 m borehole was done in February and March 1997 to study the geophysical response, behavior, permeability, and other aspects of the fault zone. The injection site was located approximately 140 m horizontally and 800 m vertically from the instrument. Associated with the water injection, contraction of approximately 0.7 × 10⁻⁷ str (almost parallel to the fault) and tilt of approximately 1 × 10^-7 rad in the sense of upheaval toward the injection site were observed. In addition to these controlled experiments, the strainmeter and tiltmeter also recorded daily variations. We interpret strain and tilt changes to be related to groundwater discharge and increased ultra-micro seismicity induced by the injected water.     

General characteristics of the recent horizontal crustal movement in Chinese mainland

1 Introduction of GPS observation dataThe Crustal Movement Observation Network of China (CMONOC) is a major scientific project in China organized by China Seismological Bureau and paticipated by the Bureau of Surveying and Mapping of the General Staff, the Chinese Academy of Sciences and the National Bureau of Surveying and Mapping. Based on the observation data of 25 fiducial stations and 56 basic stations in CMONOC (Figure 1 and Table 1), collected from August 26 to September…     

Model of rigid and elastic-plastic motion in intraplate blocks and strain status of principal blocks in Chinese mainland

Introduction The Chinese mainland is located in the southeastern part of Eurasia plate and encircled by India, Eurasia, Pacific and Philippine Sea plates. It is one of areas with the strongest tectonic de-formation, especially Qingzang (QinghaiXizang) plateau and NS tectonic zone where the tec-tonic activity is more intensive and intricate. The main part of tectonic activity of Chinese mainland includes a series of tectonic zones and active blocks divided by them. Therefore, the research…     

Evaluation of response and energy in actively controlled structures

A computational method of energy evaluation is derived to study the elastic responses and energy distribution of actively controlled single‐degree‐of‐freedom (SDOF) structures during earthquakes. Contrary to the common perception that applying active control force pumps energy into the structure, the applied control force can actually reduce the energy in the structure by reducing the input energy from earthquakes to the structure. In addition, applying control force can dissipate a large amount of energy in the structure when this control force is applied in the direction opposite to the displacement and velocity responses. To demonstrate this energy mechanism in active controlled structures, the two most popular control algorithms, optimal linear control (OLC) and instantaneous optimal control (IOC) algorithms, are used to calculate the control response and energy spectra. One‐step time delay is incorporated into the algorithms to take into consideration the practical aspect of active control. The effects of different earthquakes and damping ratios on control energy and response spectra are studied. These studies show that both OLC and IOC are very effective in reducing the structural displacement and velocity responses by reducing the input earthquake energy as well as dissipating a large amount of energy in the structure. Copyright © 2001 John Wiley & Sons, Ltd.     

On the origin of inhomogeneity of anomalous birefringence in mixed crystals: an example of alums

 Optical anomalies (deviations of the symmetry of optical properties from the ideal symmetry of the crystal) occur in many minerals and synthetic compounds and have been under investigation since the last century. An important feature of optically anomalous mixed crystals is a high degree of optical inhomogeneity, whereas the optical patterns of mixed crystals without anomalies are usually rather uniform. This work is devoted to the study of this phenomenon. As a model object we have chosen mixed alum crystals, which were known for their anomalous birefringence and which revealed the following types of optical inhomogeneities: (1) sector zoning; (2) concentric zoning; (3) subsector zoning; (4) stripes normal to growth front. The inhomogeneity of anomalous birefringence of mixed crystals of alums can be explained by superposition of several effects: mismatch strain, strain along dislocations and growth ordering of isomorphous components. Optical inhomogeneities due to the sector zoning of crystals and their dislocation structure arise even under stationary growth conditions and stationary micromorphology of the growing face. Both variable growth conditions and the relief of the growing face strongly intensify the optical inhomogeneity due to three interrelated factors: (1) a significantly inhomogeneous mismatch strain; (2) a variable degree of ordering of isomorphous components due to the compositional inhomogeneities; (3) different degrees of ordering of isomorphous atoms caused by different orientations, heights and velocities of growth steps. These effects lead to the formation of subsector zoning and zoning superimposed on the optical sector zoning. These optical structures are crossed by birefringent stripes arising from dislocations. Received: 29 March 2000 / Accepted: 11 March 2001     

Synchrotron X-ray powder diffraction study of natural P2 /n-omphacites at high-pressure conditions

 Synchrotron X-ray powder diffraction experiments at high pressure conditions (0.0001–13 GPa) were performed at ESRF (Grenoble-F), on the beamline ID9, to investigate the bulk elastic properties of natural P2/n-omphacites, with quasi-ideal composition. The monoclinic cell parameters a, b, c and β were determined as a function of pressure, and their compressibility coefficients are 0.00277(7), 0.00313(8), 0.00292(5) and 0.00116(4) GPa⁻¹, respectively. The third-order Birch-Murnaghan equation of state was used to interpolate the experimental P−V data, obtaining K ₀=116.6(±2.5) GPa and K′₀=6.03(±0.60). K ₀ was also determined by means of the axial and angular compressibilities [122.5(±1.7) GPa], and of the finite Lagrangian strain theory [121.5(±1.0) GPa]. The discrepancies on K ₀ are discussed in the light of a comparison between techniques to determine the bulk modulus of crystalline materials from static compression diffraction data. Received: 22 February 2000 / Accepted: 10 July 2000