Stability relations of Mn–Fe–Al piemontite

Abstract Comparison of the stability relations of Fe-piemontite, Pm₁₇Ps₁₇Cz₆₆ (Ca₂Al₂Mn_0.5 Fe_0.5Si₃O₁₂(OH)), with similar experimentally determined results on Pm₃₃Cz₆₇ suggests that, at moderate f_o2, addition of Fe to piemontite raises its thermal stability and slightly decreases its sensitivity to oxygen fugacity. Reversal study of the reaction: Fe-piemontite + quartz = garnet (Gr₃₃Sp₂₇And₄₀) + anorthite + fluid at P_fluid= 2 kbar in cold-seal apparatus using solid oxygen buffers was completed. The data indicated breakdown of Pm₁₇Ps₁₇Cz₆₆ at 645°± 10° C along the Cu₂O–CuO buffer, 477°± 10° C along the Cu–Cu₂O buffer, and 365°± 10° C for the hematite-magnetite buffer. Mn-free clinozoisite and epidote have been shown to be stable to much higher temperatures than piemontite at moderate f_o2 (< Cu–Cu₂O). At very high f_o2, however, the presence of Mn⁺³ in a distorted octahedral site may permit persistence of piemontite to higher temperatures than Mn-poor epidote minerals. The compositional range of natural Fe–Mn–Al piemontites supports these results. Cation partitioning from piemontite-bearing parageneses also indicates crystallization at high f_o2, but application of the cited results should be made with caution. Synthetic phases were too fine-grained for optical or microprobe analysis, and reaction was often incomplete. The assumption that all Fe + Mn was contained in piemontite and garnet, respectively, in the low- and high-temperature assemblages is supported by the cell dimensions for these synthetic minerals, which are close to predicted values. The reaction is pseudo-univariant, as solid solution in garnet and piemontite would be f_o2-dependent in a more complex chemical system. Although bulk rock and fluid compositions may also have a marked effect on the stability of natural epidote–piemontite, f_o2 is the major control on Fe : Mn : Al in epidote minerals.     

GIS算法基础实验教学探索

GIS算法基础实验教学是引导学生透彻理解GIS算法原理,掌握GIS算法应用技术的重要环节。论文重点分析了GIS算法基础课程的内容特点,并结合笔者在GIS算法基础方面的教学经验,建立了以实验教学系统平台为基础和以算法功能设计为主体的教学内容体系,同时建立了以项目导向式为主的教学方法体系。     

Equivalent continuum strain calculations based on 3D particle kinematic measurements of sand

Constitutive modeling of granular materials has been a subject of extensive research for many years. While the calculation of the Cauchy stress tensor using the discrete element method has been well established in the literature, the formulation and interpretation of the strain tensor are not as well documented. According to Bagi, 1 researchers mostly adopt well‐known continuum or discrete microstructural approaches to calculate strains within granular materials. However, neither of the 2 approaches can fully capture the behavior of granular materials. They are considered complementary to each other where each has its own strengths and limitations in solving granular‐mechanics problems. Zhang and Regueiro 2 proposed an equivalent continuum approach to calculating finite strain measures at the local level in granular materials subjected to large deformations. They used three‐dimensional discrete element method results to compare the proposed strains measures. This paper presents an experimental application of the Zhang and Regueiro 2 approach using three‐dimensional synchrotron microcomputed tomography images of a sheared Ottawa sand specimen. Invariant Eulerian finite strain measures were calculated for representative element volumes within the specimen. The spatial maps of Eulerian octahedral shear and volumetric strain were used to identify zones of intense shearing within the specimen and compared well with maps of incremental particle translation and rotation for the same specimen. The local Eulerian volumetric strain was compared to the global volumetric strains, which also can be considered as an averaging of all local Eulerian volumetric strains.     

北斗新一代试验星观测数据质量分析

5颗北斗新一代试验星搭载了包括B1C、B2a和B2b的诸多新体制民用信号,并且为了与北斗区域系统平稳过渡而搭载了B1I和B3I两个旧体制信号。采集了来自国内的6个监测站7 d的试验星观测数据,针对信号载噪比和码伪距多路径偏差分析了新一代试验星观测数据质量。结果表明,新一代试验星信号的各项指标整体较北斗区域系统卫星更好。前者载噪比较高,虽然仍发现了部分测站数据微小的多路径波动,但通过实时相位平滑伪距的方法可以很好地消除之;新一代试验星上B3I与B1I频点的载噪比最大,B2a和B2b次之,B1C的载噪比最小,且不同测站的观测结果存在明显差异;新一代试验星各频点的MP基本相同,但B2a、B2b和B3I频点MP的RMS明显小于B1I和B1C频点的结果。     

鄂尔多斯盆地镇北地区长3储层微观非均质性的实验分析

油气储层的微观非均质性特征是储层地质学研究的重要内容之一。本文的目的是研究鄂尔多斯盆地镇北地区长3储层微观非均质性特征,研究方法是利用真实砂岩微观模型实验。通过实验发现鄂尔多斯盆地镇北地区长3和储层为致密型砂岩,真实砂岩微观模型实验直观地显示出鄂尔多斯盆地镇北地区长3储层具有很强的微观非均质性,砂岩的成岩作用和孔隙结构是影响本区长3储层微观非均质性的主要原因。在低渗透砂岩中,溶蚀作用引起砂岩产生强烈的非均质性,而这些砂岩则形成长3储层的高渗带。     

滇东北山区坡耕地土壤侵蚀的地形因子

通过在滇东北山区坡耕地上设置１８个不同坡度和坡长的试验小区,并进行连续３年实测,得到本区域土壤侵蚀地形因子（ＬＳ）的定量关系式,据此求得滇东北山区坡耕地土壤侵蚀的坡面地形效应（ＬＳ值）表。     

Bubble growth in highly viscous melts: theory, experiments, and autoexplosivity of dome lavas

We examine the physics of growth of water bubbles in highly viscous melts. During the initial stages, diffusive mass transfer of water into the bubble keeps the internal pressure in the bubbles close to the initial pressure at nucleation. Growth is controlled by melt viscosity and supersaturation pressure and radial growth under constant pressure is approximately exponential. At later stages, internal pressure falls, radial growth decelerates and follows the square-root of time. At this stage it is controlled by diffusion. The time of transition between the two stages is controlled by the decompression, melt viscosity and the Peclet number of the system. The model closely fit experimental data of bubble growth in viscous melts with low water content. Close fit is also obtained for new experiments at high supersaturation, high Peclet numbers, and high, variable viscosity. Near surface, degassed, silicic melts are viscous enough, so that viscosity-controlled growth may last for very long times. Using the model, we demonstrate that bubbles which nucleate shortly before fragmentation cannot grow fast enough to be important during fragmentation. We suggest that tiny bubbles observed in melt pockets between large bubbles in pumice represent a second nucleation event shortly before or after fragmentation. The presence of such bubbles is an indicator of the conditions at fragmentation. The water content of lavas extruded at lava domes is a key factor in their evolution. Melts of low water content (<0.2 wt%) are too viscid and bubbles nucleated in them will not grow to an appreciable size. Bubbles may grow in melts with 0.4 wt% water. The internal pressure in such bubbles may be preserved for days and the energy stored in the bubbles may be important during the disintegration of dome rocks and the formation of pyroclastic flows.     

生物中碳氢化合物的结晶(英文)

生物和矿物体系的结构、功能和演化的比较分析与生物有机体中生命矿物的功能令人对生物世界矿物根的存在产生了怀疑。文章提出,应在非生物成因有序碳氢分子体系（硬沥青）中寻找前生物信息结构、基因之祖和原生有机体。前生物有机体的理想模型是纤维状黄绿蛭石,它是按照ＶＬＳ机制在伟晶岩的孔洞中结晶出来的,其形态、结构和成分与生物有机体十分相似。生命世界不是矿物世界转化的产物。生命世界和矿物世界都有共同的来源———非紧密离子分子体系,在该体系中,它们相互和谐作用,以不同的结晶机理发生和发展。生命作为统一的整体,作为复杂碳氢体系结晶作用的完整结果产生和演化,而不是偶然事件巧合或不同成因组分结合的结果。矿物和生物有机体的演化受控于共同的个体发生律。根据纤维状黄绿蛭石晶体的研究而提出的晶质原生有机体模型,消除了在创立统一的自然发生论概念（结构组织、大分子集合、继承机理、手性选择等等）方面的主要分歧和障碍。这就使把解决生命起源问题带入实验模拟层次成为现实     

芒果苷对高脂肪/高果糖饮食诱导大鼠代谢综合征的影响

目的：探讨芒果苷对高脂肪/高果糖饮食诱导大鼠代谢综合征（MS）的影响。方法：将60只大鼠随机分为正常组,模型组,阳性对照组,芒果苷高、中、低剂量组,每组各10只。每天饲喂17%脂肪/17%果糖饲料+20%果糖水,构建MS模型,造模8周。造模成功后阳性对照组灌胃二甲双胍50mg/kg,芒果苷高、中、低剂量组分别灌胃40、20、10mg/kg,正常组和模型组灌胃等体积0.5%羧甲基纤维素钠,连续给药8周。观察各组的体质量、内脏脂肪质量、脂体比及血清总胆固醇、三酰甘油、空腹血糖、胰岛素水平、胰岛素抵抗指数（IRI）、脂肪细胞因子（脂联素、抵抗素）水平。结果：与模型组比较,芒果苷高、中、低剂量组的体质量、内脏脂肪质量、脂体比、血清总胆固醇、三酰甘油、空腹血糖、胰岛素及抵抗素水平下降（P<0.01）,芒果苷高、中剂量组IRI降低（P<0.05）。结论：芒果苷通过调控糖脂代谢、脂肪细胞因子、脂肪堆积、胰岛素抵抗等途径干预大鼠MS的病理进程。