利用双向缓冲区算法综合海图岛屿

阐述了岛屿综合的内容和原则。介绍了双向缓冲区算法的概念并给出了双向缓冲区算法的定义,研究并证明了双向缓冲区算法的特性。分析了利用双向缓冲区算法综合海图岛屿的原理,并通过实验验证利用双向缓冲区算法综合海图岛屿具有较好的效果。     

数字管网连通分析的淘汰算法与实现

本文从图论的观点出发,分析了数字化市政管网的构成和连通的特点,探索出数字化管网线路连通性分析的规律,提出了逐步淘汰算法进行连通性分析的方法。给出了基于mapbsic的实现这种算法的关键语句和注意问题。     

基于遗传算法的空基导航信号增强平台组网优化方法研究

根据空基导航信号增强平台的工作原理设计了组网优化评价指标;然后简单介绍了遗传算法的基本原理,对空基增强平台的空间位置进行了二进制编码;最后采用通用的遗传算法对空基导航信号增强平台空间分布进行优化搜索。仿真实验结果证明该算法能够对空基导航信号增强平台进行有效布置,覆盖范围内导航服务误差分布合理,并且能够根据实际要求对空基平台进行优化调整。     

Chebyshev逼近滤波器在位场分离中的应用

在对经典FIR数字滤波器的设计方法进行研究的基础上,提出了一种可以用于位场分离的基于Chebyshev最佳一致逼近原理的FIR滤波器的设计方法。在理论模型实验中,采用基于Hanning窗的低通滤波器计算出的区域异常最大误差为6.266×10^-6 m/s² ,均方差为2.115×10^-6 m/s² ,最大百分比误差为22.2%,而且计算点在±9 km以外的误差均大于10.1%。而利用最佳一致逼近原理分离出的区域场和局部场与理论异常值拟合得较好,曲线基本重合。分离出的区域异常最大误差为3.101×10^-6 m/s² ,均方差为0.989×10^-6 m/s² ,最大百分比误差仅在边部的几个数据上,为7.76%,其余各点的误差均小于4.1%。实例检验中将该方法用于孙吴—嘉荫剖面布格重力异常场的分离,分离出的区域场中局部场残留少,分离彻底,效果较为理想。     

The ionospheric eclipse factor method (IEFM) and its application to determining the ionospheric delay for GPS

A new method for modeling the ionospheric delay using global positioning system (GPS) data is proposed, called the ionospheric eclipse factor method (IEFM). It is based on establishing a concept referred to as the ionospheric eclipse factor (IEF) λ of the ionospheric pierce point (IPP) and the IEF’s influence factor (IFF) . The IEF can be used to make a relatively precise distinction between ionospheric daytime and nighttime, whereas the IFF is advantageous for describing the IEF’s variations with day, month, season and year, associated with seasonal variations of total electron content (TEC) of the ionosphere. By combining λ and with the local time t of IPP, the IEFM has the ability to precisely distinguish between ionospheric daytime and nighttime, as well as efficiently combine them during different seasons or months over a year at the IPP. The IEFM-based ionospheric delay estimates are validated by combining an absolute positioning mode with several ionospheric delay correction models or algorithms, using GPS data at an international Global Navigation Satellite System (GNSS) service (IGS) station (WTZR). Our results indicate that the IEFM may further improve ionospheric delay modeling using GPS data.     

变形分析的神经网络技术应用实例

大型工程施工过程中的变形监测、分析与预报极为重要。变形分析建模的方法很多,神经网络技术的应用是其中之一。文中结合某深基坑工程的监测资料和工作经验,运用神经网络BP算法进行预测分析。简述BP神经网络的基本概念,介绍基坑变形分析的BP神经网络的具体模型结构,将神经网络方法预报结果与实测数据对比效果较好。该成果对生产实践具有参考价值。     

模拟退火算法在控制网平差中的应用

线性最小二乘估计在对非线性函数进行线性近似的过程中会产生模型误差,而一些非线性参数估计方法可能因为函数复杂而难以求导,法方程系数矩阵秩亏或呈病态矩阵时难以求解,非线性迭代解法有时对初始值的选择存在依赖性,不恰当的初始值会导致迭代无法收敛。针对这些问题,引入了模拟退火算法,介绍了该算法的基本原理、计算步骤和收敛性,并以3个控制网平差应用为例,说明该算法具有无需求导求逆,简洁实用,易于编程等优势,并能实现全局优化,获得高精度的平差结果。     

一种新型非线性滤波理论及其应用

研究一种新型的非线性滤波理论,即Unscented卡尔曼滤波（UKF）,同时为了获得更高的计算效率和确保协方差阵的非负定性,研究了平方根UKF。将UKF和平方根UKF应用到星载GPS卫星定轨中,实际算例表明UKF和平方根UKF的性能要优于常用的推广卡尔曼滤波的性能。     

Bringing GPS into harsh environments for fully automated deformation monitoring

Engineering projects that require deformation monitoring frequently utilize geodetic sensors to measure displacements of target points located in the deformation zone. In situations where control stations and targets are separated by a kilometer or more, GPS can offer higher precision position updates at more frequent intervals than can normally be achieved using total station technology. For large-scale deformation projects requiring the highest precision, it is therefore advisable to use a combination of the two sensors. In response to the need for high precision, continuous GPS position updates in harsh deformation monitoring environments, a software has been developed that employs triple-differenced carrier-phase measurements in a delayed-state Kalman filter. Two data sets were analyzed to test the capabilities of the software. In the first test, a GPS antenna was displaced using a translation stage to mimic slow deformation. In the second test, data collected at a large open pit mine were processed. It was shown that the delayed-state Kalman filter developed could detect millimeter-level displacements of a GPS antenna. The actual precision attained depends upon the amount of process noise infused at each epoch to accommodate the antenna displacements. Higher process noise values result in quicker detection times, but at the same time increase the noise in the solutions. A slow, 25 mm displacement was detected within 30 min of the full displacement with sigma values in E, N and U of ±10 mm or better. The same displacement could also be detected in less than 5 h with sigma values in E, N and U of ±5 mm or better. The software works best for detecting long period deformations (e.g., 20 mm per day or less) for which sigma values of 1–2 mm are attained in all three solution components. It was also shown that the triple-differenced carrier-phase observation can be used to significantly reduce the effects of residual tropospheric delay that would normally plague double-differenced observations in harsh GPS environments.

An approach to aid INS using time-differenced GPS carrier phase (TDCP) measurements

This paper presents a simple and effective approach that incorporates single-frequency, L1 time-differenced GPS carrier phase (TDCP) measurements without the need of ambiguity resolution techniques and the complexity to accommodate the delayed-state terms. Static trial results are included to illustrate the stochastic characteristics and effectiveness of the TDCP measurements in controlling position error growth. The formulation of the TDCP observation model is also described in a 17-state tightly-coupled GPS/INS iterative, extended Kalman filter (IEKF) approach. Preliminary land vehicle trial results are also presented to illustrate the effectiveness of the TDCP which provides sub-meter positional accuracies when operating for more than 10 min.